Page 21 of 203

xi
(a) Accurate current vehicle
position may not be shown in the
following cases:
When driving on a small angled Y−
shaped road.
When driving on a winding road.
When driving on a slippery road such as
in sand, gravel, snow, etc.
When driving on a long straight road.
When freeway and surface streets run in
parallel.
After moving by ferry or vehicle carrier.
When a long route is searched during
high speed driving.
When driving without setting the current
position calibration correctly.
After repeating a change of direction by
going forward and backward, or turning on a
turntable in the parking lot.
When leaving a covered parking lot or
parking garage.
When a roof carrier is installed.
When driving with tire chains installed.
When the tires are worn.
After replacing a tire or tires.
When using tires that are smaller or larg-
er than the factory specifications.When the tire pressure in any of the four
tires is not correct.
INFORMATION
If your vehicle cannot receive GPS sig-
nals, you can correct the current posi-
tion manually. For information on set-
ting the current position calibration,
see page lxxxviii.
Page 22 of 203

xii
(b) Inappropriate route guidance
may occur in the following cases:
When turning at an intersection off the
designated route guidance.
If you set more than one destination but
skip any of them, auto reroute will display a
route returning to the destination on the pre-
vious route.
When turning at an intersection for which
there is no route guidance.
When passing through an intersection
for which there is no route guidance.
During auto reroute, the route guidance
may not be available for the next turn to the
right or left.
It may take a long time to operate auto re-
route during high speed driving. In auto re-
route, a detour route may be shown.
After auto reroute, the route may not be
changed.
An unnecessary U−turn may be shown
or announced.
A location may have multiple names and
the system will announce one or more.
Some routes may not be searched.
If the route to your destination includes
gravel, unpaved roads or alleys, the route
guidance may not be shown.
Your destination point might be shown on
the opposite side of the street.
When a portion of the route has regula-
tions prohibiting the entry of the vehicle that
vary by time or season or other reason.
The road and map data stored in your
navigation system may not be complete or
may not be the latest version.
After replacing the tire, implement the
operation described in the “ Tire
change calibration”. (For details, see
page xc.)
This navigation system uses the tire turning
data and is designed to work with factory−
specified tires for your vehicle. Installing
tires that are larger or smaller than the origi-
nally equipped diameter may cause inaccu-
rate display of the vehicle’s position. The tire
pressure also affects the diameter of the
tires so please make sure the tire pressure
of all four tires is correct.
Map database information
and updates
This system uses the maps of DENSO.
Page 100 of 203
xc
2. Touch either the or switch to
adjust the direction of the current vehicle
position mark.
Touch the
“Enter” switch and the map
screen will be displayed.
Tire change calibration
The tire change calibration function will
be used when replacing the tires. This
function will adjust the mis calculation
caused by the circumference difference
between the old tires and new ones. If
this procedure is not performed when
tires are replaced, the current vehicle
position mark may be incorrectly dis-
played.
To perform a distance calibration procedure,
touch the
“Tire Change” switch on the
“Calibration” screen.
The message appears and the quick dis-
tance calibration is automatically started. A
few seconds later, a map screen will be dis-
played.
Distance unit
1. Push the “MENU” button.
2. Touch the “Setup” switch.
Page 119 of 203
cix “Reset All”: To reset the item which has sat-
isfied a condition.
Touch the
“Off” switch at the top of the
“Maintenance” screen to turn off the informa-
tion screen.
When your vehicle needs to be serviced, the
icon color will change to orange.
INFORMATION
For scheduled maintenance infor-
mation, please refer to the “Sched-
uled Maintenance Guide” or “Own-
er’s Manual Supplement”.
Depending on driving or road condi-
tions, the actual date and distance
may differ from the stored date and
distance in the system.
Information items
Oil change
Replace oil filter
Rotate tires
Replace tires
Replace battery
Replace brake linings
Replace wiper blades
Replace engine coolant
Replace brake fluid
Replace ATF
Scheduled maintenance
Replace air filter
Personal event