2007 TOYOTA HIGHLANDER warning light

[x] Cancel search: warning light

Page 154 of 426

TOYOTA HIGHLANDER 2007 XU40 / 2.G Owners Manual ’07 HIGHLANDER_U (L/O 0608)
140
2007 HIGHLANDER from July ’06  Prod. (OM48682U)
If the light stays on, it indicates that the
SRS driver and front passenger airbag
system and/or front passenger occ

Page 155 of 426

TOYOTA HIGHLANDER 2007 XU40 / 2.G Owners Manual ’07 HIGHLANDER_U (L/O 0608)
141
2007 HIGHLANDER from July ’06  Prod. (OM48682U)
If the light is flashing, we recommend that
you replace the engine oil at an early
opportunity depending on the driv

Page 169 of 426

TOYOTA HIGHLANDER 2007 XU40 / 2.G Owners Manual ’07 HIGHLANDER_U (L/O 0608)
155
2007 HIGHLANDER from July ’06  Prod. (OM48682U)
TRACTION CONTROL OFF MODE
If your wheels get stuck in an ditch
when you are driving on a severe off
road and sand, t

Page 170 of 426

TOYOTA HIGHLANDER 2007 XU40 / 2.G Owners Manual ’07 HIGHLANDER_U (L/O 0608)
156
2007 HIGHLANDER from July ’06  Prod. (OM48682U)
In the following cases, contact your Toyota
dealer:
The warning light does not  come on
after the ignition key is t

Page 171 of 426

TOYOTA HIGHLANDER 2007 XU40 / 2.G Owners Manual ’07 HIGHLANDER_U (L/O 0608)
157
2007 HIGHLANDER from July ’06  Prod. (OM48682U)
When the traction control system is oper-
ating, the following conditions occur:
The system controls the spinning o

Page 173 of 426

TOYOTA HIGHLANDER 2007 XU40 / 2.G Owners Manual ’07 HIGHLANDER_U (L/O 0608)
159
2007 HIGHLANDER from July ’06  Prod. (OM48682U)
“VSC” warning light
This light warns that there is a problem
somewhere in the vehicle stability control
system o

Page 174 of 426

TOYOTA HIGHLANDER 2007 XU40 / 2.G Owners Manual ’07 HIGHLANDER_U (L/O 0608)
160
2007 HIGHLANDER from July ’06  Prod. (OM48682U)
LOW TIRE PRESSURE WARNING LIGHT
This light comes on when the ignition key
is turned to the “ON” position. It goe

Page 175 of 426

TOYOTA HIGHLANDER 2007 XU40 / 2.G Owners Manual ’07 HIGHLANDER_U (L/O 0608)
161
2007 HIGHLANDER from July ’06  Prod. (OM48682U)
The loading is over  the limit or imbal-
anced.
Initialization was not performed correct-
ly after replacing or ro