2007 TOYOTA FJ CRUISER window

2682007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
TS40023
If you cannot shift the selector lever
out of the “P” position to other posi-
tions even though the brake pedal is
depressed, use the shift lock override
button as follows:1. Turn the ignition key to the “LOCK” position. Make sure the parking
brake is applied.
2. Pry up the cover with a flathead screwdriver or equivalent.
TS40024
3. Insert the screwdriver or equivalentinto the hole to push down the shift
lock override button. You can shift
out of the “P” position only while
pushing the button.
4. Shift into the “N” position.
5. Insert the cover.
6. Start the engine. For your safety, keep the brake pedal depressed.
Be sure to have the system checked by
your Toyota dealer as soon as possible. You can purchase a new key at your
Toyota dealer if you can give them the
key number.
See the suggestion given in “Keys” on
page 10 in Section 1
−2.
If your keys are locked in the vehicle and
you cannot get a duplicate, many Toyota
dealers can still open the door for you,
using their special tools. If you must
break a window to get in, we suggest
breaking the smallest side window be-
cause it is the least expensive to replace.
Be extremely cautious to avoid cuts from
the glass.
If you cannot shift automatic
transmission selector lever If you lose your keys

2752007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
Exterior lights: Do not apply wax on the
surfaces of the lights. Wax may cause
damage to the lenses. If you accidentally
put wax on the light surfaces, wipe or
wash it off.3. Wax the vehicle again when water does not bead but remains on the sur-
face in large patches.CAUTION
Vehicles with side airbags and cur-
tain shield airbags:
Be careful not to splash water or
spill liquid on the floor. This may
prevent the side airbags and curtain
shield airbags from activating cor-
rectly, resulting in death or serious
injury.
Do not wash the vehicle floor with
water, or allow water to get onto
the floor when cleaning the vehicle
interior or exterior. Water may get
into audio components or other
electrical components above or un-
der the floor carpet (or mat) and
cause a malfunction; and it may
cause body corrosion.
Vinyl interior
The vinyl upholstery may be easily
cleaned with a mild soap or detergent
and water.
First vacuum over the upholstery to re-
move loose dirt. Then, using a sponge or
soft cloth, apply the soap solution to the
vinyl. After allowing it to soak in for a few
minutes to loosen the dirt, remove the dirt
and wipe off the soap with a clean damp
cloth. If all the dirt does not come off,
repeat the procedure. Commercial foam-
ing −type vinyl cleaners are also available
which work well. Follow the manufacturer ’s
instructions.
NOTICE
Do not use solvent, thinner, gasoline
or window cleaner on the interior.
Cleaning the interior

2762007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
Carpets
Use a good foamtype shampoo to
clean the carpets.
Begin by vacuuming thoroughly to remove
as much dirt as possible. Several types of
foam cleaners are available; some are in
aerosol cans and others are powders or
liquids which you mix with water to pro-
duce a foam. To shampoo the carpets,
use a sponge or brush to apply the foam.
Rub in overlapping circles.
Do not apply water—the best results are
obtained by keeping the carpet as dry as
possible. Read the shampoo instructions
and follow them closely.
Seat belts
The seat belts may be cleaned with
mild soap and water or with lukewarm
water.
Use a cloth or sponge. As you are clean-
ing, check the belts for excessive wear,
fraying, or cuts.NOTICE
Do not use dye or bleach on the
belts—it may weaken them.
 Do not use the belts until they be-
come dry.
Windows
The windows may be cleaned with any
household window cleaner.
NOTICE
When cleaning the inside of the rear
window, be careful not to scratch or
damage the heater wires or connec-
tors.
Air conditioning control panel, audio
panel, instrument panel, console panel
and switches
Use a soft damp cloth for cleaning.
Soak a clean soft cloth in water or luke-
warm water then lightly wipe off dirt.
NOTICE
Do not use organic substances (sol-
vents, kerosene, alcohol, gasoline,
etc.) or alkaline or acidic solutions.
These chemicals can cause discol-
oring, staining or peeling of the
surface.
 If you use cleaners or polishing
agents, make sure their ingredients
do not include the substances men-
tioned above.
 If you use a liquid car freshener, do
not apill the liquid onto the ve-
hicle’s interior surfaces. It may con-
tain the ingredients mentioned
above. Immediately clean any spill
using the method mentioned above.
Leather interior
The leather upholstery may be cleaned
with neutral detergent for wool.
Remove dirt using a soft cloth dampened
with 5% solution of neutral detergent for
wool. Then thoroughly wipe off all traces
of detergent with a clean damp cloth.

2832007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
Tire inflation pressure
Check the pressure with a gauge ev-
ery two weeks, or at least once a
month. See page 297 in Section 7−2
for additional information.
Tire surface and wheel nuts
Check the tires carefully for cuts,
damage or excessive wear. See page
299 in Section 7− 2 for additional in-
formation. When checking the tires,
make sure no nuts are missing, and
check the nuts for looseness. Tighten
them if necessary.
Tire rotation
Rotate the tires according to the
maintenance schedule. (For sched-
uled maintenance information, please
refer to the “Scheduled Maintenance
Guide” or “Owner ’s Manual Supple-
ment”.) See page 301 in Section 7 −2
for additional information.Be on the alert for changes in perfor-
mance, sounds, and visual tip −offs that
indicate service is needed. Some impor-
tant clues are as follows:
Engine missing, stumbling, or pinging
Appreciable loss of power
Strange engine noises
A leak under the vehicle (however, wa-
ter dripping from the air conditioning
after use is normal.)
Change in exhaust sound (This may
indicate a dangerous carbon monoxide
leak. Drive with the windows open and
have the exhaust system checked im-
mediately.)
Flat −looking tire; excessive tire squeal
when cornering; uneven tire wear
Vehicle pulls to one side when driving
straight on a level road
Strange noises related to suspension
movement
Loss of brake effectiveness; spongy
feeling brake or clutch pedal; pedal al-
most touches floor; vehicle pulls to one
side when braking
Engine coolant temperature continually
higher than normal If you notice any of these clues, take your
vehicle to your Toyota dealer as soon as
possible. It probably needs adjustment or
repair.
CAUTION
Do not continue driving with the ve-
hicle unchecked. It could result in se-
rious vehicle damage and possibly
personal injury.
Does your vehicle need
repairing?

2862007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
1. Windshield and back window washerfluid tank
2. Power steering fluid reservoir
3. Engine oil level dipstick
4. Engine coolant reservoir
5. Engine oil filler cap
6. Brake fluid reservoir
7. Fuse blocks
8. Battery
9. Condenser
10. Radiator
Engine compartment overview
TS71001

3212007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
TS80001a
Engine compartment
Fuses (type A)1. SPARE 10 A: Spare fuse
2. SPARE 15 A: Spare fuse
3. TOWING TAIL 15 A: Trailer lights
4. OFFROAD LP 15 A: Offroad lamp
5. STOP 10 A: Stop lights, high mounted
stoplight, anti −lock brake system, trac-
tion control system, active traction con-
trol system, vehicle stability control
system, “AUTO LSD” system, multiport
fuel injection system/sequential multi-
port fuel injection system, shift lock
system
6. AUX LP 15 A: Driving lamp
TS80002
Instrument panel
7. OBD 7.5 A: On−board diagnosis sys-
tem
8. HEAD (LO RH) 10 A: Right −hand
headlight (low beam) (vehicles with
daytime running light), right −hand head-
light (vehicles without daytime running
light)
9. HEAD (LO LH) 10 A: Left−hand head-
light (low beam) (vehicles with daytime
running light), left −hand headlight (ve-
hicles without daytime running light)
10. HEAD (HI RH) 10 A: Right −hand head-
light (high beam)
TS80003a
Engine compartment
11. HEAD (HI LH) 10 A: Left −hand head-
light (high beam)
12. EFI NO.2 10 A: Multiport fuel injection
system/s equential multiport fuel injec-
tion system
13. DRL 7.5 A: Daytime running light
system
14. DEFOG 30 A: Back window defogger
15. DEFOG NO.2 7.5 A: Multiport fuel in-
jection system/sequential multiport fuel
injection system
16. DOME 10 A: Interior light, luggage
compartment light, clock, accessory
meter, meter and gauge
Fuses

3222007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
17. RADIO NO.1 20 A: Audio system
18. ECUB 10 A: Air conditioning system,
multiplex communication system, SRS
airbag system, front passenger occu-
pant classification system
19. ALTS 7.5 A: Charging system
20. HORN 10 A: Horn
21. A/F HEATER 15 A: Multiport fuel injec-
tion system/sequential multiport fuel in-
jection system
22. TRNHAZ 15 A: Turn signal lights,
emergency flashers
23. ETCS 10 A: Multiport fuel injection
system/s equential multiport fuel injec-
tion system, electronic throttle control
system
24. EFI 20 A: “EFI NO.2” fuse, Multiport
fuel injection system/sequential multi-
port fuel injection system
25. DR/LCK 20 A: Door lock system, mul-
tiplex communication system
26. TOWING 15 A: Towing converter
27. RADIO NO.2 20 A: Audio system28. IGN 10 A:
Multiport fuel injection sys-
tem/sequential multiport fuel injection
system, anti −lock brake system, vehicle
stability control system, traction control
system, active traction control system,
“AUTO LSD” system, SRS airbag sys-
tem, front passenger occupant classifi-
cation system
29. GAUGE 7.5 A: Meter and gauge
30. FR WIPWSH 30 A: Windshield wipers
and washer
31. 4WD/DIFF 20 A: Four−wheel drive sys-
tem, rear differential lock system
32. PWR OUTLET 15 A: Power outlet
33. RR WSH 15 A: Back window wiper
and washer, multiplex communication
system
34. ECUIG 10 A: Anti−lock brake system,
vehicle stability control system, traction
control system, active traction control
system, “AUTO LSD” system, multiport
fuel injection system/sequential multi-
port fuel injection system, cruise con-
trol system, back door lock system,
shift lock system, multiplex communica-
tion system 35. IG1 15 A:
Turn signal lights, air condi-
tioning system, charging system, clutch
start cancel switch, anti −lock brake
system, traction control system, active
traction control system, vehicle stability
control system, “AUTO LSD” system,
back −up lights, intuitive parking assist,
rear differential lock system, power out-
let, accessory meter, meter and gauge
36. STA 7.5 A: Starting system, clutch
start cancel switch, power outlet
37. TAIL 10 A: Tail lights, license plate
lights, parking lights, instrument panel
light control, illuminations
38. ACC 7.5 A: Shift lock system, outside
rear view mirrors, audio system, power
outlet, clock, accessory meter, multi-
plex communication system
Fuses (type B)
39. AM1 50 A: “ACC”, “ECU−IG”, “IG1”,
“PR WSH”, “FR WIP −WSH”, “4WD/
DIFF” and “STA” fuses
40. J/B 50 A: “TAIL”, “PWR OUTLET”,
“POWER”
4

1. ABS MTR 40 A: Anti−lock brake sys-
tem, vehicle stability control system,
traction control system, active traction
control system, “AUTO LSD” system

3232007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
42. AM2 30 A: “IGN” and “GAUGE” fuses,
multiport fuel injection system/sequen-
tial multiport fuel injection system,
starting system
43. ABS SOL 30 A: Anti−lock brake sys-
tem, vehicle stability control system,
traction control system, active traction
control system, “AUTO LSD” system
44. POWER 30 A: Power windows
45. AC 115V 80 A: Power outlet
Fuses (type C)
46. ALT 120 A: “AM1”, “AC 115V”,
“DEFOG”, “DEFOG NO.2”, “STOP”,
“OBD”, “J/B”, “TOWING TAIL”, “AUX
LP” and “OFFROAD LP” fuses
47. HEATER 60 A: Air conditioning system