2732007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
Check the interior of your vehicle. Wa-
ter and dirt can accumulate under the
floor mats and could cause corrosion. Oc-
casionally check under the mats to make
sure the area is dry. Be particularly care-
ful when transporting chemicals, cleans-
ers, fertilizers, salt, etc; these should be
transported in proper containers. If a spill
or leak should occur, immediately clean
and dry the area.
Use mud shields on your wheels. If you
drive on salted or gravel roads, mud
shields help protect your vehicle. Full −size
shields, which come as near to the ground
as possible, are the best. We recommend
that the fittings and the area where the
shields are installed be treated to resist
corrosion. Your Toyota dealer will be
happy to assist in supplying and installing
the shields if they are recommended for
your area.
Keep your vehicle in a well ventilated
garage or a roofed place. Do not park
your vehicle in a damp, poorly venti-
lated garage. If you wash your vehicle in
the garage, or if you drive it covered with
water or snow, your garage may be so
damp as to cause corrosion. Even if your
garage is heated, a wet vehicle can cor-
rode if the ventilation is poor. Washing your Toyota
Keep your vehicle clean by regular
washing.
The following cases may cause weakness
to the paint or corrosion to the body and
parts. Wash your vehicle as soon as pos-
sible.
When driving in a coastal area
When driving on a road sprinkled with
antifreeze
When exposed to coal tar, tree sap,
bird droppings and carcass of an insect
When driving in areas where there is
a lot of smoke, soot, dust, iron dust or
chemical substances
When the vehicle becomes remarkably
dirty with dust and mud
Hand washing your Toyota
Work in the shade and wait until the
vehicle body is not warm to the touch.
CAUTION
When cleaning under floor or chas-
sis, be careful not to injure your
hands.
Exhaust gases cause the exhaust
pipe to become quite hot. When
washing the vehicle, be careful not
to touch the pipe until it has cooled
sufficiently, as touching a hot ex-
haust pipe can cause burns.
1. Rinse off loose dirt with a hose. Re- move any mud or road salt from the
underside of the vehicle or the wheel
wells.
2. Wash with a mild car −wash soap,
mixed according to the manufacturer ’s
instructions. Use a soft cotton mitt and
keep it wet by dipping it frequently into
the wash water. Do not rub hard—let
the soap and water remove the dirt.
Fuel filler door: Do not apply water (high −
pressure car wash, for example) at or
near the fuel tank inlet with the fuel filler
door opened. If the water enters the air
vent, you may experience trouble with re-
fueling or rough engine idling.
Wa sh in g an d waxin g yo u r
To y o t a
3222007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
17. RADIO NO.1 20 A: Audio system
18. ECU B 10 A: Air conditioning system,
multiplex communication system, SRS
airbag system, front passenger occu-
pant classification system
19. ALT S 7.5 A: Charging system
20. HORN 10 A: Horn
21. A/F HEATER 15 A: Multiport fuel injec-
tion system/sequential multiport fuel in-
jection system
22. TRN HAZ 15 A: Turn signal lights,
emergency flashers
23. ETCS 10 A: Multiport fuel injection
system/s equential multiport fuel injec-
tion system, electronic throttle control
system
24. EFI 20 A: “EFI NO.2” fuse, Multiport
fuel injection system/sequential multi-
port fuel injection system
25. DR/LCK 20 A: Door lock system, mul-
tiplex communication system
26. TOWING 15 A: Towing converter
27. RADIO NO.2 20 A: Audio system28. IGN 10 A:
Multiport fuel injection sys-
tem/sequential multiport fuel injection
system, anti −lock brake system, vehicle
stability control system, traction control
system, active traction control system,
“AUTO LSD” system, SRS airbag sys-
tem, front passenger occupant classifi-
cation system
29. GAUGE 7.5 A: Meter and gauge
30. FR WIP WSH 30 A: Windshield wipers
and washer
31. 4WD/DIFF 20 A: Four−wheel drive sys-
tem, rear differential lock system
32. PWR OUTLET 15 A: Power outlet
33. RR WSH 15 A: Back window wiper
and washer, multiplex communication
system
34. ECU IG 10 A: Anti−lock brake system,
vehicle stability control system, traction
control system, active traction control
system, “AUTO LSD” system, multiport
fuel injection system/sequential multi-
port fuel injection system, cruise con-
trol system, back door lock system,
shift lock system, multiplex communica-
tion system 35. IG1 15 A:
Turn signal lights, air condi-
tioning system, charging system, clutch
start cancel switch, anti −lock brake
system, traction control system, active
traction control system, vehicle stability
control system, “AUTO LSD” system,
back −up lights, intuitive parking assist,
rear differential lock system, power out-
let, accessory meter, meter and gauge
36. STA 7.5 A: Starting system, clutch
start cancel switch, power outlet
37. TAIL 10 A: Tail lights, license plate
lights, parking lights, instrument panel
light control, illuminations
38. ACC 7.5 A: Shift lock system, outside
rear view mirrors, audio system, power
outlet, clock, accessory meter, multi-
plex communication system
Fuses (type B)
39. AM1 50 A: “ACC”, “ECU−IG”, “IG1”,
“PR WSH”, “FR WIP −WSH”, “4WD/
DIFF” and “STA” fuses
40. J/B 50 A: “TAIL”, “PWR OUTLET”,
“POWER”
4
1. ABS MTR 40 A: Anti−lock brake sys-
tem, vehicle stability control system,
traction control system, active traction
control system, “AUTO LSD” system
