2007 TOYOTA FJ CRUISER lock

122007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
To lock and unlock all the side doors
and back door, push the switches of
the transmitter slowly and securely.
To lock: Push the “LOCK” switch. All the
side doors and back door are locked si-
multaneously. At this time one beep will
be heard, and the turn signal lights flash
once.
Check to see that all the side doors and
back door are securely locked.
If any of the side doors, back door or
back window is not securely closed, lock-
ing cannot be performed by the “LOCK”
switch and a beep will sound continuously
for 10 seconds. However, if the key is in
the ignition switch, a beep will not sound.
To stop the beep, close all the side doors,
back door and back window securely or
push the “UNLOCK” switch.
The beep can be disabled. For details,
contact your Toyota dealer.
To unlock: Push the “UNLOCK” switch
once to unlock the driver ’s door alone.
Pushing the switch twice within 3 seconds
unlocks all the side doors and back door
simultaneously. Each time the “UNLOCK”
switch is pushed, two beeps will be heard,
and the turn signal lights will flash twice.This double switch operation to unlock all
the side doors and back door can be
changed to a single switch operation. For
details, contact your Toyota dealer.
When the “UNLOCK” switch is pressed,
the interior light and luggage compartment
light will come on and remain on for about
15 seconds before fading out. (For details,
see “Interior light” on page 92 and
“Luggage compartment light” on page 93
in Section 1−
5.)
You have 60 seconds to open a door after
using the wireless remote unlock feature.
If a door is not opened by then, all the
side doors and back door will be automati-
cally locked again and one beep will be
heard.
The timing for the automatic door lock
function can be changed. For details, con-
tact your Toyota dealer.
If the “LOCK” or “UNLOCK” switch is kept
pressed in, the locking or unlocking opera-
tion is not repeated. Release the switch
and then push again. The following adjustments can be made in
this system. For details, contact your
Toyota dealer.
Cancelling the wireless door locking or
unlocking function
Cancelling the flash of the turn signal
lights
Changing the volume of beep sound

132007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
TS12008
Pushing the “PANIC” switch blows the
horn intermittently and flashes the
headlights, tail lights, turn signal lights
and outside rear view mirror illumina-
tion light (on some models), and turns
on the interior and luggage compart-
ment lights.
The “PANIC” switch is used to deter ve-
hicle theft when you witness anyone at-
tempting to break into or damage your
vehicle.
The alarm will last for one minute. To stop
alarm midway, push any of the switch on
the wireless remote control transmitter.
You can also stop the alarm by turning
the ignition key from the “LOCK” to “ON”
position.The “PANIC” mode does not work when
the ignition key is in the “ON” position.
This alarm function can be disabled. For
details, contact your Toyota dealer.
For vehicles sold in U.S.A.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful
interference, and (2) this device must
accept any interference received, includ-
ing interference that may cause unde-
sired operation.
—Activating panic mode

162007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
TS12011
3. Put in a new transmitter battery withpositive (+) side up.
Close the transmitter case securely.
NOTICE
 Make sure the positive side and
negative side of the transmitter bat-
tery are faced correctly.
 Do not replace the battery with wet
hands. Water may cause unexpected
rust.
 Do not touch or move any compo-
nents inside the transmitter, or it
may interfere with proper operation.
Be careful not to bend the electrode
when inserting the transmitter bat-
tery and that dust or oils do not
adhere to the transmitter case.
 Close the transmitter case securely.
After replacing the battery, check that the
transmitter operates properly. If the trans-
mitter still does not operate properly, con-
tact your Toyota dealer.TS12012
LOCKING AND UNLOCKING WITH KEY
Insert the key into the keyhole and turn
it.
To lock: Turn the key forward.
To unlock: Turn the key backward.
All the side doors and back door lock and
unlock simultaneously with either front
side door. In the driver’s door lock, turn-
ing the key once will unlock the driver’s
door and twice in succession will unlock
all the side doors and back door simulta-
neously.
Side doors

172007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
This double key turning operation to un-
lock all the side doors and back door can
be changed to a single key turning opera-
tion. For details, contact your Toyota deal-
er.
When any of the side doors and back
door is unlocked with a key, the interior
light and luggage compartment light will
come on and remain on for about 15 sec-
onds before fading out. (For details, see
“Interior light” on page 92 and “Luggage
compartment light” on page 93 in Section
1−5.)
TS12013
LOCKING AND UNLOCKING WITH
INSIDE LOCK KNOB
Move the lock knob.
To lock: Push the knob forward.
To unlock: Pull the knob backward.
The front doors can be opened by pulling
the inside handles even if the lock knobs
are in the locked position.
CAUTION
Do not pull the inside handle of the
front doors while driving. The doors
will open and an accident may occur.
Toyota strongly recommends that all
children be placed in the rear seat of
the vehicle.
Closing the door with the lock knob in the
lock position will also lock the door. Be
careful not to lock your keys in the ve-
hicle.
The front doors cannot be locked if you
leave the key in the ignition switch.

182007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
TS12014
Driver’s side
Front passenger’s side
LOCKING AND UNLOCKING WITH
POWER DOOR LOCK SWITCH
Push the switch.
To lock: Push the switch down on the
front side.
To unlock: Push the switch down on the
rear side.
Operating the switch simultaneously locks
or unlocks all the side doors and back
door.
If you do either of the following, no side
door or back door can be unlocked with
the power door lock switch.
Lock all the side doors and back door
with the key or wireless remote control
transmitter when all the side doors,
back door and back window are closed.
Open the driver ’s door or front passen-
ger’s door and move the inside lock
knobs of both front doors to the lock
position, then close the front doors. The power door lock switch can be reset
in the following ways.
Turn the ignition key to “ON”.
Unlock all the side doors and back
door with the key or wireless remote
control transmitter.
Unlock the driver’s door or front pas-
senger ’s door with the inside lock
knob, and then unlock all the side
doors and back door with the power
door lock switch.
CAUTION
Before driving, be sure that the doors
are closed and locked, especially
when small children are in the ve-
hicle. Along with the proper use of
seat belts, locking the doors helps
prevent the driver and passengers
from being thrown out from the ve-
hicle in an accident. It also helps pre-
vent the doors from being opened un-
intentionally.

212007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
TS12017
Window
lock
switch
Driver’s side
TS12018
Passenger’s side
OPERATING THE PASSENGER’S
WINDOW
Use the switch on the front passenger ’s
door or the switches on the driver ’s
door that control the front passenger ’s
window.
The window moves as long as you hold
the switch.
To open: Push down the switch.
To close: Pull up the switch.
If you push in the window lock switch on
the driver ’s door, the passenger ’s window
cannot be operated.CAUTION
To avoid death or serious personal
injury, you must do the following.
Before you close the power win-
dows, always make sure there is
nobody around the power windows.
You must also make sure the
heads, hands and other parts of the
bodies of all occupants are kept
completely inside the vehicle. If
someone’s neck, head or hands get
caught in a closing window, it
could result in death or serious in-
jury. When anyone closes the power
windows, make sure he or she op-
erates the windows safely.
When small children are in the ve-
hicle, never let them use the power
window switches without supervi-
sion. Use the window lock switch to
prevent them from making unex-
pected use of the switches.
Be sure to remove the ignition key
when you leave your vehicle.

222007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
Never leave anyone (particularly a
small child) alone in your vehicle,
especially with the ignition key still
inserted. Otherwise, he/she could
use the power window switches and
get trapped in a window. Unat-
tended person (particularly a small
child) can be involved in a serious
accident.
TS12027
To open the back window, turn the key
clockwise and hold it for about 1 se-
cond.
After the door is locked, the window
opens slightly, and then lift the back win-
dow.
You can open the back window when the
back window wiper is working. At that
time, the wiper returns to the original
position and stops working.
The wiper restarts its working about 3
seconds after the back window is closed.
If the back window is not securely closed,
the back window wiper and washer will
not work. (See “Back window wiper and
washer” on page 95 and “Back window
defogger” on page 96 in Section 1−5.)
To close the back window, lower it. After
closing the back window, try pulling it up
to make sure it is securely closed.
When you close the back window, be
careful not to lock your keys in the ve-
hicle.
Back window

232007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
CAUTION
To avoid death or serious personal
injury, you must do the following.
Before you close the back window,
always make sure there is nobody
around the back window. You must
also make sure the heads, hands
and other parts of the bodies of all
occupants are kept completely in-
side the vehicle. If someone’s neck,
head or hands get caught in a clos-
ing window, it could result in death
or serious injury. When anyone
closes the back window, make sure
he or she operates the window
safely.
Keep the back window closed while
driving. This not only keeps the
luggage from being thrown out but
also prevents exhaust gases from
entering the vehicle.
NOTICE
To prevent damage to the back win-
dow dampers, do not apply any force,
paint or let any other foreign matter
on them.
TS12019a
Insert the key into the key hole and
turn it.
To lock: Turn the key clockwise.
To unlock: Turn the key counterclockwise.
When you turn the key clockwise and hold
it for about 1 second, the window opens.
(For details, see “Back window” on page
22 in this Section.)
Operating the power door lock switch si-
multaneously locks or unlocks all the side
doors and the back door. (See “—Locking
and unlocking doors” on page 11 and
“Side doors” on page 16.)
To open the back door, pull the back door
opener.When the back door is opened, it can be
held in the half
−open position. However, it
cannot be held in this position when being
closed.
The back door can be fixed in its full
open position. (For details, see “—Back
door fixing function” on page 24.)
When closing the back door, make sure
it is securely closed.
See “Cargo and luggage” on page 226 for
precautions when loading luggage.
CAUTION
Keep the back window and back door
closed while driving. This not only
keeps the luggage from being thrown
out but also prevents exhaust gases
from entering the vehicle.
NOTICE
To prevent damage to the back door
damper, do not apply any force, paint
or let any other foreign matter on it.
Back door—