2007 TOYOTA CAMRY HYBRID light

’07Camry hybrid_U (L/O 0610)
371
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
GoodBlown
Ty p e A
Good Blown
Ty p e B
Good Blown
Ty p e C
If the headlights or other electrical
components do not work, check the
fuses. If any of the fuses are blown,
they must be replaced.
See “Fuse locations” on page 348 in Sec-
tion 7 −1 for locations of the fuses.
Turn the hybrid system and inoperative
component off. Pull the suspected fuse
straight out and check it.
Determine which fuse may be causing the
problem. The lid of the fuse box shows
the name of the circuit for each fuse. See
page 386 in Section 8 for the functions
controlled by each circuit.
Type B fuses—When any of the fuses are
blown, contact your Toyota dealer.
Checking and replacing fuses

’07Camry hybrid_U (L/O 0610)
372
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Type A fuses can be pulled out by the
pull−out tool. The location of the pull −out
tool is shown in the illustration.
If you are not sure whether the fuse has
blown, try replacing the suspected fuse
with one that you know is good.
If the fuse has blown, push a new fuse
into the clip.
Only install a fuse with the amperage rat-
ing designated on the fuse box lid.
If you do not have a spare fuse, in an
emergency you can pull out the “RADIO
NO.1” or “PWR OUTLET” fuse, which may
be dispensable for normal driving, and use
it if its amperage rating is the same.
If you cannot use one of the same amper-
age, use one that is lower, but as close
to the rating as possible. If the amperage
is lower than that specified, the fuse
might blow out again but this does not
indicate anything wrong. Be sure to get
the correct fuse as soon as possible and
return the substitute to its original clip.
It is a good idea to purchase a set of
spare fuses and keep them in your ve-
hicle for emergencies. If the new fuse immediately blows out,
there is a problem with the electrical sys-
tem. Have your Toyota dealer correct it as
soon as possible.
CAUTION
Never use a fuse with a higher am-
perage rating, or any other object, in
place of a fuse. This may cause ex-
tensive damage and possibly a fire.
If the headlights or other electrical
components do not work and the fuses
are O.K., check the fusible link fitted
on the “+” terminal of the 12 volt bat-
tery. If the link is melted, it must be
replaced.
If there is an overload in the circuits, the
fusible links are designed to melt before
the entire wiring harness is damaged.
The battery is located in the right
−hand
side of the trunk. See “—12 volt battery
location” on page 369 in this Section.
Checking the fusible link

’07Camry hybrid_U (L/O 0610)
373
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
If the washer does not work or the
message “LOW WASHER FLUID” ap-
pears on the multiinformation display,
the washer tank may be empty. Add
washer fluid.
You may use plain water as washer fluid.
However, in cold areas where tempera-
tures range below the freezing point, use
washer fluid containing antifreeze. This
product is available at your Toyota dealer
and most auto parts stores. Follow the
manufacturer ’s directions for how much to
mix with water.
NOTICE
Do not use engine antifreeze or any
other substitute because it may dam-
age your vehicle’s paint.
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the hybrid system and
light switch are off. Use bulbs with the
wattage ratings given in the table.
The stop/tail lights and high mounted stop-
light consist of a number of LEDs. If any
of the LEDs burn out, take your vehicle
to your Toyota dealer to have the light
replaced.
If two or more LEDs in a stop light burn
out, your vehicle may not conform to local
laws (SAE).
CAUTION
To prevent burning yourself, do not
replace the light bulbs while they
are hot.
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toyota dealer.
Adding washer fluidReplacing light bulbs—

’07Camry hybrid_U (L/O 0610)
374
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Light bulbsBulbNo.WTy p e
Headlights
(high)900560A
Headlights (low)—55B
Front side
marker lights—5C
Front turn
signal/parking
lights
3457NAK30/8D
Rear turn signal
lights—21D
License plate
lights—5C
Back −up lights92116C
Personal lights—5C
Interior light—8E
Door courtesy
lights1685C
Vanity lights—8C
Glove box light—1.2C
Trunk light—3.8C
A: HB3 halogen bulbs
B: H11 halogen bulbs
C: Wedge base bulbs (clear)
D: Wedge base bulbs (amber)
E: Double end bulbs If the front turn signal/parking, side
marker, tail or backup lights, or high
mounted stoplight burns out, contact
your Toyota dealer.
NOTICE
Do not try to replace the front turn
signal/parking, side marker, tail, back
up light and high mounted stoplight
bulbs by yourself. You may damage
the vehicle.
—Front turn signal/parking,
side marker, tail and backup
lights, and high mounted
stoplight

’07Camry hybrid_U (L/O 0610)
375
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Low beam (outside)High beam
(inside)
1. Open the hood. Turn the bulb basecounterclockwise to the front of the
vehicle as shown.
The above illustration shows the left −hand
headlight.2. Unplug the connector while depress- ing the lock release.
If the connector is tight, wiggle it.3. Plug in a new bulb into the connec- tor and install it into the mounting
hole.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
—Headlights

’07Camry hybrid_U (L/O 0610)
376
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
—Rear turn signal lights

’07Camry hybrid_U (L/O 0610)
383
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
12 VOLT BATTERY
Open voltage
∗ at 20C (68 F):
12.6—12.8 V Fully charged
12.2—12.4 V Half charged
11.8—12.0 V Discharged
∗: Voltage that is checked 20 minutes af-
ter the key is removed with all the lights
turned off
Charging rates: 5 A max.
CAUTION
When replacing the battery, only
install a battery designated for your
hybrid vehicle. Using a conventional
battery may cause hydrogen gas to
build up in the vehicle.
TRANSAXLE
Fluid capacity (drain and refill), L (qt.,
Imp. qt.):
3.8 (4.0, 3.3)
Fluid type: Toyota Genuine ATF WS
Change the transmission fluid only as nec-
essary.
Generally, it is necessary to change
transmission fluid only if your vehicle is
driven under one of the Special Operating
Conditions listed in your “Scheduled
Maintenance Guide” or “Owner ’s Manual
Supplement”. When changing the
transmission fluid, use only “Toyota
Genuine ATF WS” (ATF JWS3324 or
NWS9638) to aid in assuring optimum
transaxle performance. Notice: Using transmission fluid other
than “Toyota Genuine ATF WS” may
cause deterioration in shift quality,
locking up of your transmission accom-
panied by vibration, and ultimately dam-
age the transmission of your vehicle.
Please contact your Toyota dealer for fur-
ther details.

’07Camry hybrid_U (L/O 0610)
386
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
ENGINE COMPARTMENT1. AM2 7.5 A: “POWER” switch
2. ABS MAIN No.2 10 A: Electronically
controlled brake system
3. ABS MAIN No.1 10 A: Electronically
controlled brake system
4. ABS MAIN No.3 10 A: Electronically
controlled brake system
5. BATT FAN 10 A: Hybrid battery fan
6. ETCS 10 A: Electronic throttle control
system
7. HAZ 15 A: Turn signal lights
8. IG2 20 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system, starting system, “GAUGE
NO.2”, “IGN” and “INJ” fuses
9. STR LOCK 20 A: Steering lock system
10. DOME 10 A: Gages and meters, vanity
lights, trunk light, “POWER” switch
light, door courtesy lights, interior light,
personal lights, clock, smart key
system
11. ECUB NO.1 10 A: Front passenger
occupant classification system, main
body ECU
12. RADIO NO.1 15 A: Audio system, nav-
igation system 13. DOOR NO.1 25 A:
Main body ECU,
power door lock
14. IGCT 30 A: Hybrid system ECU,
“PWR”, “IGCT No.2” and “INV W/P”
fuses
15. AMP 25 A: Audio system
16. EFI MAIN 30 A: Multiport fuel injection
system/s equential multiport fuel injec-
tion system, electronic throttle control
system and “EFI NO.3” fuses
17. EFI NO.3 10 A: Fuel tank system, mul-
tiport fuel injection system/sequential
multiport fuel injection system
18. IGCT NO.2 10 A: Hybrid system ECU,
motor generator ECU
19. INV W/P 15 A: Hybrid system ECU,
traction battery, DC/DC converter, mul-
tiport fuel injection system/sequential
multiport fuel injection system
20. SHORN 7.5 A: No circuit
21. A/F 20 A: No circuit
22. MPXB 10 A: Gauges and meters
23. EFI NO.1 10 A: Smart key system
24. HORN 10 A: Horns
25. HLP(RL) 15 A: Right−hand headlight
(low beam)
Fuses