2007 TOYOTA 4RUNNER transmission fluid

[x] Cancel search: transmission fluid

Page 18 of 470

TOYOTA 4RUNNER 2007 N210 / 4.G Owners Manual 82007 4Runner from Aug. ’06 Prod. (OM35866U)
or
Driver ’s seat belt reminder light∗1
Low engine oil pressure warning light∗1
Engine oil replacement reminder light∗1 
(for vehicles sold in U.

Page 19 of 470

TOYOTA 4RUNNER 2007 N210 / 4.G Owners Manual 92007 4Runner from Aug. ’06 Prod. (OM35866U)
Center differential lock indicator light∗3
(four −wheel drive models)
Automatic transmission indicator lights
Slip indicator light
Turn signal indica

Page 165 of 470

TOYOTA 4RUNNER 2007 N210 / 4.G Owners Manual 1552007 4Runner from Aug. ’06 Prod. (OM35866U)
(l) SRS Warning Light
This indicator comes on when the igni-
tion key is turned to the “ON” position.
It goes off after about 6 seconds. This
means

Page 371 of 470

TOYOTA 4RUNNER 2007 N210 / 4.G Owners Manual 3612007 4Runner from Aug. ’06 Prod. (OM35866U)
Check the condition of  the battery and
cables.
Cold temperatures reduce the capacity of
any battery, so it must be in top shape to
provide enough powe

Page 389 of 470

TOYOTA 4RUNNER 2007 N210 / 4.G Owners Manual 3792007 4Runner from Aug. ’06 Prod. (OM35866U)
CAUTION
Do not attempt to remove the radiator
cap when the engine and radiator are
hot. Serious injury could result from
scalding hot fluid and steam b

Page 418 of 470

TOYOTA 4RUNNER 2007 N210 / 4.G Owners Manual 4082007 4Runner from Aug. ’06 Prod. (OM35866U)
Power steering fluid level
Check the level through the reservoir. The
level should be in the “HOT” or “COLD”
range depending on the fluid tempe

Page 426 of 470

TOYOTA 4RUNNER 2007 N210 / 4.G Owners Manual 4162007 4Runner from Aug. ’06 Prod. (OM35866U)
Use only spark plugs of  the speci-
fied type. Using other types will
cause engine damage, loss of per-
formance or radio noise.
 Do not reuse iridiu

Page 435 of 470

TOYOTA 4RUNNER 2007 N210 / 4.G Owners Manual 4252007 4Runner from Aug. ’06 Prod. (OM35866U)
Clean all dirt from the outside of the res-
ervoir tank and look at the fluid level. If
the fluid is cold, the level should be in the
“COLD” range.
Page:   1-8 9-16 next >