2007 SUBARU TRIBECA height adjustment

Seat, seatbelt and SRS airbags 1-3
– CONTINUED –
„
Power seat
T Fore and aft adjustment To adjust the seat forward or backward,
move the control switch forward or back-
ward.
NOTE
During backward-forward adjustment
of the seat, you cannot adjust the seat
cushion angle or seat height. „
Reclining the seatback
To adjust the angle of the seatback, move
the control switch.
NEVER INSTALL A REARWARD
FACING CHILD SEAT IN THE FRONT
SEAT. DOING SO RISKS SERIOUSINJURY OR DEATH TO THE CHILD
BY PLACING THE CHILD’S HEAD
TOO CLOSE TO THE SRS AIRBAG.
According to accident statistics,
children are safer when properly re-
strained in the rear seating posi-
tions than in the front seating posi-
tions. For instructions and precau-
tions concerning child restraint sys-
tems, see the “Child restraint sys-
tems” section in this chapter.
100351
100085
To prevent the passenger from slid-
ing under the seatbelt in the event of
a collision, always put the seatback
in the upright position while the ve-
hicle is in motion. Also, do not place
objects such as cushions between
the passenger and the seatback. If
you do so, the risk of sliding under
the lap belt and of the lap belt sliding
up over the abdomen will increase,
and both can result in serious inter-
nal injury or death.
100354

1-4 Seat, seatbelt and SRS airbags
TSeat cushion angle adjustment
(Driver’s seat only)
To adjust the seat cushion angle, pull up
or push down the front end of the controlswitch. T
Seat height adjustment (Driver’s
seat only)
To adjust the seat height, pull up or push
down the rear end of the control switch. „
Head restraint adjustment
To raise the head restraint, pull it up. To
lower it, push the head restraint down
while pressing the release button on the
top of the seatback.
The head restraint should be adjusted so
that the center of the head restraint is clos-
est to the top of the occupant’s ears.
100352100353
Never drive the vehicle with the
head restraints removed because
they are designed to reduce the risk
of serious neck injury in the event
that the vehicle is struck from the
rear.
100355

1-10 Seat, seatbelt and SRS airbags
1) Bar
NOTE
1) Holder
With the seatback folded, attach the
tongue plate of each rear/second-row
seatbelt to the corresponding holder.
Do the same also before someone gets
into the third-row seat. „ Head restraint adjustmentTWindow side seats
To raise the head restraint, pull it up.
To lower it, push the head restraint down
while pressing the release button on the
top of the seatback.
The head restraint should be adjusted so
that the center of the head restraint is clos-
est to the top of the occupant’s ears.
When the seats are not occupied, lower
y
Folding the seatback of the center
seat will expose the bar that re-
tains it in the raised position. Be
careful not to hurt yourself on it.
Especially, do not rest your finger
on the bar. Otherwise, when the
seatback is raised, your finger
could be pinched between the bar
and seatback and thus injured.
y Raise the seatback of the center
seat while taking care not to trap
your hands or other parts of the
body between the center seat and
window-side seat.
1
100681
Never drive the vehicle with the
head restraints removed because
they are designed to reduce the risk
of serious neck injury in the event
that the vehicle is struck from the
rear.
1
100362
The head restraint is not intended to
be used at the lowest position. Be- fore sitting on the seat, raise the
head restraint to an appropriate po-
sition depending on your sitting
height.
100363

1-14 Seat, seatbelt and SRS airbags
NOTE
1) Holder
y Before folding or raising the seat-
back of the third-row seat, confirm that
the seatbelt is flat against the sidewall
at the lower point and the webbing is
attached to the holder. y When raising the seatback of the
third-row seat, if the seatbelt catches
on the seatback, hold the belt forward
of the seatback while latching the seat-
back. „
Head restraint adjustment
To raise the head restraint, pull it up.
To lower it, push the head restraint down
while pressing the release button on the
top of the seatback.
The head restraint should be adjusted so
that the center of the head restraint is clos-
est to the top of the occupant’s ears.
When the seats are not occupied, lower the head restraints to improve rearward visibility.
1
100647
Never drive the vehicle with the
head restraints removed because
they are designed to reduce the risk
of serious neck injury in the event
that the vehicle is struck from the
rear.
100371
The head restraint is not intended to
be used at the lowest position. Be-fore sitting on the seat, raise the
head restraint to an appropriate po-
sition depending on your sitting
height.