Dome Lamp
The dome lamp switch has three positions.
*(Off):The lamp will not come on as long as
the switch is in this position.
1(Automatic):The lamp will come on when a
door is opened. SeeEntry Lighting on page 153.
+(On):The lamp will stay on as long as
the switch is in this position.
Entry Lighting
If the dome lamp is in the automatic position,
the lamps inside your vehicle will come on when
any door is opened. In addition, the lights will
come on when the remote keyless entry unlock
button is pressed. It will stay on for 20 seconds or
until a door is opened. After the door is opened
the lights will remain on and stay on for
20 seconds after the doors are closed, or until
you put the key in the ignition and turn the key
to RUN. The lights will then gradually dim until
it is no longer lit.
Map Lamps
The lamps are located on the headliner above the
rearview mirror. To turn the lamps on, press
the lens. Press the lens again to turn them off.
Footwell Lamps
Your vehicle may have two footwell lamps.
These lights are located under the driver and
passenger seats. The switches are located on
the instrument panel under the climate controls.
There are two different colors of light that can
be selected. Press the upper part of the button
for blue light and press the bottom part of
the button for amber light. Each light will
illuminate the front and rear area of the seat.
153
ProCarManuals.com
Trailer Wiring
Additional wire length has been provided for
connecting trailer wiring to your vehicle. A loop of
ve wires is stored below the jack, which is located
on the driver’s side of the cargo area. The wires are
fused in both the underhood and instrument fuse
block. SeeInstrument Panel Fuse Block on
page 410andUnderhood Fuse Block on page 411.The wires do not have a connector and should be
wired to the trailer by a quali ed electrical
technician. The technician can use the following
information when connecting a trailer wiring
harness to your vehicle.
Yellow: Left Turn Signal
Brown: Parking Lamps
Light Blue: Stop Lamps
Black: Ground Wire
Dark Green: Right Turn Signal
When connecting a trailer harness, be sure you
leave it loose enough so the wiring does not bend
or break, but not so loose that it drags on the
ground. Store harness below jack in the cargo area
when it is not in use. Wrap the harness together
and tie it neatly so it will not be damaged.
300
ProCarManuals.com
