2007 SATURN AURA fuel

Instrument Panel Cluster
Your instrument panel cluster is designed to let you know at a glance how your vehicle is running. You
will know how fast you are going, how much fuel you are using, and many other things you will need
to drive safely and economically.
Your vehicle has this instrument panel cluster, which includes indicator warning lights and gages that are
explained on the following pages.
United States version shown, Canada Similar
162
ProCarManuals.com

Malfunction Indicator Lamp
Check Engine Light
Your vehicle has a
computer which
monitors operation of
the fuel, ignition,
and emission control
systems.
This system is called OBD II (On-Board
Diagnostics-Second Generation) and is intended
to make sure that emissions are at acceptable
levels for the life of the vehicle, helping to produce
a cleaner environment. The check engine light
comes on to indicate that there is a problem and
service is required. Malfunctions often will be
indicated by the system before any problem is
apparent. This can prevent more serious damage
to your vehicle. This system is also designed
to assist your service technician in correctly
diagnosing any malfunction.Notice:If you keep driving your vehicle with
this light on, after a while, the emission
controls might not work as well, your vehicle’s
fuel economy might not be as good, and the
engine might not run as smoothly. This
could lead to costly repairs that might not be
covered by your warranty.
Notice:Modications made to the engine,
transmission, exhaust, intake, or fuel system
of your vehicle or the replacement of the
original tires with other than those of the same
Tire Performance Criteria (TPC) can affect
your vehicle’s emission controls and can cause
this light to come on. Modications to these
systems could lead to costly repairs not
covered by your warranty. This could also
result in a failure to pass a required Emission
Inspection/Maintenance test. SeeAccessories
and Modifications on page 253.
172
ProCarManuals.com

This light should come on, as a check to show
you it is working, when the ignition is on and the
engine is not running. If the light does not
come on, have it repaired. This light will also
come on during a malfunction in one of two ways:
Light Flashing— A misre condition has
been detected. A misre increases vehicle
emissions and could damage the emission
control system on your vehicle. Diagnosis and
service might be required.
Light On Steady— An emission control
system malfunction has been detected on your
vehicle. Diagnosis and service might be
required.
If the Light is Flashing
The following can prevent more serious damage
to your vehicle:
Reduce vehicle speed.
Avoid hard accelerations.
Avoid steep uphill grades.
If the light stops ashing and remains on steady,
see “If the Light Is On Steady” following.If the light continues to ash, when it is safe to do
so, stop the vehicle. Find a safe place to park
the vehicle. Turn the key off, wait at least
10 seconds, and restart the engine. If the light
remains on steady, see “If the Light Is On Steady”
following. If the light is still ashing, follow the
previous steps and see your dealer/retailer
for service as soon as possible.
If the Light Is On Steady
You might be able to correct the emission system
malfunction by considering the following:
Did you recently put fuel into your vehicle?
If so, reinstall the fuel cap, making sure to fully
install the cap. SeeFilling the Tank on page 258.
The diagnostic system can determine if the
fuel cap has been left off or improperly installed. A
loose or missing fuel cap allows fuel to evaporate
into the atmosphere. A few driving trips with
the cap properly installed should turn the light off.
173
ProCarManuals.com

Did you just drive through a deep puddle of
water?
If so, your vehicle’s electrical system might be
wet. The condition is usually corrected when the
electrical system dries out. A few driving trips
should turn the light off.
Have you recently changed brands of fuel?
If so, be sure to fuel your vehicle with quality fuel.
SeeGasoline Octane on page 255. Poor fuel
quality causes the engine not to run as efficiently
as designed. You might notice this as stalling
after start-up, stalling when you put the vehicle into
gear, misring, hesitation on acceleration, or
stumbling on acceleration — these conditions
might go away once the engine is warmed up. This
will be detected by the system and cause the
light to turn on.
If you experience one or more of these conditions,
change the fuel brand you use. It will require at
least one full tank of the proper fuel to turn the
light off.
If none of the above steps have made the light
turn off, your dealer/retailer can check the vehicle.
Your dealer/retailer has the proper test equipment
and diagnostic tools to x any mechanical or
electrical problems that might have developed.Emissions Inspection and Maintenance
Programs
Some state/provincial and local governments have
or might begin programs to inspect the emission
control equipment on your vehicle. Failure to pass
this inspection could prevent you from getting a
vehicle registration.
Here are some things you need to know to help
your vehicle pass an inspection:
Your vehicle will not pass this inspection if the
check engine light is on or not working properly.
Your vehicle will not pass this inspection if
the OBD (on-board diagnostic) system determines
that critical emission control systems have not
been completely diagnosed by the system.
The vehicle would be considered not ready for
inspection. This can happen if you have recently
replaced the battery or if the battery has run
down. The diagnostic system is designed
to evaluate critical emission control systems
during normal driving. This can take several days
of routine driving. If you have done this and
your vehicle still does not pass the inspection for
lack of OBD system readiness, your dealer/retailer
can prepare the vehicle for inspection.
174
ProCarManuals.com

Fuel Gage
Your fuel gage tells you about how much fuel you
have left, when the ignition is on. When the
indicator nears empty, a LOW FUEL message will
appear on the Driver Information Center (DIC).
SeeDIC Warnings and Messages on page 182for
more information. You still have a little fuel left,
but you should get more soon. The arrow on
the fuel gage points to side of the vehicle with the
fuel door.Here are four things that some owners ask about.
These are normal and do not indicate a problem
with your fuel gage:
At the service station, the gas pump shuts off
before the gage reads full.
It takes a little more or less fuel to ll up than
the gage indicated. For example, the gage
may have indicated the tank was half full, but
it actually took a little more or less than
half the tank’s capacity to ll the tank.
The indicator moves a little when you turn a
corner or speed up.
The gage goes back to empty when you turn
off the ignition.
United StatesCanada
177
ProCarManuals.com

Auto Stop Mode
This mark on the tachometer shows that the
engine is in Auto Stop mode which is a fuel saving
operation.
When the ignition key is turned off, the tachometer
needle will drop to OFF. If the driver’s door is
opened while in Auto Stop, a chime will sound.
Charge/Assist Gage
The charge/assist gage
displays the charge
(current) into and out of
the battery.
When the electric motor is assisting the engine as
in a maximum acceleration, the needle will move to
the Assist range. When the electric motor operates
as a generator to perform regenerative braking
while decelerating, the needle will move to the
Charge range. SeeRegenerative Braking on
page 119for more information. The needle will also
move into the Charge region if the hybrid control
system deems it is an efficient time to charge the
hybrid battery. If the hybrid battery or other hybrid
components are very hot or cold, the Charge and
Assist functions may be suspended until the
component temperatures are normal.
United StatesCanada
178
ProCarManuals.com

Fuel Economy Light
If enabled, this light will
come on briey when
the vehicle is started.
This light will also come on when the vehicle is
operating at a fuel efficient point.
This light can be disabled by using the Driver
Information Center (DIC) buttons. With the engine
off and the key turned to accessory, set the
DIC to the outside air temperature and odometer
mode. Press and hold the reset button for
several seconds. The light will come on solid and
then ash several times and turn off to indicate
it is disabled. Repeat the procedure to enable the
light. SeeDIC Warnings and Messages on
page 182for more information.
Driver Information Center (DIC)
Your vehicle has a Driver Information Center (DIC).
The DIC display gives you the status of many of
your vehicle’s systems. The DIC is also used to
display driver personalization menu modes and
warning/status messages. All messages will appear
in the DIC display, located at the bottom of the
instrument panel cluster.
The DIC buttons are located on the left side of the
steering wheel. Your vehicle will have one of
the buttons shown above.
q/INFO (Information):Press this button to
scroll through the vehicle information mode
displays.
179
ProCarManuals.com

TRIP A or TRIP B
Press the information button until TRIP A or TRIP B
display. These modes show the current distance
traveled since the last reset for each trip odometer
in either miles (mi) or kilometers (km). Both
odometers can be used at the same time.
To reset the trip odometer to zero, press and hold
the reset button for a few seconds while the
desired trip odometer is displayed.
FUEL RANGE
Press the information button until FUEL RANGE
displays. This mode shows the remaining distance
you can drive without refueling in either miles (mi)
or kilometers (km). It is based on fuel economy and
the fuel remaining in the tank.
When the fuel level is low, FUEL RANGE LOW
displays.
The fuel economy data used to determine fuel
range is an average of recent driving conditions.
As your driving conditions change, this data is
gradually updated. The FUEL RANGE mode
cannot be reset.
MPG (L/100 KM) AVG (Average)
Press the information button until
MPG (L/100 KM) AVG displays. This mode shows
how many miles per gallon (mpg) or liters per
100 kilometers (L/100 km) your vehicle is getting
based on current and past driving conditions.
To reset the average fuel economy, press and hold
the reset button while MPG (L/100 KM) AVG is
displayed. Average fuel economy is then
calculated starting from that point. If the average
fuel economy is not reset, it is continually updated
each time you drive.
MPG (L/100 KM) INST (Instantaneous)
Press the information button until
MPG (L/100 KM) INST displays. This mode shows
the current fuel economy at a particular moment
and changes frequently as driving conditions
change. This mode shows the instantaneous fuel
economy in miles per gallon (mpg) or liters per
100 kilometers (L/100 km). Unlike average
fuel economy, this screen cannot be reset.
Under most coast conditions or at an idle stop,
AUTOSTOP displays. This means that the electric
motor is on, the gas engine is off, and the
engine is not using any fuel.
181
ProCarManuals.com