2007 RENAULT SCENIC ESP

RADIO
Configuration - Settings
86A
86A - 10V2 MR-372-J84-86A000$396_eng.mif
CONFIGURATIONS
NOTE:
To select the zone in which the radio is to be used,
press the buttons 2 and 5 while switching the power
on. Then wait approximately 2 min. Enter the four digit
code and then:
●select the tone curve appropriate for the vehicle
–0: no regulation
–1: Twingo
–2: Clio
–3: Mégane / Scénic
–4: Laguna
–5: Vel Satis - Espace
●select the relevant zone:
–America
–Japan
–Asia
–Arabia
–Others (Europe, Africa, other)SETTINGS
To enter configuration mode (Expert mode), press and
hold the Source button (4 seconds) until you hear a
bleep. This allows you to adjust the following functions:
NR range:
●AF mode activation (automatic retuning),
●vehicle speed-dependent volume control (5 for
maximum regulation, 0 to cancel regulation),
●Loudness mode activation.
PN range:
●AF mode activation (automatic retuning),
●vehicle speed-dependent volume control (5 for
maximum regulation, 0 to cancel regulation),
●Loudness mode activation,
●Assisted tuner mode activation,
●configuration of the number of speakers (2 or 4),
●manual or dynamic list selection.
PN6 radio:
●AF mode activation (automatic retuning),
●vehicle speed-dependent volume control (5 for
maximum regulation, 0 to cancel regulation),
●Loudness mode activation,
●Assisted tuner mode activation,
●configuration of the number of speakers (2 or 4),
●manual or dynamic list selection.
●activation of data storage in accordance with the
RENAULT Card: CARD ON/OFF. To operate, the
radio must be accompanied by the navigation
system. Note:
These configurations are not required when the
secret code is entered after the power supply has
been cut.
RADIO
Configuration - Settings
MR-372-J84-86A000$396_eng.mif

RADIO
Connections
86A
86A - 11V2 MR-372-J84-86A000$495_eng.mif
RADIO
Connections
To allocate the tracks for the different functions that are connected to the radio (CD changer, steering wheel control,
display, aerial), refer to the Wiring Diagrams Technical Note corresponding to the vehicle.
Radio: see Wiring diagrams Technical Note, vehicle, code 261
CD changer: see Wiring diagrams Technical Note, vehicle, code 1272
Display: see Wiring diagrams Technical Note, vehicle, code 1127
For displays which are connected to the instrument panel, the code is 247
Steering wheel control: see Wiring diagrams Technical Note, vehicle, code 325
Aerial: see Wiring diagrams Technical Note, vehicle, code 886
MR-372-J84-86A000$495_eng.mif

RADIO
Fault finding chart
86A
86A - 18V2 MR-372-J84-86A000$792_eng.mif
EXCEPT ESPACE IV, SCENIC II
ALP 4The radio is switched on, but the display and control satellite do
not operate
The radio operates but the
display does not light up.
Check the functions of the display that are not
connected to the radio by switching on the +
side lights feed (screen backlighting and
exterior temperature).
Is there anything
displayed on the
screen?No
Disconnect the aerial
amplifier
Yes
Check the continuity and
insulation of the wiring between
the radio and display using a
multimeter (see Wiring
diagrams Technical Note,
vehicle, code 261).Is there anything
displayed on the
screen?No
Check the display supply
(the fault is not associated
with the radio)
Yes
Check the continuity and insulation of the
34AM connection
NoNo
Are the tests OK?
Are the tests OK?Replace the wiring or repair it if the
procedure exists.
Yes
YesReplace the aerial
amplifier.
Disconnect then reconnect the
display. If the fault is still present,
replace the display.

RADIO
Fault finding chart
86A
86A - 19V2 MR-372-J84-86A000$792_eng.mif
The radio operates but the
display does not light up.
Check the functions of the display that are not
connected to the radio by switching on the +
side lights feed (screen backlighting and
exterior temperature).
Is there anything
displayed on the
screen?No
Disconnect the aerial
amplifier
Yes
Check the continuity and
insulation of the wiring between
the radio and instrument panel
using a multimeter (see Wiring
diagrams Technical Note,
vehicle, code 261).Is there anything
displayed on the
screen?No

Check the supply to the
instrument panel (the
radio is not at fault) See
Wiring diagrams
Technical Note,
vehicle, code 227.
Yes
Check the continuity and insulation of the
34AM connection
NoNo
Are the tests OK?
Are the tests OK?Replace the wiring or repair it if the
procedure exists.
Yes
YesReplace the aerial
amplifier.
Disconnect and reconnect the
connector connected to the
display. If the fault is still present,
replace the instrument panel.
ESPACE IV, SCENIC II
ALP 4The radio is switched on, but the display and control satellite do
not operate

RADIO
Fault finding chart
86A
86A - 24V2 MR-372-J84-86A000$792_eng.mif
ALP 7 The volume does not increase with the vehicle speed.
The SDVC (speed-dependent volume
control) function does not work.
Check the audio equipment
configuration (Expert mode). Set the
SPEED curve to 5 and run a test when
driving at a speed greater than 48 mph
(80 km/h).
No
Does the volume change?
Yes
The fault has been rectified. Check the signal on
connection 47F (see wiring
diagrams Technical Note,
vehicle, code 261) using a
multimeter. The voltage should
vary depending on vehicle
speed. Reset the control to: CURVE 2.
Yes
No
Does the signal increase?
YES
The fault is not associated with
the audio equipment. See MR
Fault finding corresponding to
vehicle, 38C, ABS, Conformity
check.Replace the radio with the
approval of your Techline.