2007 PONTIAC GRAND PRIX check engine

A. Windshield Washer Fluid Reservoir. See
“Adding Washer Fluid” underWindshield
Washer Fluid on page 377.
B. Battery. SeeBattery on page 381.
C. Remote Positive (+) Terminal. SeeJump
Starting on page 382.
D. Underhood Fuse Block. SeeUnderhood Fuse
Block on page 462.
E. Engine Coolant Recovery Tank. SeeCooling
System on page 366.
F. Pressure Cap. SeePressure Cap on page 364.
G. Power Steering Fluid Reservoir (low in
engine compartment). SeePower Steering
Fluid on page 376.
H. Supercharger Oil Fill Location (If Equipped).
SeeSupercharger Oil on page 355.I. Electric Cooling Fan. SeeCooling System on
page 366.
J. Engine Oil Dipstick. See “Checking Engine Oil”
underEngine Oil on page 350.
K. Engine Oil Fill Cap. See “When to Add Engine
Oil” underEngine Oil on page 350.
L. Engine Coolant Bleed Valve. See “How to Add
Coolant to the Radiator” underCooling
System on page 366.
M. Automatic Transaxle Fluid Dipstick. See
“Checking the Fluid Level” underAutomatic
Transaxle Fluid on page 357.
N. Brake Master Cylinder Reservoir. See “Brake
Fluid” underBrakes on page 378.
O. Engine Air Cleaner/Filter. SeeEngine Air
Cleaner/Filter on page 355.
347

A. Windshield Washer Fluid Reservoir. See
“Adding Washer Fluid” underWindshield
Washer Fluid on page 377.
B. Battery. SeeBattery on page 381.
C. Underhood Fuse Block. SeeUnderhood Fuse
Block on page 462.
D. Remote Positive (+) Terminal. SeeJump
Starting on page 382.
E. Pressure Cap. SeePressure Cap on page 364.
F. Power Steering Fluid Reservoir. SeePower
Steering Fluid on page 376.
G. Engine Oil Dipstick. See “Checking Engine Oil”
underEngine Oil on page 350.H. Engine Oil Fill Cap. See “When to Add Engine
Oil” underEngine Oil on page 350.
I. Automatic Transaxle Fluid Dipstick. See
“Checking the Fluid Level” underAutomatic
Transaxle Fluid on page 357.
J. Brake Master Cylinder Reservoir. See “Brake
Fluid” underBrakes on page 378.
K. Engine Air Cleaner/Filter. SeeEngine Air
Cleaner/Filter on page 355.
L. Engine Coolant Recovery Tank. SeeCooling
System on page 366.
349

Engine Oil
If this symbol, along with
the LOW OIL LEVEL
message appears on the
Driver Information
Center (DIC), it means
you need to check
the engine oil level
right away.
For more information, see LOW OIL LEVEL under
DIC Warnings and Messages on page 200. You
should check the engine oil level regularly;
this is an added reminder.
Checking Engine Oil
It is a good idea to check the engine oil every time
you get fuel. In order to get an accurate reading,
the oil must be warm and the vehicle must be
on level ground.
The engine oil dipstick handle is a yellow loop.
SeeEngine Compartment Overview on page 346
for the location of the engine oil dipstick.
1. Turn off the engine and give the oil
several minutes to drain back into the oil pan.
If you do not do this, the oil dipstick might
not show the actual level.
2. Pull out the dipstick and clean it with a paper
towel or cloth, then push it back in all the
way. Remove it again, keeping the tip down,
and check the level.
350

If you are in an area of extreme cold, where the
temperature falls below−20°F (−29°C), it is
recommended that you use either an SAE 5W-30
synthetic oil or an SAE 0W-30 oil. Both will
provide easier cold starting and better protection
for the engine at extremely low temperatures.
Engine Oil Additives
Do not add anything to the engine oil. The
recommended oils with the starburst symbol that
meet GM Standard GM6094M are all you will need
for good performance and engine protection.
Engine Oil Life System
When to Change Engine Oil
Your vehicle has a computer system that lets you
know when to change the engine oil and lter.
This is based on engine revolutions and engine
temperature, and not on mileage. Based on driving
conditions, the mileage at which an oil change
will be indicated can vary considerably. For the oil
life system to work properly, you must reset the
system every time the oil is changed.When the system has calculated that oil life has
been diminished, it will indicate that an oil change
is necessary. A CHANGE OIL SOON message
will come on. SeeDIC Warnings and Messages on
page 200. Change the oil as soon as possible
within the next 600 miles (1 000 km). It is possible
that, if you are driving under the best conditions,
the oil life system may not indicate that an oil
change is necessary for over a year. However, the
engine oil and lter must be changed at least
once a year and at this time the system must be
reset. Your dealer has GM-trained service
people who will perform this work using genuine
GM parts and reset the system. It is also important
to check the oil regularly and keep it at the
proper level.
If the system is ever reset accidentally, you must
change the oil at 3,000 miles (5 000 km) since
the last oil change. Remember to reset the oil life
system whenever the oil is changed.
353

Supercharger Oil
Because they are technically qualied and have
the proper tools, you should have your dealer
perform this maintenance.
When to Check
SeeAdditional Required Services on page 476for
when the oil level should be checked.
What Kind of Oil to Use
Use only the recommended supercharger oil. See
Recommended Fluids and Lubricants on
page 483.
Engine Air Cleaner/Filter
The engine air cleaner/lter is located in the
engine compartment on the driver’s side of the
vehicle. SeeEngine Compartment Overview
on page 346for more information on location.
When to Inspect the Engine Air
Cleaner/Filter
Inspect the air cleaner/lter at the MaintenanceII
intervals and replace it at the rst oil change
after each 50,000 mile (83 000 km) interval. See
Scheduled Maintenance on page 473for more
information. If you are driving in dusty/dirty
conditions, inspect the lter at each engine oil
change.
355

5. To reinstall the cover, position the tabs
through the slots on the housing. If your
vehicle has one of the 3800 V6 engines, a
notch on the sides of the lter cover will
indicate the correct engagement.
6. Push the cover tabs on top of the housing to
lock the cover in place.
{CAUTION:
Operating the engine with the air
cleaner/lter off can cause you or others
to be burned. The air cleaner not only
cleans the air; it helps to stop ames if
the engine backres. If it is not there and
the engine backres, you could be
burned. Do not drive with it off, and be
careful working on the engine with the air
cleaner/lter off.Notice:If the air cleaner/lter is off, a backre
can cause a damaging engine re. And, dirt
can easily get into your engine, which will
damage it. Always have the air cleaner/lter in
place when you are driving.
Automatic Transaxle Fluid
When to Check and Change Automatic
Transaxle Fluid
A good time to check the automatic transaxle uid
level is when the engine oil is changed.
Change the uid and lter at the intervals listed in
Additional Required Services on page 476, and
be sure to use the transaxle uid listed in
Recommended Fluids and Lubricants on page 483.
357

How to Check Automatic Transaxle
Fluid
Because this operation can be a little difficult, you
may choose to have this done at the dealership
service department.
If you do it yourself, be sure to follow all the
instructions here, or you could get a false reading
on the dipstick.
Notice:Too much or too little uid can
damage the transaxle. Too much can mean
that some of the uid could come out and fall
on hot engine or exhaust system parts,
starting a re. Too little uid could cause the
transaxle to overheat. Be sure to get an
accurate reading if you check the transaxle
uid.Wait at least 30 minutes before checking the
transaxle uid level if you have been driving:When outside temperatures are above
90°F (32°C).
At high speed for quite a while.
In heavy traffic — especially in hot weather.
While pulling a trailer.
To get the right reading, the uid should be at
normal operating temperature, which is 180°F to
200°F (82°C to 93°C).
Get the vehicle warmed up by driving about
15 miles (24 km) when outside temperatures are
above 50°F (10°C). If it is colder than 50°F (10°C),
you may have to drive longer.
358

Checking the Fluid Level
Prepare the vehicle as follows:
1. Park the vehicle on a level place. Keep the
engine running.
2. With the parking brake applied, place the shift
lever in PARK (P).
3. With your foot on the brake pedal, move the
shift lever through each gear, pausing for
about three seconds in each one. Then,
position the shift lever in PARK (P).
4. Let the engine run at idle for three to
ve minutes.
Then, without shutting off the engine, follow
these steps:
The transaxle uid
dipstick handle has this
symbol on it, and is
located near the rear of
the engine compartment.SeeEngine Compartment Overview on page 346
for more information on location.
1. Pull out the dipstick and wipe it with a clean
rag or paper towel.
2. Push it back in all the way, wait three seconds
and then pull it back out again.
3. Check both sides of the dipstick, and read the
lower level. The uid level must be in the
crosshatched area.
4. If the uid level is in the acceptable range,
push the dipstick back in all the way.
359