2007 PONTIAC GRAND PRIX steering

OnStar®Steering Wheel Controls
Your vehicle may have a Talk/Mute button that
can be used to interact with OnStar®Hands-Free
Calling. SeeAudio Steering Wheel Controls on
page 277for more information.
On some vehicles, you may have to hold the
button for a few seconds and give the command
“ONSTAR” in order to activate the OnStar
®
Hands-Free Calling feature.
On some vehicles, the mute button can be used to
dial numbers into voicemail systems, or to dial
phone extensions. See the OnStar
®Owner’s
Guide for more information.
How OnStar®Service Works
In order to provide you with OnStar®services,
your vehicle’s OnStar®system has the capability
of recording and transmitting vehicle information.
This information is automatically sent to an
OnStar
®Call Center at the time of an OnStar®
button press, Emergency button press or if
your airbags or AACN system deploys.The vehicle information usually includes your GPS
location and, in the event of a crash, additional
information regarding the accident that your vehicle
has been involved in (e.g. the direction from
which your vehicle was hit). When you use the
Virtual Advisor feature of OnStar
®Hands-Free
Calling, your vehicle also sends OnStar®your GPS
location so that we can provide you with
location-based services.
OnStar
®service cannot work unless your vehicle
is in a place where OnStar®has an agreement
with a wireless service provider for service in that
area. OnStar
®service also cannot work unless
you are in a place where the wireless service
provider OnStar
®has hired for that area
has coverage, network capacity and reception
when the service is needed, and technology that
is compatible with the OnStar
®service. Not all
services are available everywhere, particularly in
remote or enclosed areas, or at all times.
OnStar
®service that involves location information
about your vehicle cannot work unless GPS
satellite signals are unobstructed and available in
that place as well.
125

Traction Control System (TCS)
Warning Light........................................ 178
Enhanced Traction System
Warning Light........................................ 179
Engine Coolant Temperature
Warning Light........................................ 179
Engine Coolant Temperature Gage............ 180
Malfunction Indicator Lamp........................ 180
Oil Pressure Light..................................... 184
Fog Lamp Light......................................... 185
Cruise Control Light.................................. 185
Highbeam On Light................................... 185
Fuel Gage................................................. 185
Driver Information Center (DIC).................. 186
DIC Controls and Displays
(Base Level DIC)................................... 186
DIC Controls and Displays
(Uplevel DIC with Trip Computer)........... 190
DIC Compass (Uplevel DIC)...................... 198
DIC Warnings and Messages.................... 200
DIC Vehicle Customization........................ 226Audio System(s)......................................... 233
Setting the Time........................................ 234
Radio with CD (Base Level)...................... 235
Radio with CD (MP3)................................ 245
Radio with Six-Disc CD............................. 255
Using an MP3........................................... 269
XM Radio Messages................................. 275
Theft-Deterrent Feature............................. 277
Audio Steering Wheel Controls.................. 277
Radio Reception........................................ 278
Care of Your CDs..................................... 279
Care of the CD Player.............................. 279
Backglass Antenna.................................... 280
XM™ Satellite Radio Antenna System....... 281
Chime Level Adjustment............................ 281
Section 3 Instrument Panel
130

The main components of the instrument panel are the following:
A. Side Window Defogger Outlets. SeeOutlet
Adjustment on page 166.
B. Air Outlets. SeeOutlet Adjustment on page 166.
C. Turn Signal/Multifunction Lever and Cruise
Controls. SeeTurn Signal/Multifunction Lever
on page 135andCruise Control on page 140.
D. TAP-Shift
®Control (If Equipped). See
Automatic Transaxle Operation on page 110.
E. Hazard Warning Flashers Button. See
Hazard Warning Flashers on page 134.
F. Instrument Panel Cluster. SeeInstrument Panel
Cluster on page 169.
G. Windshield Wiper Lever. SeeWindshield Wiper
Lever on page 138.
H. Ignition. SeeIgnition Positions on page 105.
I. Driver Information Center (DIC) (If Equipped).
SeeDriver Information Center (DIC) on
page 186.
J. Audio System. SeeAudio System(s) on
page 233.K. Audio Steering Wheel Controls (If Equipped).
SeeAudio Steering Wheel Controls on
page 277.
L. Hood Release. SeeHood Release on page 345.
M. Tilt Steering Wheel Lever, on Steering Column.
SeeTilt Wheel on page 135.
N. Interior Lamps Brightness Control. SeeInterior
Lamps on page 146.
O. Passenger Air Bag Status Indicator. See
Passenger Airbag Status Indicator on page 173.
P. Climate Controls. SeeClimate Control
System on page 157.
Q. Shift Lever. SeeAutomatic Transaxle Operation
on page 110.
R. Traction Control Button (If Equipped). See
Traction Control System (TCS) on page 292.
S. Head Up Display (HUD) Control (If Equipped).
SeeHead-Up Display (HUD) on page 151.
T. Glove Box. SeeGlove Box on page 126.
U. Instrument Panel Fuse Block. SeeInstrument
Panel Fuse Block on page 460.
133

Hazard Warning Flashers
The hazard warning ashers warn others. They
also let police know you have a problem.
Your front and rear turn signal lamps will ash on
and off.
The hazard warning
asher button is located
on top of the steering
column.
The hazard warning ashers work no matter what
ignition position the key is in, and even if the
key is not in the ignition.Press the button to make the front and rear turn
signal lamps ash on and off. Press the button
again to turn the ashers off.
When the hazard warning ashers are on, your
turn signals will not work.
Other Warning Devices
If you carry reective triangles, you can set them up
at the side of the road about 300 feet (100 m)
behind your vehicle.
Horn
Press on or near the horn symbols on the steering
wheel pad to sound the horn.
134

Tilt Wheel
A tilt wheel enables the position of the steering
wheel to be adjusted. The lever that lets the
steering wheel tilt is located on the outboard side
of the steering column.
To tilt the steering wheel, hold it and pull the lever.
Move the steering wheel to a comfortable driving
position and release the lever to lock it into place.
Tilt the steering wheel to the highest position to
give more room when exiting and entering
the vehicle.
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
GTurn and Lane-Change Signals. See
Turn and Lane-Change Signals on page 136.
3Headlamp High/Low-Beam Changer. See
Headlamp High/Low-Beam Changer on
page 137.
-Fog Lamps. SeeFog Lamps on page 146.
135

Flash-to-Pass Feature. SeeFlash-to-Pass on
page 137.
ICruise Control. SeeCruise Control on
page 140.
PExterior Lamps Control. SeeExterior
Lamps on page 144.
Turn and Lane-Change Signals
To signal a turn, move the turn signal lever located
on the left side of the steering column all the
way up or down. The lever returns automatically
when the turn is complete.
An arrow on the
instrument panel cluster
will ash in the
direction of the turn or
lane change.
If the vehicle is equipped with the Head-Up-Display
(HUD), a right or left turn signal will appear in
the HUD area when making turns or lane changes.
SeeHead-Up Display (HUD) on page 151for
more information.Raise or lower the lever until the arrow starts to
ash to signal a lane change. Hold it there until the
lane change is complete. The lever returns to its
original position when it is released.
Arrows that ash rapidly when signaling for a turn
or lane change may be caused by a burned-out
signal bulb. Other drivers will not see the signal.
Replace burned-out bulbs to help avoid possible
accidents. SeeReplacement Bulbs on page 398,
Front Turn Signal, Parking and Fog Lamps on
page 394, andTaillamps, Turn Signal, and
Stoplamps on page 395. Also, check the fuse for
burned-out bulbs if a turn signal arrow fails to
work when signaling a turn. SeeFuses and Circuit
Breakers on page 460for location information.
Turn Signal On Chime
If the turn signal is left on for more than
0.75 of a mile (1.21 km), a warning chime will
sound and the TURN SIGNAL ON warning
message will appear on the Driver Information
Center (DIC) display. See “Turn Signal On” under
DIC Warnings and Messages on page 200.
136

Windshield Wiper Lever
Be sure to clear ice and snow from the wiper blades
before using them. If they are frozen to the
windshield, gently loosen or thaw them. Damaged
wiper blades may not clear the windshield well,
making it harder to see and drive safely. If the
blades do become damaged, install new blades or
blade inserts. For more information, seeWindshield
Wiper Blade Replacement on page 399.
Heavy snow or ice can overload the wiper motor.
A circuit breaker will stop the motor until it
cools down. Clear away snow or ice to prevent an
overload.
N(Windshield Wipers):The lever with this
symbol, located on the right side of the steering
column, operates the windshield wipers.
9(Off):Lower the lever to its original position to
turn the wipers off.
&(Delay):Push the lever up once to this
position to set a delay between wiping cycles. Turn
the delay adjustment band to set the length of
the delay.
x(Delay Adjustment):Turn the band, located
on the left of the windshield wiper lever, to set
the length of the delay between wiper cycles when
using the delay feature. There are ve delay
adjustment settings. Turn the band up to make the
delays shorter in between wiper cycles. Turn
the band down to make the delays longer between
wiper cycles. The windshield wiper lever must
be in delay for this feature to work.
138

Exterior Lamps
The exterior lamp control is located to the left of
the steering wheel on the multifunction lever.
O(Exterior Lamp Control):Turn the band with
this symbol on it to operate the exterior lamps.
The exterior lamp band has four positions:
O(Off):Turning the band to this position turns
off all lamps.
AUTO (Automatic):Turning the band to this
position sets the exterior lamps in automatic mode.
AUTO mode will turn the exterior lamps on and
off depending on how much light is available
outside the vehicle.To override AUTO mode, turn the control to off.
To reset to AUTO mode turn the control to exterior
lamps and then back to AUTO. Automatic mode
will also reset when your vehicle is turned off
and then back on again when the control is left in
the AUTO position.
;(Parking Lamp):Turning the band to this
position turns on the parking lamps together with
the following:
Sidemarker Lamps
Taillamps
License Plate Lamps
Instrument Panel Lights
The parking brake indicator light will come on and
stay on when the parking lamps are on with the
engine off and the ignition to ACC.
5(Headlamps):Turning the control to this
position turns on the headlamps, together with the
previously listed lamps and lights.
144