2007 PONTIAC G6 brake

Keys.............................................................. 99
Remote Keyless Entry System.................. 100
Remote Keyless Entry System
Operation............................................... 101
Doors and Locks........................................ 108
Door Locks................................................ 108
Power Door Locks..................................... 109
Door Ajar Reminder.................................. 109
Delayed Locking........................................ 110
Automatic Door Lock................................. 110
Programmable Automatic Door Unlock....... 111
Rear Door Security Locks......................... 111
Lockout Protection..................................... 112
Trunk........................................................ 113
Windows...................................................... 115
Power Windows........................................ 116
Sun Visors................................................ 117
Theft-Deterrent Systems............................. 118
Content Theft-Deterrent............................. 118
PASS-Key
®III+......................................... 120
PASS-Key®III+ Operation......................... 120Starting and Operating Your Vehicle......... 122
New Vehicle Break-In................................ 122
Ignition Positions....................................... 122
Retained Accessory Power (RAP)............. 124
Starting the Engine.................................... 125
Adjustable Throttle and Brake Pedal
(Automatic Transaxle)............................ 127
Engine Coolant Heater.............................. 128
Automatic Transaxle Operation.................. 129
Manual Transaxle Operation...................... 134
Parking Brake........................................... 135
Shifting Into Park (P)
(Automatic Transaxle)............................ 136
Shifting Out of Park (P)
(Automatic Transaxle)............................ 138
Parking Your Vehicle
(Manual Transaxle)................................ 138
Parking Over Things That Burn................. 139
Engine Exhaust......................................... 140
Running the Engine While Parked............. 141
Section 2 Features and Controls
97

Starting and Operating Your
Vehicle
New Vehicle Break-In
Notice:Your vehicle does not need an
elaborate break-in. But it will perform better in
the long run if you follow these guidelines:
Do not drive at any one constant speed, fast
or slow, for the rst 500 miles (805 km). Do
not make full-throttle starts. Do not exceed
5,000 engine rpm. Avoid downshifting to
brake, or slow, the vehicle.
Avoid making hard stops for the rst
200 miles (322 km) or so. During this time
your new brake linings are not yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking-in guideline every time
you get new brake linings.
Do not tow a trailer during break-in. See
Towing a Trailer on page 296for the trailer
towing capabilities of your vehicle and more
information.Following break-in, engine speed and load can
be gradually increased.
Ignition Positions
With the key in the
ignition switch, you can
turn it to four different
positions.
Notice:Using a tool to force the key from the
ignition switch could cause damage or break
the key. Use the correct key and turn the key
only with your hand. Make sure the key is in all
the way. If none of this works, then your vehicle
needs service.
122

Starting the Engine
To place the transaxle in the proper gear:
Automatic Transaxle
Move your shift lever to PARK (P) or
NEUTRAL (N). Your engine will not start in
any other position -- this is a safety feature.
To restart when you are already moving, use
NEUTRAL (N) only.
Notice:Shifting into PARK (P) with the vehicle
moving could damage the transaxle. Shift into
PARK (P) only when your vehicle is stopped.
Manual Transaxle
The shift lever should be in the NEUTRAL position
and the parking brake engaged. Hold the clutch
pedal to the oor and start the engine. Your vehicle
will not start if the clutch pedal is not all the way
down. That is a safety feature.
Starting Procedure
1. With your foot off the accelerator pedal, turn
the ignition key to START. When the engine
starts, let go of the key. The idle speed will
go down as your engine gets warm. Do not
race the engine immediately after starting it.
Operate the engine and transaxle gently to
allow the oil to warm up and lubricate all
moving parts.
Your vehicle has a Computer-Controlled
Cranking System. This feature assists in
starting the engine and protects components.
If the ignition key is turned to the START
position, and then released when the engine
begins cranking, the engine will continue
cranking for a few seconds or until the
vehicle starts. If the engine does not start
and the key is held in START for many
seconds, cranking will be stopped after
15 seconds to prevent cranking motor damage.
125

Adjustable Throttle and Brake Pedal
(Automatic Transaxle)
If your vehicle has this feature, you can change
the position of the throttle and brake pedals.
This feature is designed for shorter drivers, since
the pedals cannot move farther away from the
standard position, but can move rearward
for better pedal reach.
The vehicle must be in PARK (P) or have the
ignition off for this feature to operate. If the system
senses unusually high resistance while the pedals
are being adjusted, such as a driver’s foot pushing
the brake pedal, it is designed to disable the switch.
Remove the obstruction and try to adjust the pedals
again.The switch used to
adjust the pedals is
located on the left side
of the instrument panel.
To use your adjustable throttle and brake pedal
feature, do the following:
The adjustable pedal feature is meant to be used
with the adjustable seat and adjustable steering
wheel controls to reach a safe and comfortable
position.
1. Adjust your seat to a comfortable position
where you can comfortably reach other
controls such as the radio and climate
controls.
2. Adjust the throttle and brake pedals to reach
a comfortable and safe operating position.
3. Adjust the steering wheel to a safe operating
position.
127

Instead of trying to list everything here, we ask that
you contact your dealer in the area where you will
be parking your vehicle. The dealer can give you
the best advice for that particular area.
Automatic Transaxle Operation
Your automatic transaxle has a shift lever located
on the console between the seats.
PARK (P):This position locks your front wheels.
It is the best position to use when you start
the engine because your vehicle cannot move
easily.
{CAUTION:
It is dangerous to get out of your vehicle
if the shift lever is not fully in PARK (P)
with the parking brake rmly set. Your
vehicle can roll.
Do not leave your vehicle when the engine
is running unless you have to. If you have
left the engine running, the vehicle can
move suddenly. You or others could be
injured. To be sure your vehicle will not
move, even when you are on fairly level
ground, always set your parking brake
and move the shift lever to PARK (P). See
Shifting Into Park (P) (Automatic Transaxle)
on page 136. If you are pulling a trailer, see
Towing a Trailer on page 296.
Make sure the shift lever is fully in PARK (P)
before starting the engine. Your vehicle has an
automatic transaxle shift lock control system.
SE ModelGT and GTP Models
129

You have to apply your regular brake rst and then
press the shift lever button before you can shift from
PARK (P) while the ignition key is in ON. If you
cannot shift out of PARK (P), ease pressure on the
shift lever and push the shift lever all the way into
PARK (P) as you maintain brake application. Press
the shift lever button and then move the shift lever
into another gear. SeeShifting Out of Park (P)
(Automatic Transaxle) on page 138later in this
section.
REVERSE (R):Use this gear to back up.
Notice:Shifting to REVERSE (R) while your
vehicle is moving forward could damage the
transaxle. The repairs would not be covered by
your warranty. Shift to REVERSE (R) only after
your vehicle is stopped.
To rock your vehicle back and forth to get out of
snow, ice, or sand without damaging your
transaxle, seeIf Your Vehicle is Stuck in Sand,
Mud, Ice, or Snow on page 287.NEUTRAL (N):In this position, your engine does
not connect with the wheels. To restart when
you are already moving, use NEUTRAL (N) only.
Also, use NEUTRAL (N) when your vehicle is
being towed.
{CAUTION:
Shifting into a drive gear while your
engine is running at high speed is
dangerous. Unless your foot is rmly on
the brake pedal, your vehicle could move
very rapidly. You could lose control and
hit people or objects. Do not shift into a
drive gear while your engine is running at
high speed.
Notice:Shifting out of PARK (P) or
NEUTRAL (N) while the engine is running at
high speed may damage the transaxle. The
repairs would not be covered by your warranty.
Be sure the engine is not running at high
speeds when shifting your vehicle.
130

DRIVE (D):This position is for normal driving. It
provides the best fuel economy for your vehicle. If
you need more power for passing, and you are:
Going less than 35 mph (55 km/h), push
your accelerator pedal about halfway down.
Going about 35 mph (55 km/h) or more, push
the accelerator all the way down.
You will shift down to the next gear and have
more power.
Downshifting the transaxle in slippery road
conditions could result in skidding, see “Skidding”
underLoss of Control on page 271.
Notice:If your vehicle seems to accelerate
slowly or not shift gears when you go faster,
and you continue to drive your vehicle that way,
you could damage the transaxle. Have your
vehicle serviced right away. You can drive in
LOW (L) when you are driving less than 35 mph
(55 km/h) and DRIVE (D) for higher speeds
until then.THIRD (3):This position, available on the SE
model, is also used for normal driving. However,
it reduces vehicle speed more than DRIVE (D)
without using your brakes. Here are some times
you might choose THIRD (3) instead of DRIVE (D):When driving on hilly, winding roads.
When towing a trailer, so there is less shifting
between gears.
When going down a steep hill.
LOW (L):This position, available on the SE model,
reduces vehicle speed more than THIRD (3)
without using your brakes. You can use LOW (L) on
hills. It can help control your speed as you go down
steep mountain roads, but then you would also
want to use your brakes off and on.
131

You can use LOW (L) on very steep hills, or in deep
snow or mud. If the shift lever is put in LOW (L), the
transaxle will not shift into rst gear until the vehicle
is going slowly enough.
Notice:Driving in LOW (L) for more than
25 miles (40 km) or at speeds over 55 mph
(90 km/h) may damage the transaxle. Also,
shifting into LOW (L) at speeds above 65 mph
(105 km/h) can cause damage. Drive in
THIRD (3) or DRIVE (D) instead of LOW (L).
Notice:Spinning the tires or holding the
vehicle in one place on a hill using only the
accelerator pedal may damage the transaxle.
If you are stuck, do not spin the tires. When
stopping on a hill, use the brakes, or parking
brake to hold the vehicle in place.
MANUAL MODE (M):This position, available on
the GT/GTP models, allows you to change gears
similar to a manual transaxle. If your vehicle has
this feature, see Manual Shift Mode (MSM)
following.Manual Shift Mode (MSM)
(Automatic Transaxle)
To use this feature, do the following:
1. Move the shift lever from DRIVE (D) rearward
and then to the right into the MANUAL
MODE (M).
While driving in manual shift mode, the
transaxle will remain in the driver gear selected.
When coming to a stop in the manual position,
the vehicle will automaticaly shift to
FIRST (1) gear.
2. Press the shift level forward to upshift or
rearward to downshift.
The odometer display on the instrument panel
cluster will change from the vehicle’s mileage to
the letter M, for manual shift mode, and a number
indicating the requested gear range when
moving the shift lever forward or rearward. See
Speedometer and Odometer on page 194for more
information.
While using the MSM feature the vehicle will have
rmer shifting and sportier performance. You can
use this for sport driving or when climbing hills to
stay in gear longer or to downshift for more power
or engine braking.
132