2007 PONTIAC G6 towing

Shifting Into Park (P)
(Automatic Transaxle)
{CAUTION:
It can be dangerous to get out of your
vehicle if the shift lever is not fully in
PARK (P) with the parking brake rmly
set. Your vehicle can roll. If you have left
the engine running, the vehicle can move
suddenly. You or others could be injured.
To be sure your vehicle will not move,
even when you are on fairly level ground,
use the steps that follow. If you are
pulling a trailer, seeTowing a Trailer on
page 296.Use the following procedure to shift into PARK (P):
1. Hold the brake pedal down with your right
foot and set the parking brake.
2. Move the shift lever into PARK (P) by holding
in the button on the shift lever and pushing
the lever all the way toward the front of
the vehicle.
3. Turn the ignition key to OFF.
4. Remove the key and take it with you. If you
can leave your vehicle with the ignition key in
your hand, your vehicle is in PARK (P).
136

Running the Engine While Parked
It is better not to park with the engine running. But if
you ever have to, here are some things to know.
{CAUTION:
Idling the engine with the climate control
system off could allow dangerous exhaust
into your vehicle. See the earlier caution
underEngine Exhaust on page 140.
Also, idling in a closed-in place can let
deadly carbon monoxide (CO) into your
vehicle even if the climate control fan is at
the highest setting. One place this can
happen is a garage. Exhaust — with
CO — can come in easily. NEVER park
in a garage with the engine running.
Another closed-in place can be a blizzard.
SeeWinter Driving on page 282.
{CAUTION:
It can be dangerous to get out of your
vehicle if the automatic transaxle shift
lever is not fully in PARK (P) with the
parking brake rmly set. Your vehicle can
roll. Do not leave your vehicle when the
engine is running unless you have to.
If you have left the engine running, the
vehicle can move suddenly. You or others
could be injured. To be sure your vehicle
will not move, even when it is on fairly
level ground, always set the parking brake
and move the automatic transaxle shift
lever to PARK (P), or the manual transaxle
shift lever to NEUTRAL.
Follow the proper steps to be sure your vehicle
will not move. If you have an automatic transaxle,
seeShifting Into Park (P) (Automatic Transaxle)
on page 136.
If you are parking on a hill and if you are pulling a
trailer, seeTowing a Trailer on page 296.
141

The hardtop will not operate if the vehicle has an
electrical failure. If an electrical failure occurs,
see your dealer for service.
If your vehicle has an electrical failure while
operating the hardtop, and must be towed to a
dealer for service, your vehicle should be towed
by atbed with the vehicle facing backwards.
Consult your dealer or professional towing service
if you need to have your disabled vehicle towed.
SeeRoadside Assistance Program on page 456.Raising the Retractable Hardtop
1. Park on a level surface and apply the parking
brake. Shift the automatic transaxle into
PARK (P). The vehicle must be in PARK (P),
and the engine must be running, or the ignition
turned to the ON position, to operate the
retractable hardtop.
2. The trunk cargo cover must be fully closed,
and the trunk must be closed before raising
the hardtop.
157

After the hardtop has raised completely, release
the switch. If you continue to press the switch for
about two seconds after the hardtop has raised
completely, the windows will automatically close.
If pressure is released from the switch before the
hardtop cycle is complete, the cycle will stop and
the Driver Information Center (DIC) will display the
TOP NOT SECURE message. Always press and
hold the switch until a chime sounds, if the engine
is on, and the Driver Information Center (DIC)
displays the TOP MOVE COMPLT to signal the
procedure is complete. SeeDIC Warnings and
Messages on page 212for more information.The hardtop will not operate if the vehicle has an
electrical failure. If an electrical failure occurs,
see your dealer for service.
If your vehicle has an electrical failure while
operating the hardtop, and must be towed to a
dealer for service, your vehicle should be towed by
atbed with the vehicle facing backwards. Consult
your dealer or professional towing service if you
need to have your disabled vehicle towed. See
Roadside Assistance Program on page 456.
160

When the ignition is on, the brake system warning
light will also come on when you set your
parking brake. The light will stay on if your parking
brake does not release fully. If it stays on after
your parking brake is fully released, it means you
have a brake problem.
If the light comes on while you are driving, pull off
the road and stop carefully. Make sure the parking
brake is fully released. You may notice that the
pedal is harder to push or, the pedal may go closer
to the oor. It may take longer to stop. If the light is
still on, have the vehicle towed for service. See
Towing Your Vehicle on page 293.
{CAUTION:
Your brake system may not be working
properly if the brake system warning light
is on. Driving with the brake system
warning light on can lead to an accident.
If the light is still on after you have pulled
off the road and stopped carefully, have
the vehicle towed for service.
Anti-Lock Brake System
Warning Light
If your vehicle has the
anti-Lock Brake System
(ABS), this light will
come on when your
engine is started and
may stay on for several
seconds. That is normal.
If the light stays on, turn the ignition to OFF. Or, if
the light comes on when you are driving, stop
as soon as possible and turn the ignition off. Then
start the engine again to reset the system. If
the light still stays on, or comes on again while
you are driving, your vehicle needs service. If the
regular brake system warning light is not on,
you still have brakes, but you do not have anti-lock
brakes. If the regular brake system warning light
is also on, you do not have anti-lock brakes
and there is a problem with your regular brakes.
SeeBrake System Warning Light on page 199.
The ABS warning light will come on briey when
you turn the ignition key to ON. This is normal. If the
light does not come on then, have it xed so it will
be ready to warn you if there is a problem.
200

This light should come on, as a check to show
you it is working, when the ignition is on and the
engine is not running. If the light does not
come on, have it repaired. This light will also
come on during a malfunction in one of two ways:
Light Flashing— A misre condition has
been detected. A misre increases vehicle
emissions and may damage the emission
control system on your vehicle. Diagnosis and
service may be required.
Light On Steady— An emission control
system malfunction has been detected on your
vehicle. Diagnosis and service may be
required.
If the Light is Flashing
The following may prevent more serious damage
to your vehicle:
Reducing vehicle speed
Avoiding hard accelerations
Avoiding steep uphill grades
If you are towing a trailer, reduce the amount
of cargo being hauled as soon as it is
possibleIf the light stops ashing and remains on steady,
see “If the Light Is On Steady” following.
If the light continues to ash, when it is safe to do
so, stop the vehicle. Find a safe place to park
your vehicle. Turn the key off, wait at least
10 seconds and restart the engine. If the light
remains on steady, see “If the Light Is On Steady”
following. If the light is still ashing, follow the
previous steps, and see your dealer for service as
soon as possible.
If the Light Is On Steady
You may be able to correct the emission system
malfunction by considering the following:
Did you recently put fuel into your vehicle?
If so, reinstall the fuel cap, making sure to fully
install the cap. SeeFilling the Tank on page 313.
The diagnostic system can determine if the
fuel cap has been left off or improperly installed.
A loose or missing fuel cap will allow fuel to
evaporate into the atmosphere. A few driving trips
with the cap properly installed should turn the
light off.
205

Your Driving, the Road, and
Your Vehicle............................................ 254
Defensive Driving...................................... 254
Drunken Driving........................................ 255
Control of a Vehicle.................................. 258
Braking...................................................... 258
Anti-Lock Brake System (ABS).................. 259
Braking in Emergencies............................. 261
Traction Control System (TCS).................. 262
Enhanced Traction System (ETS).............. 263
StabiliTrak
®System................................... 265
Steering.................................................... 266
Off-Road Recovery.................................... 269
Passing..................................................... 269
Loss of Control.......................................... 271
Driving at Night......................................... 272Driving in Rain and on Wet Roads............ 274
City Driving............................................... 277
Freeway Driving........................................ 278
Before Leaving on a Long Trip.................. 279
Highway Hypnosis..................................... 280
Hill and Mountain Roads........................... 280
Winter Driving........................................... 282
If Your Vehicle is Stuck in Sand, Mud,
Ice, or Snow.......................................... 287
Rocking Your Vehicle to Get It Out........... 288
Loading Your Vehicle................................ 288
Towing........................................................ 293
Towing Your Vehicle ................................. 293
Recreational Vehicle Towing...................... 294
Towing a Trailer........................................ 296
Section 4 Driving Your Vehicle
253

Rocking Your Vehicle to Get It Out
First, turn the steering wheel left and right.
That will clear the area around the front wheels.
If your vehicle has a traction system, you
should turn your traction system off. SeeTraction
Control System (TCS) on page 262,Enhanced
Traction System (ETS) on page 263,or
StabiliTrak
®System on page 265. Then shift back
and forth between REVERSE (R) and a forward
gear, or with a manual transaxle, between
FIRST (1) or SECOND (2) and REVERSE (R),
spinning the wheels as little as possible. Release
the accelerator pedal while you shift, and press
lightly on the accelerator pedal when the transaxle
is in gear. By slowly spinning the wheels in the
forward and reverse directions, you will cause
a rocking motion that may free your vehicle. If that
does not get your vehicle out after a few tries, it
may need to be towed out. If your vehicle
does need to be towed out, seeTowing Your
Vehicle on page 293.
Loading Your Vehicle
It is very important to know how much weight your
vehicle can carry. This weight is called the vehicle
capacity weight and includes the weight of all
occupants, cargo and all nonfactory-installed
options. Two labels on your vehicle show how much
weight it may properly carry, the Tire and Loading
Information label and the Certication label.
{CAUTION:
Do not load your vehicle any heavier than
the Gross Vehicle Weight Rating (GVWR),
or either the maximum front or rear Gross
Axle Weight Rating (GAWR). If you do,
parts on your vehicle can break, and it
can change the way your vehicle handles.
These could cause you to lose control
and crash. Also, overloading can shorten
the life of your vehicle.
288