2007 PEUGEOT 607 engine

4
62

Make a careful note of the
number on each key. The
key number is coded on the
label attached to the key.

If the keys are lost, your PEUGEOT
dealer can rapidly supply you with
new keys.

The high frequency remote control is
a sensitive system; do not operate it
while it is in your pocket as there is a
possibility that it may unlock your ve-
hicle, without you being aware of it.

The remote control does not oper-
ate when the key is in the ignition,
even when the ignition is switched
off, except for reprogramming.

Do not operate the deadlocking
function if there is anyone inside
the vehicle.

Driving with the doors locked may
make access to the passenger com-
partment by the emergency services
more difi cult in an emergency.

As a safety precaution (with chil-
dren on board), remove the ignition
key when you leave the vehicle,
even for a short time.

Do not repeatedly press the button
of your remote control out of range
and out of sight of your vehicle.
You run the risk of stopping it from
working and the remote control
would have to be reprogrammed.
CONFIDENTIAL CARD
When purchasing a second-hand
vehicle:
- ensure that you are given the
coni dential card;
- have the key codes memorised
by a PEUGEOT dealer, to ensure
that the keys in your possession
are the only ones which can start
the vehicle.

Do not make any modii cations to
the electronic engine immobiliser
system.
This is given to you on delivery of your
vehicle with the duplicate keys.
It contains the identii cation code
necessary for any work carried out
by a PEUGEOT dealer on the elec-
tronic immobiliser system. This code
is hidden by a i lm, which should be
removed only if necessary.

Keep your card in a safe place,
never inside the vehicle.
When undertaking a long trip or
journey, however, it is advisable to
take it with you along with your per-
sonal papers.

4
69
Tailgate release
This enables the tailgate to be un-
locked in the event of a central locking
fault.
- Fold back the rear seats to gain access to the lock from inside the
boot,
- Insert a small screwdriver into hole
A of the lock to unlock the tailgate. FILLING WITH FUEL
Low fuel level
When the minimum fuel level
is reached, this warning light
comes on, accompanied by an
audible signal and a message
on the multifunction display.

You can can still drive approximate-
ly 30 miles (50 km) without i lling up
with fuel. Filling with fuel
Locking and unlocking of the fuel i ller
l ap, the doors and the boot is simul-
taneous.
The engine and the ignition must
be switched off when i lling with
fuel:

 Open the fuel i ller l ap by pressing
the front,

 Unscrew the cap and hook it over
the tab located on the inside of the
l ap.
When i lling up your tank, do not con-
tinue after the 3rd cut-off of the pump;
this could cause your vehicle to mal-
function.

The capacity of the tank is approxi-
mately 80 litres.

 After i lling the tank, screw the cap
on fully and close the fuel i ller
l ap.
Fuel i ller cap open When this light comes on,
accompanied by an audible
signal and/or a message
on the multifunction display,
screw the cap on again and
close the fuel i ller l ap.

4
69
Tailgate release
This enables the tailgate to be un-
locked in the event of a central locking
fault.
- Fold back the rear seats to gain access to the lock from inside the
boot,
- Insert a small screwdriver into hole
A of the lock to unlock the tailgate. FILLING WITH FUEL
Low fuel level
When the minimum fuel level
is reached, this warning light
comes on, accompanied by an
audible signal and a message
on the multifunction display.

You can can still drive approximate-
ly 30 miles (50 km) without i lling up
with fuel. Filling with fuel
Locking and unlocking of the fuel i ller
l ap, the doors and the boot is simul-
taneous.
The engine and the ignition must
be switched off when i lling with
fuel:

 Open the fuel i ller l ap by pressing
the front,

 Unscrew the cap and hook it over
the tab located on the inside of the
l ap.
When i lling up your tank, do not con-
tinue after the 3rd cut-off of the pump;
this could cause your vehicle to mal-
function.

The capacity of the tank is approxi-
mately 80 litres.

 After i lling the tank, screw the cap
on fully and close the fuel i ller
l ap.
Fuel i ller cap open When this light comes on,
accompanied by an audible
signal and/or a message
on the multifunction display,
screw the cap on again and
close the fuel i ller l ap.

7
81
The switch lights up and the
warning light comes on: the
ASR and ESP systems no
longer have any effect on the
engine operation.
TRACTION CONTROL (ASR)
AND DYNAMIC STABILITY
CONTROL (ESP)
These systems are linked and com-
plement the ABS.
The ASR system optimises drive to
prevent the wheels skidding, by act-
ing on the brakes of the drive wheels
and on the engine. It also allows the
directional stability of the vehicle to be
improved on acceleration.
If there is a variation between the
trajectory followed by the vehicle and
that required by the driver, the ESP sys-
tem automatically acts on the engine
and the brake of one or more wheels, in
order to put the vehicle back on course,
within the limits of the laws of physics.
Operation of the ASR and ESP
systems The warning light l ashes
when the ASR or ESP is ac-
tivated. Disarming
Reactivation:

 Automatic if the ignition is switched
off.

 Automatic from 30 mph (50 km/h).


Manual by pressing the switch again.
When a malfunction of the
systems occurs, the switch
light l ashes and the warn-
ing light comes on, accom-
panied by an audible signal
and a message on the multi-function
display.
Contact a PEUGEOT dealer to have
the system checked.
The ASR/ESP systems offer
exceptional safety in normal
driving, but this should not
encourage the driver to take
extra risks or drive at high speed.
The correct functioning of these sys-
tems depends on observation of the
manufacturer’s recommendations re-
garding the wheels (tyres and rims),
the braking components and the elec-
tronic components, as well as the
PEUGEOT assembly and operation
procedures.
After an impact, have the system
checked by a PEUGEOT dealer.
When the ignition is on, the
ASR and ESP systems are
always activated. Operating check
Activation of the ASR and ESP
systems In exceptional conditions (starting a
vehicle which is bogged down, stuck
in snow, on soft ground), it may be ad-
visable to disarm the ASR and ESP
systems, so that the wheels can move
freely and regain grip.

 Press the ESP OFF switch, located
under the steering wheel to the
left.

8
88
When the vehicle is being
driven, the respective illumi-
nation of these warning lights
on the instrument panel, ac-
companied by an audible
signal and a message on the
multifunction display, indicates that the handbrake is
still on or has not been properly released.
When parking on a slope, di-
rect your wheels towards the
pavement and pull the hand-
brake.
HANDBRAKE
Releasing
Pull on the handle and press the but-
ton to release the handbrake.
6-SPEED MANUAL GEARBOX
Starting the vehicle
Before starting your vehicle:
- ensure that the gear lever is in
neutral,
or
- if a gear is engaged, press the clutch pedal.
Applying
Pull the handbrake to immobilise your
vehicle.
Reverse
To change to reverse gear, lift the ring
under the gear lever knob and push the
gear lever to the left then to the front.

Reverse gear can only be engaged
when the vehicle is stationary with
the engine idling.
When the ignition is on with
the engine off, always select
neutral.
IGNITION SWITCH

1. Stop position.

2. Running position.

3. Starting position.
The RD4 audio equipment and
the RT4 GPS audio/telephone
can be switched on with the
ignition off for a combined du-
ration of approximately thirty
minutes.

8
89
"PORSCHE TIPTRONIC
SYSTEM" AUTOMATIC
GEARBOX
Gear selection gate

 Move the lever in the gate to select
a position.
The indicator light corresponding to
the position selected appears on the
instrument panel screen.

P ark: to immobilise the vehicle and to
start the engine, with the handbrake
on.

R everse: to reverse (select this posi-
tion with the vehicle stationary, engine
at idle).

N eutral: to start the engine and to park,
with the handbrake on.

Note: if position N is inadvertently en-
gaged while driving, allow the engine
to return to idle before engaging posi-
tion D then accelerate.

D rive: to drive in automatic mode.

M anual: to drive selecting the gears.

S : Sport program. Starting the engine

 with the handbrake on, select posi-
tion P or N in the gate,

 turn the ignition key.
Moving Off
With the engine running, from posi-
tion P :

 to exit position P, it is essential
to press the brake pedal,

 select position R , D or M , then
gradually release the pressure on
the brake pedal; the vehicle moves
off immediately.
To move off from position N :

 with your foot on the brake, release
the handbrake,

 select position R , D or M , then
gradually release the pressure on
the brake pedal; the vehicle moves
off immediately.
When the engine is at idle,
brakes not applied, if position

R , D or M is selected, the ve-
hicle moves even without the
accelerator being pressed.

Do not leave children unsupervised
inside the vehicle, with position
R, D or M selected, with the en-
gine running, as the vehicle moves
even without the accelerator being
pressed.
The six speed automatic gearbox of-
fers, as required, the comfort of the
automatic program, enhanced by a
manual selection suited to dynamic
driving conditions: Sport program.
Driving on a slippery road is detected
automatically.
However, manual selection is still pos-
sible using the gear lever.

8
93
Changing a memorised speed
To memorise a speed higher than the
previous one, there are two options:
Without using the accelerator:

 press button 3 ;
A brief press increases by 1 mph
(1 km/h).
A maintained press increases in steps
of 5 mph (5 km/h).
Using the accelerator:

 exceed the memorised speed until
the required speed is reached,

 press button 2 or 3 .
To memorise a speed lower than the
previous one:

 press button 2 ;
A brief press decreases by 1 mph
(1 km/h).
A maintained press decreases in steps
of 5 mph (5 km/h).
Reactivating the memorised speed
After cancellation, press button
4 . Your
vehicle will return to the last memo-
rised speed. The display indicates
(e.g. at 70 mph (110 km/h)): Cancelling the memorised speed

 When the vehicle is stationary, af-
ter the ignition has been switched
off, the system no longer stores
any speed.
Operating check
In the event of a cruise control malfunc-
tion, the memorised speed is erased,
the dashes l ash for a few seconds:
Do not use the cruise control
on slippery roads or in heavy
trafi c.
To prevent the mat from be-
coming caught under the pedals:
- ensure that the mat is positioned correctly,
- never i t one mat on top of another.
Contact a PEUGEOT dealer to have
the system checked.
This prevents the vehicle speed ex-
ceeding the speed programmed by
the driver (minimum speed of 18 mph
(30 km/h)).

The operations must be carried out:
- while stationary, with the engine
running,

or
- while the vehicle is moving.
Speed limiter function

8
93
Changing a memorised speed
To memorise a speed higher than the
previous one, there are two options:
Without using the accelerator:

 press button 3 ;
A brief press increases by 1 mph
(1 km/h).
A maintained press increases in steps
of 5 mph (5 km/h).
Using the accelerator:

 exceed the memorised speed until
the required speed is reached,

 press button 2 or 3 .
To memorise a speed lower than the
previous one:

 press button 2 ;
A brief press decreases by 1 mph
(1 km/h).
A maintained press decreases in steps
of 5 mph (5 km/h).
Reactivating the memorised speed
After cancellation, press button
4 . Your
vehicle will return to the last memo-
rised speed. The display indicates
(e.g. at 70 mph (110 km/h)): Cancelling the memorised speed

 When the vehicle is stationary, af-
ter the ignition has been switched
off, the system no longer stores
any speed.
Operating check
In the event of a cruise control malfunc-
tion, the memorised speed is erased,
the dashes l ash for a few seconds:
Do not use the cruise control
on slippery roads or in heavy
trafi c.
To prevent the mat from be-
coming caught under the pedals:
- ensure that the mat is positioned correctly,
- never i t one mat on top of another.
Contact a PEUGEOT dealer to have
the system checked.
This prevents the vehicle speed ex-
ceeding the speed programmed by
the driver (minimum speed of 18 mph
(30 km/h)).

The operations must be carried out:
- while stationary, with the engine
running,

or
- while the vehicle is moving.
Speed limiter function