WINDSHIELD WIPER/WASHER SWITCH
INSTRUMENT BRIGHTNESS CONTROL/TRIP CHANGE BUTTONHEADLIGHT AND TURN SIGNAL CONTROL
0102
03
STEERING WHEEL TILT
AD jUSTMENT*CRUISE CONTROL
STEERING WHEEL SWITCHES FOR AUDIO CONTROL
04
0506
AUDIO SYSTEM
HOOD
RELEASE*
0708
02
05
09
03
01
12
04
11
10
08
14
06
07
*See your Owner’s Manual for more information.
FRONT-PASSENGER AIRBAG STATUS LIGHT
10
E-LOCK SWITCH
11
HILL DESCENT CONTROL SWITCH
12
AUXILIARY AUDIO
INPUT jACK *
13
FOUR-WHEEL
DRIvE (4WD) SWITCH
14
13
CLIMATE CONTROLS
09
WINDSHIELD WIPER/WASHER SWITCH
The ignition switch must be in the ON position
to activate the windshield wipers.
Move the lever to the following positions to
operate the windshield wipers:
1A Intermittent (INT) – Front wipers operate
intermittently and can be further adjusted
by twisting the time control ring 1B.
02 Low Speed (LO) – Continuous low-speed
operation of front wipers.
03 High Speed (HI) – Continuous high-speed
operation of front wipers.
04 Mist (MIST) – Lift the lever up for one sweep of the front wipers.
05 Rear Wipers (REAR) – Twist the end section to operate the first (INT)
or second (ON) speed settings for the rear wipers.
The washer function activates the washer fluid and several sweeps of the wipers:
• For F
RONT WASHER, pull lever toward you.
• F
or REAR WASHER, push lever away from you.
HEADLIGHT AND TURN SIGNAL CONTROL
HEADLIGHT SWITCH
Turn the headlight switch to the position to turn
on the front parking, tail, license plate and instrument
panel lights.
Turn the headlight switch to the position to turn on
the headlights. All other lights remain on.
HIGH BEAM
Push the headlight switch forward to select the high beam function. The blue indicator light illuminates. Pull the headlight switch back to the original position to
select the low beam. The blue indicator light goes off.
Pull and release the headlight switch to flash the headlight high beams on and off.
TURN SIGNAL SWITCH
Move the headlight control switch up or down to signal the turning direction. When
the turn is completed, the turn signals cancel automatically.
To signal a lane change, move the headlight control switch up or down to the point
where the indicator light begins to flash, but the headlight control switch does not
latch.
FOG LIGHT OPERATION (if so equipped)
Note: The headlights must be on and the low beams selected for the fog lights to operate.
Turn the switch to the position to turn on the fog lights.
Turn the switch to the OFF position to turn off the fog lights.
1A
02
03
04
1B05
