Push the switch 02 forward to move the seatback forward; push it back to move the seatback backward.
LUMBAR SUPPORT (if so equipped) Your driver’s seat has a lumbar support; adjust it by moving the lever
03 up or down.
03
folding the 3rd row seats
Pull up on the latches 01 located in the outer corners of each seatback and fold the seatbacks forward over the seat base.
To return the 3rd row seats to a seating position use the pull straps 02 to raise each seatback. Pull back until the seatback latches into position.
Make sure to properly raise each seatback to an upright and
secured position.
folding the 2nd row Bench seat
To fold the 2nd row bench seat flat for maximum cargo hauling:
Lower the head restraint to the “down” position.
Pull the strap 01 located in the center of the seat cushion toward the front of the vehicle. Lift up on the recline lever 02 to fold the seatback forward.
Fold the carpet panel flap 03 toward the back of the vehicle. (The carpet panel flap provides a level cargo floor when the 3rd row seats are also folded flat.)
Reverse this process to return the 2nd row bench seats to a seating position.
Make sure to properly raise the seatback to an upright position and push the seat cushion down into place.
01
02
03
01
02
ti P uP for eas Y entr Y or exit fro M the 3rd
row
The 2nd row outboard seats can be tipped forward for easy entry or exit from the 3rd row bench seat.
To enter the 3rd row, lift up on the latch located on the upper corner of the seatback 01 on the back of the 2nd row outboard seats.
This will then release the back of the seat and tip the 2nd row outboard seat forward. 02
To exit the 3rd row bench seat, lift up on the same latch and tip the seatback forward.
01
02
