2007 NISSAN ARMADA engine oil

[x] Cancel search: engine oil

Page 263 of 344

NISSAN ARMADA 2007 1.G Owners Manual 8 Maintenance and do-it-yourself
Maintenance requirements..........................8-2
General maintenance..............................8-2
Explanation of general maintenance items.........8-2
Mainten

Page 266 of 344

NISSAN ARMADA 2007 1.G Owners Manual Windshield defrosterCheck that the air
comes out of the defroster outlets properly and in
sufficient quantity when operating the heater or
air conditioner.
Under the hood and vehicle
The maintenance i

Page 267 of 344

NISSAN ARMADA 2007 1.G Owners Manual When performing any inspection or maintenance
work on your vehicle, always take care to prevent
serious accidental injury to yourself or damage to
the vehicle. The following are general precau-
tions

Page 268 of 344

NISSAN ARMADA 2007 1.G Owners Manual 1. Battery
2. Fuse/fusible link box
3. Transmission dipstick
4. Engine oil filler cap
5. Brake fluid reservoir
6. Windshield washer fluid reservoir
7. Air cleaner
8. Drive belt location
9. Radiator ca

Page 270 of 344

NISSAN ARMADA 2007 1.G Owners Manual If the cooling system frequently requires
coolant, have it checked by a NISSAN
dealer.
CHANGING ENGINE COOLANT
A NISSAN dealer can change the engine coolant.
The service procedure can be found in the

Page 271 of 344

NISSAN ARMADA 2007 1.G Owners Manual 5. Remove the dipstick again and check the oil
level. It should be between the H (High) and
L (Low) marks
sB. This is the normal oper-
ating oil level range. If the oil level is below
the L (Low) mark

Page 272 of 344

NISSAN ARMADA 2007 1.G Owners Manual If the oil filter is to be changed, remove and
replace it at this time. See “Changing engine
oil filter” later in this section.
WARNING
cProlonged and repeated contact with
used engine oil may cau

Page 273 of 344

NISSAN ARMADA 2007 1.G Owners Manual 5. Wipe the engine oil filter sealing surface with
a clean rag.
Be sure to remove any old gasket material
remaining on the sealing surface of the en-
gine.
6. Coat the gasket on the new filter with cl
Page:   < prev 1-8 9-16 17-24 25-32 33-40 next >