2007 NISSAN ALTIMA engine

[x] Cancel search: engine

Page 97 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual Be sure you do not put anything on top of
the autolight sensor
s1located on the top
side of the instrument panel. The autolight
sensor controls the autolight; if it is cov-
ered, the autolight sensor

Page 100 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual cTurn signals do not work when the haz-
ard warning flasher lights are on.
The flashers will operate with the ignition switch
in any position.
Some state laws may prohibit the use of
the hazard warnin

Page 101 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual 3. When the seat is warmed or before you
leave the vehicle, be sure to turn the switch
off.
CAUTION
cDo not use the seat heater for extended
periods or when no one is using the
seat.
cDo not put anyth

Page 102 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual The vehicle should be driven with the Vehicle
Dynamic Control (VDC) system on for most driv-
ing conditions.
If the vehicle is stuck in mud or snow, the VDC
system reduces the engine output to reduce

Page 113 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual 5. Within 5 seconds of completing step 4,
press and continuously hold. After a
delay of 5 seconds, the panel will move from
the tilt position to the open position and back
to the close position.
6. Re

Page 114 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual To turn the map lights on, press the light lens. To
turn them off, press the lens again.
CAUTION
Do not use for extended periods of time
with the engine stopped. This could result
in a discharged batt

Page 115 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual The HomeLinkTUniversal Transceiver provides a
convenient way to consolidate the functions of up
to three individual hand-held transmitters into
one built-in device.
HomeLinkTUniversal Transceiver:
cWi

Page 124 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual WARNING
Radio waves could adversely affect elec-
tric medical equipment. Those who use a
pacemaker should contact the electric
medical equipment manufacturer for the
possible influences before use.
Th