2007 NISSAN 350Z belt

ATC-1
AUTOMATIC AIR CONDITIONER
J AIR CONDITIONER
CONTENTS
C
D
E
F
G
H
I
K
L
M
SECTION AT C
A
B
AT C
Revision: 2006 November2007 350Z
AUTOMATIC AIR CONDITIONER
PRECAUTIONS .......................................................... 4
Precautions for Supplemental Restraint System
(SRS) “AIR BAG” and “SEAT BELT PRE-TEN-
SIONER” .................................................................. 4
Precautions for Battery Service ................................ 4
Precautions for Procedures without Cowl Top Cover ..... 4
Precautions for Working with HFC-134a (R-134a) ..... 5
CONTAMINATED REFRIGERANT ....................... 5
General Refrigerant Precautions .............................. 6
Precautions for Refrigerant Connection ................... 7
ABOUT ONE-TOUCH JOINT ................................ 7
FEATURES OF NEW TYPE REFRIGERANT
CONNECTION ...................................................... 9
O-RING AND REFRIGERANT CONNECTION ... 10
Precautions for Servicing Compressor ................... 12
Precautions for Service Equipment ........................ 12
RECOVERY/RECYCLING EQUIPMENT ............ 12
ELECTRICAL LEAK DETECTOR ....................... 12
VACUUM PUMP ................................................. 12
MANIFOLD GAUGE SET .................................... 12
SERVICE HOSES ............................................... 13
SERVICE COUPLERS ........................................ 13
REFRIGERANT WEIGHT SCALE ...................... 13
CHARGING CYLINDER ...................................... 13
Precautions for Leak Detection Dye ....................... 14
IDENTIFICATION ................................................ 14
IDENTIFICATION LABEL FOR VEHICLE ........... 14
PREPARATION ......................................................... 15
Special Service Tools ............................................. 15
HFC-134a (R-134a) Service Tools and Equipment ... 16
Commercial Service Tools ...................................... 18
REFRIGERATION SYSTEM ..................................... 19
Refrigerant Cycle ................................................... 19
REFRIGERANT FLOW ....................................... 19
FREEZE PROTECTION ..................................... 19
Refrigerant System Protection ............................... 19
REFRIGERANT PRESSURE SENSOR ............. 19
PRESSURE RELIEF VALVE ............................... 19
Component Layout ................................................. 20LUBRICANT .............................................................. 21
Maintenance of Lubricant Quantity in Compressor ... 21
LUBRICANT ........................................................ 21
LUBRICANT RETURN OPERATION .................. 21
LUBRICANT ADJUSTING PROCEDURE FOR
COMPONENTS REPLACEMENT EXCEPT
COMPRESSOR .................................................. 22
LUBRICANT ADJUSTING PROCEDURE FOR
COMPRESSOR REPLACEMENT ....................... 23
AIR CONDITIONER CONTROL ............................... 24
Description of Air Conditioner LAN Control System ... 24
System Construction .............................................. 24
OPERATION ........................................................ 25
TRANSMISSION DATA AND TRANSMISSION
ORDER ............................................................... 25
AIR MIX DOOR CONTROL (AUTOMATIC TEM-
PERATURE CONTROL) ..................................... 26
FAN SPEED CONTROL ...................................... 26
INTAKE DOOR CONTROL ................................. 26
MODE DOOR CONTROL ................................... 26
MAGNET CLUTCH CONTROL ........................... 27
SELF-DIAGNOSIS SYSTEM .............................. 27
Description of Control System ................................ 28
Control Operation ................................................... 29
MODE CONTROL DIAL ...................................... 29
TEMPERATURE CONTROL DIAL (POTENTIO
TEMPERATURE CONTROL) .............................. 29
FAN CONTROL DIAL .......................................... 29
REAR WINDOW DEFOGGER SWITCH ............. 29
INTAKE SWITCH ................................................. 29
A/C SWITCH ....................................................... 29
Discharge Air Flow ................................................. 30
System Description ................................................. 31
SWITCHES AND THEIR CONTROL FUNCTION ... 31
CAN Communication System Description .............. 32
TROUBLE DIAGNOSIS ............................................ 33
CONSULT-III Function (BCM) ................................ 33
DATA MONITOR ................................................. 33
How to Perform Trouble Diagnosis for Quick and
Accurate Repair ...................................................... 34

ATC-3
C
D
E
F
G
H
I
K
L
MA
B
AT C
Revision: 2006 November2007 350Z SUNLOAD SENSOR .............................................. 106
Removal and Installation ...................................... 106
REMOVAL ......................................................... 106
INSTALLATION ................................................. 106
INTAKE SENSOR ................................................... 107
Removal and Installation ...................................... 107
REMOVAL ......................................................... 107
INSTALLATION ................................................. 107
BLOWER UNIT ....................................................... 108
Removal and Installation ...................................... 108
REMOVAL ......................................................... 108
INSTALLATION ................................................. 108
Disassembly and Assembly ................................. 109
BLOWER MOTOR ...................................................110
Removal and Installation ....................................... 110
REMOVAL .......................................................... 110
INSTALLATION .................................................. 110
INTAKE DOOR MOTOR .......................................... 111
Removal and Installation ...................................... . 111
REMOVAL ......................................................... . 111
INSTALLATION ................................................. . 111
HEATER & COOLING UNIT ASSEMBLY ...............112
Removal and Installation ....................................... 112
REMOVAL .......................................................... 112
INSTALLATION .................................................. 113
Disassembly and Assembly .................................. 114
MODE DOOR MOTOR ............................................116
Removal and Installation ....................................... 116
REMOVAL .......................................................... 116
INSTALLATION .................................................. 116
AIR MIX DOOR MOTOR ..........................................117
Removal and Installation ....................................... 117
REMOVAL .......................................................... 117
INSTALLATION .................................................. 117
HEATER CORE .......................................................118
Removal and Installation ....................................... 118
REMOVAL .......................................................... 118
INSTALLATION .................................................. 118
DUCTS AND GRILLES ...........................................119
Removal and Installation ....................................... 119
COMPONENT LAYOUT ..................................... 119
REMOVAL .......................................................... 119
INSTALLATION ................................................. 122
REFRIGERANT LINES ........................................... 123
HFC-134a (R-134a) Service Procedure ............... 123
SETTING OF SERVICE TOOLS AND EQUIP-
MENT ................................................................ 123
Components ......................................................... 125
Removal and Installation of Compressor ............. 125REMOVAL .........................................................125
INSTALLATION .................................................126
Check Disc to Pulley Clearance ...........................126
Removal and Installation of Low-pressure Flexible
Hose and Pipe 2 ...................................................127
REMOVAL .........................................................127
INSTALLATION .................................................128
Removal and Installation of High-pressure Flexible
Hose .....................................................................128
REMOVAL .........................................................128
INSTALLATION .................................................129
Removal and Installation of High-pressure Pipe 1
(Engine Compartment) .........................................130
REMOVAL .........................................................130
INSTALLATION .................................................130
Removal and Installation of Low-pressure Pipe 1
and High-pressure Pipe 2 .....................................131
REMOVAL .........................................................131
INSTALLATION .................................................132
Removal and Installation of Liquid Tank ...............132
REMOVAL .........................................................132
INSTALLATION .................................................133
Removal and Installation of Condenser ................133
REMOVAL .........................................................133
INSTALLATION .................................................134
Removal and Installation of Refrigerant Pressure
Sensor ..................................................................135
REMOVAL .........................................................135
INSTALLATION .................................................135
Removal and Installation of Evaporator ................135
REMOVAL .........................................................135
INSTALLATION .................................................135
Removal and Installation of Expansion Valve .......137
REMOVAL .........................................................137
INSTALLATION .................................................137
Checking for Refrigerant Leaks ............................138
Checking System for Leaks Using the Fluorescent
Leak Detector .......................................................138
Dye Injection .........................................................138
Electrical Leak Detector ........................................139
PRECAUTIONS FOR HANDLING LEAK
DETECTOR .......................................................139
CHECKING PROCEDURE ...............................140
SERVICE DATA AND SPECIFICATIONS (SDS) ....142
Compressor ..........................................................142
Lubricant ...............................................................142
Refrigerant ............................................................142
Engine Idling Speed .............................................142
Belt Tension ..........................................................142

ATC-4
PRECAUTIONS
Revision: 2006 November2007 350Z
PRECAUTIONSPFP:00001
Precautions for Supplemental Restraint System (SRS) “AIR BAG” and “SEAT
BELT PRE-TENSIONER”
NJS000D2
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRS and SB section of this Service Man-
ual.
WARNING:

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.

Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.

Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.
Precautions for Battery ServiceNJS000D3
Before disconnecting the battery, lower both the driver and passenger windows. This will prevent any interfer-
ence between the window edge and the vehicle when the door is opened/closed. During normal operation, the
window slightly raises and lowers automatically to prevent any window to vehicle interference. The automatic
window function will not work with the battery disconnected.
Precautions for Procedures without Cowl Top CoverNJS000CP
When performing the procedure after removing cowl top cover, cover
the lower end of windshield with urethane, etc.
PIIB3706J

ATC-82
TROUBLE DIAGNOSIS
Revision: 2006 November2007 350Z
*1ATC-46, "FUNCTION CONFIRMA-
TION PROCEDURE", see No. 1.*2AT C - 6 3 , "
Air Mix Door Motor Circuit"*3AT C - 8 5 , "Test Reading"
*4ATC-50, "AUXILIARY MECHA-
NISM: TEMPERATURE SETTING
TRIMMER"
*5AT C - 4 6 , "FUNCTION CONFIRMA-
TION PROCEDURE", see No. 9.*6AT C - 5 6 , "
LAN System Circuit"
*7ATC-69, "Blower Motor Circuit"*8AT C - 7 4 , "Magnet Clutch Circuit"*9AT C - 8 3 , "PERFORMANCE TEST
DIAGNOSIS"
*10ATC-53, "Operational Check"*11AT C - 4 6 , "FUNCTION CONFIRMA-
TION PROCEDURE", see No. 5 to
7.*12AT C - 5 , "
CONTAMINATED REFRIG-
ERANT"
*13EM-12, "Checking Drive Belts"*14EC-543, "SYSTEM DESCRIPTION"

ATC-84
TROUBLE DIAGNOSIS
Revision: 2006 November2007 350Z
*1ATC-125, "Removal and Installation
of Compressor"
*2ATC-69, "Blower Motor Circuit"*3EM-12, "Checking Drive Belts"
SJIA1642E

ATC-90
TROUBLE DIAGNOSIS
Revision: 2006 November2007 350Z
NoiseNJS00018
SYMPTOM: Noise
INSPECTION FLOW
*1ATC-53, "Operational Check"*2ATC-126, "Check Disc to Pulley
Clearance"
*3AT C - 2 1 , "Maintenance of Lubricant
Quantity in Compressor"
*4EM-12, "Checking Drive Belts"
SJIA0843E

ATC-126
REFRIGERANT LINES
Revision: 2006 November2007 350Z
3. Remove engine cover (1), (2). Refer to EM-17, "INTAKE MANIFOLD COLLECTOR" .
4. Remove air cleaner case (LH) and air duct (LH). Refer to EM-15, "
AIR CLEANER AND AIR DUCT" .
5. Remove mounting nuts (A) from low-pressure flexible hose (1).
6. Remove mounting nuts (B) from high-pressure flexible hose (2).
CAUTION:
Cap or wrap the joint of compressor, low-pressure flexible
hose and high-pressure flexible hose with suitable material
such as vinyl tape to avoid the entry of air.
7. Disconnect compressor connector (C).
8. Remove drive belt. Refer to EM-12, "
DRIVE BELTS" .
9. Remove mounting bolts (A) from compressor, using power tools.
10. Remove compressor (1) upward of vehicle.
INSTALLATION
Installation is basically the reverse order of removal.
CAUTION:

Replace O-rings of low-pressure flexible hose and high-pressure flexible hose with new ones, and
then apply compressor oil to it when installing it.

When recharging refrigerant, check for leaks.
Check Disc to Pulley ClearanceNJS000IE
Check the clearance (B) between pulley assembly (1) and clutch
disc (2) around the entire periphery with feeler gauge (A).
If specified clearance is not obtained, replace compressor.
PJIA0178E
PJIA0179E
Disc to pulley
clearance: 0.30 - 0.60 mm (0.012 - 0.024 in)
SJIA1918E

ATC-142
SERVICE DATA AND SPECIFICATIONS (SDS)
Revision: 2006 November2007 350Z
SERVICE DATA AND SPECIFICATIONS (SDS)PFP:00030
CompressorNJS0002B
LubricantNJS0002C
RefrigerantNJS0002D
Engine Idling SpeedNJS0002E
Refer to EC-718, "Idle Speed and Ignition Timing" .
Belt TensionNJS0002F
Refer to EM-12, "DRIVE BELTS" .
ModelVALEO THERMAL SYSTEMS JAPAN make
DCS-17IC
Ty p eVariable displacement swash plate
Displacement
cm
3 (cu in)/revMax. 171 (10.4)
Cylinder bore × stroke
mm (in)32 (1.26) × 30.5 (1.20)
Direction of rotationClockwise (viewed from drive end)
Drive beltPoly V
ModelVALEO THERMAL SYSTEMS JAPAN make
DCS-17IC
NameNissan A/C System Oil Type S (DH-PS)
Capacity
m (US fl oz, lmp fl oz)Total in system 150 (5.07, 5.3)
Compressor (Service part) charging amount 150 (5.07, 5.3)
Ty p eHFC-134a (R-134a)
Capacity
kg (lb)0.55 (1.21)