2007 MERCEDES-BENZ SLR buttons

162 Controls in detail
Audio system
Telephone operationVarious car telephone functions and oper-
ating steps for the car telephone can be
performed and displayed via the audio
system.
Further operating instructions not covered
here can be found in the operating
instructions for the multifunction steering
wheel and the telephone.
Switching on the telephone
Pressh button.
If you have programmed an unlock
code for the telephone, you must enter
the code now.
Enter the code using buttons4
toM.
If necessary, correct number entered
with the
CLR key. Press key briefly to
delete the last digit entered; press key
and hold to delete the complete
number.
Press theOK key after entering correct
code.
The telephone is unlocked. If you have
entered the wrong code, you must re-
peat the entering procedure with the
correct code.
Switching off the telephone
Pressh button repeatedly until
PHONE OFF appears in the display.
The receiving symbol in the display
disappears.
Adjusting the volume
Turn control knoba during tele-
phone operation.
The volume increases or decreases de-
pending on the direction in which the
knob is turned.
Warning!G
Please do not forget that your primary re-
sponsibility is to drive the vehicle. A driver’s
attention to the road must always be
his/her primary focus when driving. For
your safety and the safety of others, we rec-
ommend that you pull over to a safe location
and stop before placing or taking a
telephone call.
If you choose to use the telephone
1 while
driving, please use the hands-free device
and only use the telephone when road,
weather and traffic conditions permit. Some
jurisdictions prohibit the driver from using a
mobile telephone while driving a vehicle.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.
1Observe all legal requirements.
iThe volume can be adjusted separately for
the telephone and radio.

163 Controls in detail
Audio system
Placing a call
Entering a telephone number and
starting the dialing process
Enter the desired telephone number
using buttons4 toM.
The number can have up to 32 digits,
but only 13 of these are visible on the
display.
If necessary, correct number entered with
the
CLR key.
Press key briefly to delete the last digit
entered.
Press key and hold to delete the
complete number.
After correct telephone number has
been entered, press the
SND key.Phone book
The numbers stored in the phone book can
be called up either by name or number.
Calling up the phone book
Pressd, c, f or
ebutton.
Switching between name search and
number search
Press theABC key.
The name search is called up.
or
Press theNUM key.
The number search is called up.Searching and calling up phone book
entries by name
Press theABC key.
The current name is highlighted on the
display.
Press either thed or cbutton.
The stored entries are selected accord-
ing to the alphabetical order of the
initial letter.
or
Press either thef or ebutton.
The stored entries are selected in
increments of four.
or


165 Controls in detail
Audio system
Manual repeat dialing (redial)
Press theSND key.
The last number dialed is shown in the
display.
Select the desired telephone number
usingd, c, f or
ebutton.
The abbreviation
L and the number of
the entry are shown in the top line of
the display.
When you have selected a number,
press the
SND key.
The call will be made.Automatic repeat dialing (redial)
If a call cannot be connected, press
the
SND key.
REDIAL will appear in the display and re-
peated attempts to place the call will be
made for the next 4 minutes.
Selecting numbers directly from the
directory
Enter previously selected 3-digit
(1-999) number of the entry using
number keys4 toM.
Press theRCL key.
The telephone number stored under
that entry will be dialed.
Press theSND key.
The call will be made.Speed dialing
Input desired entry number using
number keys4 toM.
A maximum of two digits can be en-
tered.
If necessary, correct the last number
entered with the
CLR key.
Press theSND key.
The telephone number stored under
that entry will be dialed. The number,
L
and the full entry number will be shown
in the display.
Quick-dialing
Press one of the desired number
buttons4 toM longer than
1 second.
The telephone number saved under
that number will be dialed.
!Please be aware that button4 might al-
ready be reserved for an emergency call number.

173 Controls in detail
Automatic transmission
Driving tips
Accelerator position
Your driving style influences the
transmission’s shifting behavior:
Less throttle Earlier upshifting
More throttle Later upshifting
Kickdown
Use kickdown when you want maximum
acceleration.
Press the accelerator past the point of
resistance.
Depending on the engine speed the
transmission shifts into a lower gear.
Ease on the accelerator when you have
reached the desired speed.
The transmission shifts up again.Stopping
When you stop briefly, e.g. at traffic lights:
Leave the transmission in gear.
Hold the vehicle with the brake.
When you stop longer with the engine
idling and/or on a hill:
Set the parking brake.
Move the gear selector lever to park
positionP.Maneuvering
When you maneuver in tight areas,
e.g. when pulling into a parking space:
Control the vehicle speed by gradually
releasing the brakes.
Accelerate gently.
Never abruptly step on the accelerator.
Working on the vehicle
iKickdown in manual shift program MAN is
not possible.
In kickdown operation, it is not possible to
change gear with the steering wheel gear shift
buttons.
Warning!G
When working on the vehicle, set the
parking brake and move gear selector lever
to positionP. Otherwise the vehicle could
roll away.

174 Controls in detail
Automatic transmission
Gear ranges
With the gear selector lever in drive
positionD and driving in shift programC
orS, you can select a gear range for the
automatic transmission to operate within.
Gear selector lever (
page 175):
You can limit the gear range by pressing
the gear selector lever to the left (D-), and
reverse the gear range limit by pressing
the gear selector lever to the right (D+).
Steering wheel gearshift buttons/paddles
(
page 177):
You can limit the gear range by pressing
the left gearshift button or pulling the left
gearshift paddle, and reverse the gear
range limit by pressing the right gearshift
button or pulling the right gearshift paddle.The selected gear range appears in the
right multifunction display (
page 117).
iIf, when driving in shift programC and S the
maximum engine speed for the gear range has
been reached, the transmission shifts up auto-
matically, even if the gear range is restricted. In
shift program MAN the transmission will not
shift up automatically.
Effect
éThe transmission shifts through
fourth gear only.
èThe transmission shifts through
third gear only.
With this selection you can use the
braking effect of the engine.
Effect
çThe transmission shifts through
second gear only.
Allows the use of engine’s braking
power when driving:

on steep downgrades

in mountainous regions

under extreme operating
conditions
æThe transmission operates in the
first gear only.
For maximum use of engine’s
braking effect on very steep or
lengthy downgrades.

177 Controls in detail
Automatic transmission
Steering wheel gearshift control
one-touch gearshifting
With the gear selector lever in drive posi-
tion D and driving in shift programC orS,
you can limit or extend the gear range.
With the MAN shift program activated, you
can use the steering wheel gearshift con-
trol to manually shift the gears.The steering wheel gearshift buttons/pad-
dles are located on the left and right side
of the steering wheel.
Steering wheel gearshift buttons
1Left shift button: limiting gear range or
downshift (in shift programMAN)
2Right shift button: extending gear
range or upshift (in shift programMAN)
Steering wheel gearshift paddles (only
Mercedes-Benz SLR McLaren 722 Edition)
1Left shift paddle: limiting gear range or
downshift (in shift programMAN)
2Right shift paddle: extending gear
range or upshift (in shift programMAN)
The following instructions describe opera-
tion of the gear selector lever when driving
in the shift programC orS.
iFor information on using the steering wheel
gearshift control in shift program MAN, see
“Manual shift program” (
page 179).
!Allow engine to warm up under low load use.
Do not place full load on the engine until the
operating temperature has been reached.
Shift into reverse gearR or park positionP only
when the vehicle is stopped.
Avoid spinning of a drive wheel for an extended
period when driving off on slippery road
surfaces. This may cause serious damage to the
drivetrain which is not covered by the
Mercedes-Benz Limited Warranty.
iYou cannot shift with the steering wheel
gearshift buttons/paddles when the gear selec-
tor lever is in positionP,N orR.

194 Controls in detail
Automatic climate control
Front defroster
You can use this setting to defrost the
windshield, for example if it is iced up.
You can also defog the windshield and the
side windows.
Activating
Press button P (page 188).
The indicator lamp on the button
comes on.
The air conditioning switches to the
following functions automatically:

cooling on to dehumidify

maximum blower speed and
heating power

air flows onto the windshield
and the front side windows

the air recirculation mode is
switched offDeactivating
Press button P (page 188).
The indicator lamp on the button goes
out. Defrosting is turned off.
The previous settings are in effect
again.Windshield fogged on the outside
Switch the windshield wipers on
(
page 52).
If the automatic air distribution and air
volume are switched off:
Turn air distribution controls1 and 5
(
page 188) to position h ork.
or
Press control buttons 1, 5 and 9
(
page 188).
The control buttons are engaged.
TheU symbol on the control
buttons come on. Air distribution and
air volume are adjusted automatically.
iKeep this setting selected only until the
windshield or the side windows are clear again.
iThe cooling remains switched on.
iKeep this setting selected only until the
windshield is clear again.

210 Controls in detail
Useful features
Radio transmitters, such as a portable tele-
phone or a citizens band unit, should only
be used inside the vehicle if they are con-
nected to an antenna that is installed on
the outside of the vehicle.
The external antenna must be approved by
Mercedes-Benz. Please contact an autho-
rized Mercedes-Benz Center for informa-
tion on the installation of an approved
external antenna. Refer to the radio trans-
mitter operation instructions regarding use
of an external antenna.You can take and place telephone calls
using the í and ì buttons on the
steering wheel. To carry out other tele-
phone functions, use the control system
(
page 141).
See separate instruction manual for
instructions on how to operate the
telephone.
Warning!G
Please do not forget that your primary re-
sponsibility is to drive the vehicle. A driver’s
attention to the road must always be
his/her primary focus when driving. For
your safety and the safety of others, we rec-
ommend that you pull over to a safe location
and stop before placing or taking a
telephone call.
If you choose to use the telephone
1 while
driving, please use the hands-free device
and only use the telephone when road,
weather and traffic conditions permit. Some
jurisdictions prohibit the driver from using a
mobile telephone while driving a vehicle.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.
1Observe all legal requirements.
iFor additional information on operating the
telephone using the audio system head unit, see
“Telephone operation” (
page 162).
iStandard Mercedes-Benz mobile phone
design shown, SLR phone design may vary.