2007 MERCEDES-BENZ S550 Manual shift

344 Controls in detailLighting
Turn the exterior lamp switch to *.
With the SmartKey in starter switch po-
sition 1 or the KEYLESS-GO*
start/stop button pressed once, only
the parking lamps will switch on and off
automatically.
When the engine is running, the low
beam headlamps, the tail and parking
lamps, the license plate lamps, and the
side marker lamps will switch on and
off automatically.Daytime running lamp mode

Turn exterior lamp switch to
positionM or*.
When the engine is running, the low
beam headlamps are switched on. In
low ambient light conditions, the fol-
lowing lamps will switch on additional-
ly:

tail and parking lamps


license plate lamps


side marker lamps
For nighttime driving you should turn the
exterior lamp switch to positionB to
permit activation of the high beam head-
lamps.
Canada only
The daytime running lamp mode is manda-
tory and therefore in a constant mode.
When the engine is running, and you shift
from a driving position to positionN orP,
the low beam headlamps will switch off
with a 3-minute delay.When the engine is running, and you


turn the exterior lamp switch to
positionC, the parking lamps
switch on additionally.


turn the exterior lamp switch to
positionB, the manual headlamp
mode has priority over the daytime run-
ning lamp mode.
The corresponding exterior lamps
switch on (
page 622).
USA only
By default, the daytime running lamp mode
is deactivated. Activate the daytime run-
ning lamp mode using the control system,
see “Daytime driving lamps mode on/off
(USA only)” (
page 255).
When the engine is running, and you turn
the exterior lamp switch to position C
orB, the manual headlamp mode has
priority over the daytime running lamp
mode.
The corresponding exterior lamps switch
on (
page 622).
i
The front fog lamps and rear fog lamp can-
not be switched on manually with exterior lamp
switch in position*. To activate the fog
lamps, turn exterior lamp switch to
positionB and pull the exterior lamp switch
to first or second stop (
page 345).

364 Controls in detailDriving and parkingElectric parking brake
1Handle for electric parking brake
Manually releasing electric parking
brake

Pull handle1.
The red indicator lamp 0 (USA only)
or ! (Canada only) in the instru-
ment cluster goes out.
You cannot release the electric parking
brake until the ignition is switched on.Automatically releasing electric parking
brake
Your vehicle’s electric parking brake is au-
tomatically released when:


The engine is running.


Transmission is in position D or R.


The hood is closed.


You have fastened your seat belt.


You step on the accelerator pedal.
If gear R is engaged, the trunk must be
closed.
Warning!
G
Do not leave children unattended in the ve-
hicle, or with access to an unlocked vehicle.
Children could release the parking brake
and/or shift the automatic transmission out
of position P, either of which could result in
an accident and/or serious personal injury.Warning!
G
Getting out of your vehicle with the automat-
ic transmission not fully engaged in
positionPis dangerous. Also, when parked
on an incline, position P alone may not pre-
vent your vehicle from moving, possibly hit-
ting people or objects.
Always set the parking brake in addition to
shifting to position P (
page 359).
i
If you have not fastened your seat belt, the
following conditions must be met in order for the
parking brake to be automatically released:


The driver's door is closed


You must move the gear selector out of P po-
sition or drive faster than 2 mph (3 km/h).

369 Controls in detail
Automatic transmission

With the vehicle at a standstill, depress
the brake pedal and keep it pressed.

Press the handle for electric parking
brake (
page 364).

Press button at the end of the gear
selector lever in direction of arrow
(page 367) to select park positionP.

Release the brake pedal.
Shifting from D or R to N
If you want to select neutral positionN
with the automatic transmission being in
drive positionD or reverse gearR:

With the vehicle at a standstill, depress
the brake pedal and keep it pressed.

Press the handle for electric parking
brake (
page 364).

Move gear selector lever up to resis-
tance point when in drive position D or
down to resistance point when in
reverse gear R to select neutral
positionN.

Release the brake pedal.
Shifting procedure
The automatic transmission selects indi-
vidual gears automatically, depending on:

drive positionD(
page 370) with
gear ranges (
page 372)


the selected program mode (C/S)
(page 374)


the position of the accelerator pedal
(page 373)


the vehicle speed
With drive positionD selected, you can use
the steering wheel gearshift control
buttons (
page 375) to influence auto-
matic transmission shifting by:


limiting the gear range


changing gears manually
!
Shift the automatic transmission directly
from drive positionD to reverse gearR, from
reverse gearR to drive positionD or directly to
park positionP only when the vehicle is stopped.
Otherwise the automatic transmission could be
damaged.
When trying to free a vehicle stuck in mud or
snow, see “Rocking the vehicle” (
page 373).
i
When the vehicle needs to be moved with
the engine switched off and the automatic trans-
mission set to neutral positionN (
page 371),
e.g. in an automatic car wash, do not press the
handle for electric parking brake.
!
Allow engine to warm up under low load use.
Do not place full load on the engine until the op-
erating temperature has been reached.
Shift into reverse gearR or parking positionP
only when the vehicle is stopped.
Avoid spinning of a drive wheel for an extended
period when driving off on slippery road surfac-
es. This may cause serious damage to the driv-
etrain which is not covered by the
Mercedes-Benz Limited Warranty.

562 Practical hintsWhat to do if …?Display
Possible cause/consequence
Possible solution
Door Open
Vehicle not in Park
You have opened the driver’s
door and the automatic trans-
mission is still in position D, R
orN.

Before you leave the vehicle, make sure that the automatic transmission
is shift to position P and that the parking brake is engaged.
Front passenger
airbag disabled
See Oper. Manual
Front passenger front air bag is
deactivated while driving even
though an adult or someone
larger than a small individual is
occupying the front passenger
seat. Forces acting on the seat
may make the system sense a
decrease in weight.
Stop the vehicle in a safe location as soon as possible and check the front
passenger seat for the following:
Switch off the ignition (
page 315).

Have the front passenger vacate the seat and exit the vehicle.

Adjust the seat in a height position (
page 318).

Make sure that no objects which apply forces to the seat are present (e.g.
objects such as books, briefcases etc. lodged underneath, behind or
around the seat). Such forces may cause the system to sense that an oc-
cupant of a lesser weight than actually present is on the front passenger
seat.

Keep the seat unoccupied, close the front passenger door and switch on
the ignition (
page 315).
Monitor the 59indicator lamp right of the instrument cluster
(
page 53) and the multifunction display in the instrument cluster
(page 241) for the following:
(Continued on next page)

566 Practical hintsWhat to do if …?Display
Possible cause/consequence
Possible solution
Next Service X
due in ... days
due in ... mls (km)
Service X must be carried out in ... days or
after ... miles (kilometers) (
page 532).

Have the maintenance service carried out by an authorized
Mercedes-Benz Center.
Only shift to
position 'P' when
vehicle is stationary
You have tried to Shift the automatic trans-
mission to P using the gear selector lever al-
though the vehicle is still in motion.

Stop the vehicle.
Park Assist
currently unavailable
See Oper. Manual
You attempt to activate Park Assist* even
though you have switched off the radar sen-
sors* on the vehicle.

Check if the radar sensors* may be switched on (
page 256).

Switch on the radar sensors* using the instrument cluster
control system.
Park Assist* is deactivated because the
area around the sensors* in the front or the
rear bumper (
page 538) is dirty.

Clean the front and rear bumper (
page 538).
Park Assist* is deactivated because the
battery voltage is insufficient.

Have the battery checked by an authorized Mercedes-Benz
Center.
Park Assist* is switched off because the ra-
dar sensor system* is temporarily inopera-
tive due to electromagnetic interference
near television and radio transmitter sta-
tions, toll stations, speed measuring sys-
tems, etc.

Wait until the message in the multifunction display disappears.

567 Practical hints
What to do if …?
Display
Possible cause/consequence
Possible solution
Park Assist
inoperative
Park Assist* is unavailable due to a mal-
function.

Visit an authorized Mercedes-Benz Center as soon as possible.
PRE-SAFE
inoperative
See Owner's Manual
PRE-SAFE
® itself has failed. All other occu-
pant safety systems, such as the air bags,
are still available.

Visit an authorized Mercedes-Benz Center as soon as possible.
Check tires
then restart
Run Flat Indicator
There was a warning message about a loss
in tire inflation pressure and the Run Flat In-
dicator* has not been restarted yet.

Check and adjust tire inflation pressure as required
(page 514).

Then restart the Run Flat Indicator* (
page 515).
Radar sensor
deactivated
See Oper. Manual
You attempt to activate DISTRONIC Plus*
or Park Assist* even though you have
switched off the radar sensors* on the vehi-
cle.

Check if the radar sensors* may be switched on (
page 256).

Switch on the radar sensors* using the instrument cluster
control system.
Run Flat Indicator
inoperative
The Run Flat Indicator* is malfunctioning.

Visit an authorized Mercedes-Benz Center as soon as possible.
Service X
due
Service X must be carried out (
page 532).

Have the maintenance service carried out by an authorized
Mercedes-Benz Center.
Service X exceeded
by X days
by XXX mls (km)
Service X must be carried within the next ...
or before you have driven ... miles (kilome-
ters) (
page 532).

Have the maintenance service carried out by an authorized
Mercedes-Benz Center as soon as possible.
Shift to P or N
to start engine
You have attempted to start the engine
while the automatic transmission was set to
position R or D.

Shift the automatic transmission to P or N (
page 367).

580 Practical hintsWhat to do if …?Display
Possible cause/consequence
Possible solution
Parking brake
See Oper. Manual
If overheated:
Let vehicle cool down, and do not engage
electric parking brake during this time.
or

Switch ignition off and back on again, and en-
gage or release electric parking brake.
(USA only)(Canada only)
Parking brake
inoperative
When you engage or release the electric
parking brake, the red indicator lamp for
the electric parking brake flashes and goes
out after approx. 10 seconds. The yellow
warning lamp for the electric parking brake
lights up.
The electric parking brake is malfunction-
ing.

Switch ignition off and back on again, and en-
gage electric parking brake (
page 364).
If the electric parking brake cannot be engaged:

Shift the automatic transmission to P
(page 367).

Protect vehicle from rolling away while
parked by using a chock from the vehicle tool
kit (
page 613).

Visit an authorized Mercedes-Benz Center as
soon as possible.

616 Practical hintsUnlocking/locking in an emergencyMechanically releasing the electric parking brake
The mechanical release device for the
electric parking brake is underneath the
fuel filler flap next to the fuel cap.
1Fuel filler flap
2Release tool
3Protective cap

Shift the automatic transmission to P
(page 367).

Place chock from vehicle tool kit
(page 611) under a rear wheel.

Open fuel filler flap1.

Remove protective cap3.

Screw release tool2 from vehicle tool
kit clockwise 2 to 3 rotations onto re-
lease lever.

Pull release tool2 in direction of ar-
row.
The electric parking brake is released.
The red indicator lamp 0 (USA only)
or ! (Canada only) in the instru-
ment cluster for the electric parking
brake flashes. The message “Parking
brake See Oper. Manual” appears on
the driver’s display.
After it has been unlocked, you can engage
the electric parking brake again from the
driver’s seat.

Press the electric parking brake handle
(page 364).
Warning!
G
If you mechanically release the electric
parking brake, the vehicle may start to move
on its own. Make sure that no one is in front
of or behind the vehicle. Otherwise, an acci-
dent could occur resulting in injury or fatali-
ty. Shift the automatic transmission to P and
secure your vehicle in place using the chock
from the vehicle tool kit.
i
You must pull the release tool with more
force if the electric parking brake cannot be re-
leased.
!
Reattach protective cap
3
after you have
mechanically released the electric parking
brake.