2007 MERCEDES-BENZ S CLASS brake sensor

412 Controls in detailDriving systemsCollision warning
Park Assist can detect obstacles from a
considerable distance. If you drive in re-
verse towards an obstacle, you will hear a
warning tone. You must then brake in or-
der to avoid a collision. The warning tone
for a collision will not sound when the vehi-
cle is at a standstill very close to the obsta-
cle. In this case, you will hear a
corresponding tone for the warning indica-
tor in the rear area.Switching Park Assist system on/off
The Park Assist system can be switched off
manually.
The Park Assist button with the indicator
lamp is located on the control panel on the
right-hand side of the instrument cluster.
1Park Assist button
2Indicator lamp

Switching off Park Assist system:
Press button 1.
Indicator lamp 2 comes on.

Switching on Park Assist system:
Press button 1 again.
Indicator lamp 2 goes out.
i
During strong rainfall, the collision warning
may be triggered, for example, by water splash-
ing into the area of the sensors.
i
When the indicator lamp is on, the Park
Assist system is switched off.
i
The Park Assist system is automatically
switched on when the ignition (
page 315) and
radar sensors are switched on (page 256).

512 OperationTires and wheelsThe TPMS only functions on wheels that
are equipped with the proper electronic
sensors. It monitors the tire inflation pres-
sure, as selected by the driver, in all four
tires. A warning is issued to alert you to a
decrease in pressure in one or more of the
tires.
Tire inflation pressure inquiries are made
using the multifunction display. The
present inflation pressures are displayed
only after a few minutes of travel time.
Switch on the ignition (
page 315).

Press( or& to select the menu
“Service”.

Press$ or% to select “Tire
pressure”.

Press#.
i
Possible differences between the readings
of a tire inflation pressure gauge of an air hose,
e.g. gas station equipment, and the vehicle’s
control system can occur. Usually the readings
issued by the control system are more precise.
i
The menu overview can be found on
(
page 243).
i
When the message “Tire pressures dis-
played after driving a few minutes” appears in
the display, the individual inflation pressure val-
ues are matched with the tires. The individual
values are displayed after a few minutes driving.Warning!
G
It is the driver’s responsibility to calibrate
the TPMS on the recommended cold infla-
tion pressure. Underinflated tires affect the
ability to steer or brake the vehicle. You
might lose control over the vehicle.
i
With a spare wheel without wheel sensor
mounted, the system may still indicate the tire
inflation pressure of the removed wheel for some
minutes. If this happens, keep in mind that the
indicated value where the spare wheel is mount-
ed does not reflect the actual spare tire inflation
pressure.Warning!
G
The TPMS does not indicate a warning for
wrongly selected inflation pressures. Always
adjust tire inflation pressure according to
the placard on the driver’s door B-pillar or, if
available, the supplemental tire pressure in-
formation on the inside of the fuel filler flap.
The TPMS is not able to issue a warning due
to a sudden dramatic loss of pressure (e.g.
tire blowout caused by a foreign object). In
this case bring the vehicle to a halt by care-
fully applying the brakes and avoiding
abrupt steering maneuvers.

514 OperationTires and wheelsReactivating Advanced TPMS
The TPMS must be reactivated when you
have adjusted the tire inflation pressure to
a new level (e.g. because of different load
or driving conditions). The TPMS is then
recalibrated to the current tire inflation
pressures.
Using the tire placard on the driver’s
door B-pillar (
page 503) or, if avail-
able, the supplemental tire inflation
pressure information on the inside of
the fuel filler flap (page 489), make
sure the tire inflation pressure of all
four tires is correct.

Switch on the ignition (
page 315).

Press( or& to select the menu
“Service”.

Press$ or% to select “Tire
pressure”.

Press#.
You will see

the current inflation pressures for
each tire
or


the message
Tire pressures
displayed after driving
a few minutes
appear in the multifunction display.

Press%.
The message
Use current pressure
values as new
reference values
To confirm press “OK”
appears in the multifunction display.
Warning!
G
It is the driver’s responsibility to calibrate
the TPMS on the recommended cold infla-
tion pressure. Underinflated tires affect the
ability to steer or brake the vehicle. You
might lose control over the vehicle.
i
Reactivate the TPMS after adjusting the tire
inflation pressure to the inflation pressure rec-
ommended for the vehicle operating condition.
Tire inflation pressure should only be adjusted
on cold tires. Observe the recommended tire in-
flation pressure on the placard on the driver’s
door B-pillar (
page 503). Some vehicles may
have supplemental tire inflation pressure infor-
mation for driving at high speeds (
page 510)
or for vehicle loads less than the maximum load-
ed vehicle condition. If such information is pro-
vided, it can be found on the inside of the fuel
filler flap (
page 489).
i
After wheel rotation or sensor replacement,
the vehicle must be parked for 20 minutes be-
fore attempting to reactivate the TPMS.
i
The menu overview can be found on
(
page 243).

568 Practical hintsWhat to do if …?Display
Possible cause/consequence
Possible solution
Tire pressure
Check tires
The pressure has fallen significantly in one
or more tires.

Carefully bring the vehicle to a halt, avoiding abrupt steering
and braking maneuvers. Observe the traffic situation around
you.

Check and adjust tire inflation pressure as required
(page 511).

If necessary, change the wheel (
page 629).

Restart the Run Flat Indicator* after adjusting the tire infla-
tion pressure values (
page 516).
Tire pressure monitor
inoperative
The Advanced TPMS* or a wheel sensor is
malfunctioning.

Have the Advanced TPMS* checked by an authorized
Mercedes-Benz Center.
Tire pressure monitor
inoperative
No wheel sensors
The Advanced TPMS* is deactivated be-
cause wheels without proper sensors were
installed.

Have the wheel sensors installed by an authorized
Mercedes-Benz Center.
As soon as all wheels with sensors have been mounted, the
Advanced TPMS* is switched back on after driving for sever-
al minutes.
Warning!
G
Do not drive with a flat tire. A flat tire affects
the ability to steer or brake the vehicle. You
may lose control of the vehicle. Continued
driving with a flat tire will cause excessive
heat build-up and possibly a fire.

575 Practical hints
What to do if …?
Display
Possible cause/consequence
Possible solution
Service
See Oper. Manual
S 600 only:
The brake system sensors are malfunction-
ing. The brake system continues to function
normally with full brake force boost.

Continue driving with added caution.

Have the system checked at an authorized
Mercedes-Benz Center as soon as possible.
(USA only)(Canada only)
Brake wear
The brake pads have reached their wear
limit.

Have the brake pads replaced as soon as
possible.
!
Brake pad thickness must be visually
checked by a qualified technician at the intervals
specified in the Maintenance Booklet.

670 Technical termsBAS Plus*
(B
rake A
ssist S
ystem Plus)
A system based on radar sensors for
providing brake support in situations
where there is a risk of collision.
BAS Plus is activated in hazardous situ-
ations by stepping quickly on the brake
pedal. During the process, the brake
force is adapted depending on the
proximity to the vehicle in front.
Bead
(
page 526)
Bit
(Binary digit)
The smallest unit of digital information.
Bit rate (MP3)
Measurement of transmission speed.
Indicates the number of ->bits trans-
mitted per time unit.Bi-xenon headlamps
Headlamps which use an electric arc as
the light source and produce a more in-
tense light than filament headlamps.
Bi-xenon headlamps produce low beam
and high beam.
B-pillar
Center connecting pillar between roof
and vehicle body (->A-pillar, ->C-pillar).
Bluetooth
Standard for short-range wireless tech-
nologies, suitable for transmitting
voice and data. It is possible to connect
Bluetooth devices wirelessly.
Bluetooth technology uses the freely
available ISM (Industrial Scientific
Medical) wireless network that works
at 2.45 GHz. Ranges of up to ten
meters are possible with Bluetooth.CAC
(C
ustomer A
ssistance C
enter)
Mercedes-Benz customer service cen-
ter, which can help you with any ques-
tions about your vehicle and provide
assistance in the event of a break-
down.
CAN system
(C
ontroller A
rea N
etwork)
Data bus network serving to control ve-
hicle functions such as door locking or
windshield wiping.
CD
(C
ompact D
isc)
Digital storage medium in disc form.
CD-R
(C
ompact D
isc R
ecordable)
->CD which can be written to once and
read many times.
CD-RW
(C
ompact D
isc R
ew
ritable)
->CD which be read and written to
many times.

689 Index
L
Labels 652
Certification 652
Emission control information 652
Supplemental tire inflation pressure
information 489
Tire and Loading Information 504
Vacuum line routing diagram 652
Lamp bulbs, exterior 621
Lamps, exterior
Front 622
Light sensor 596
Rear 622
Lamps, indicator and warning
ABS 29, 69, 544
Air bag Off 49
Battery (SmartKey with
KEYLESS-GO*) 310
Battery check lamp (SmartKey) 305
Brakes 545
DISTRONIC Plus* 29, 388, 397, 549
Engine diagnostics 547
Engine malfunction 547
ESP
®
549
Front passenger front air bag off 53,
555Fuel reserve 550
Instrument cluster 544
Maintenance service indicator 532
Seat belts telltale 550
SRS 552
Language (COMAND) 216
LATCH-type child seat anchors see Chil-
dren in the vehicle
Leather upholstery, Cleaning and care
of 542
Lever
For automatic transmission (gear se-
lector lever) 367
For cruise control 381
For DISTRONIC Plus* 390
License plate lamps
Messages in display 597
Replacing bulbs 622
Light alloy wheels, Cleaning 541
Light sensor
Message in display 596
Lighter see Cigarette lighter
Lighting 342
Automatic headlamp mode 343
Combination switch 346
Corner-illuminating lamps 347Courtesy lighting 350
Daytime running lamp mode 344
Door entry lamps 350
High beam flasher 347
High beams 346
Instrument cluster illumination 81,
378
Interior 348
Manual headlamp mode 343
Trunk 350
Limp-home mode 377
Line of fall 674
Loading see Vehicle loading
Locator lighting (COMAND) 221
Lock button
Door handle (KEYLESS-GO*) 309,
358
Key, SmartKey 304
Key, SmartKey with
KEYLESS-GO* 306
Trunk lid (KEYLESS-GO*) 310
Locking 363
Automatic central locking
(COMAND) 223
Vehicle in an emergency 615
Locking knob 312, 674

691 Index
Cruise control 559
DISTRONIC Plus* 560
Doors 590
EBP (Electronic Brake
Proportioning) 574
Engine 547
Engine oil 494, 602
ESP
®
572, 582
Fog lamps 598
Front passenger front air bag 562
Fuel cap 591
Gear selector lever 562, 566, 567,
569, 610
Headlamps 595
Hood 591
Key, SmartKey with
KEYLESS-GO* 592
Lamps, exterior 595
License plate lamps 597
Light sensor 596
Night View Assist* 601
Park Assist* 566
Parking brake 576
Parking lamps 599
PRE-SAFE®
567, 572
Restraint systems 605Side marker lamps 599
SRS 605
Tail lamps 600
Tele Aid 607
Trunk 610
Turn signals 596
Windshield washer fluid 610
Multifunction steering wheel 242, 675
N
Navigation system
Menu overview (COMAND) 147
Navigation system (COMAND) 140
Basic settings 150
Destination entry 153
Destination memory 195
Detour function (COMAND) 194
Driving maneuver 185
Hiding/showing the menu
system 148
Last destinations 201
Map display 148
Operation 148
POI entry 177
Route guidance 185Navigation system (Instrument cluster
control system) 246
Driving maneuver 247
Navigation system (Voice Control*) 269
Neutral gear position, Automatic
transmission 367, 370
New vehicle break-in 478
Night View Assist* 420
Cleaning the windshield in front of the
camera 539
Dirty or fogged-up windshield 422
Image on multifunction display 421
Malfunction 423
Messages in display 601
Removing condensation 422
Switching on or off 421
Normal occupant weight 527
Number, Vehicle Identification (VIN) 652
O
Occupant Classification System see OCS
Occupant distribution 527