2007 MERCEDES-BENZ R350 engine

515 Practical hints
Jump starting
The jump-start contacts are located in the
engine compartment.
1Negative (-) terminal
2Positive (+) terminal
Make sure the two vehicles do not
touch.
Turn off all electrical consumers.
Apply parking brake.
Set automatic transmission to
positionP.
Open the hood (page 364).
Open cover of positive terminal 2.1Negative terminal of discharged
battery
2Positive terminal of discharged battery
3Negative terminal of charged battery
4Positive terminal of charged battery
Warning!G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries.


516 Practical hints
Jump starting
Connect positive terminals2 and 4
with the jumper cable. Clamp cable to
charged battery 4 first.
Start engine of the vehicle with the
charged battery and run at idle speed.
Connect negative terminals1 and 3
of the batteries with the jumper cable.
Clamp cable to charged battery 3
first.
Start the engine of the disabled vehi-
cle.You can now turn on the electrical con-
sumers. Do not switch on the headlamps
under any circumstances.
Remove the jumper cables first from
negative terminals1 and 3 and then
from the positive terminals2 and 4.
You can now switch on the headlamps.
Have the battery checked at the
nearest authorized Mercedes-Benz
Light Truck Center.
!Never invert the terminal connections!


517 Practical hints
Towing the vehicle
Towing the vehicle
Mercedes-Benz recommends that the
vehicle be transported with all wheels off
the ground using flatbed or appropriate
wheel lift/dolly equipment. This method is
preferable to other types of towing.When circumstances do not permit the
recommended towing methods, the
vehicle may be towed with all wheels on
the ground only so far as necessary to have
the vehicle moved to a safe location where
the recommended towing methods can be
employed.
!Use flatbed or wheel lift/dolly equipment,
with the SmartKey in starter switch turned to
position0.
Do not tow with sling-type equipment. Towing
with sling-type equipment over bumpy roads will
damage radiator and supports.
To prevent damage during transport, do not tie
down vehicle by its chassis or suspension parts.
Use the towing eyes.
Switch off the ESP
® (page 104) and the
automatic central locking (
page 130).
!Do not tow-start the vehicle.
!Do not tow with one axle raised. Doing so
could damage the transfer case, which is not
covered by the Mercedes-Benz Limited
Warranty.
All wheels must be on or off the ground. Observe
instructions for towing the vehicles with all
wheels on the ground.
Warning!G
If circumstances require towing the vehicle
with all wheels on the ground, always tow
with a tow bar if:

the engine will not run

there is a malfunction in the power
supply or in the vehicle’s electrical
system
Prior to towing the vehicle with all wheels on
the ground, make sure the starter switch is
in position2 (
page 39).
Warning!G
With the engine not running, there is no
power assistance for the brake and steering
systems. In this case, it is important to keep
in mind that a considerably higher degree of
effort is necessary to brake and steer the
vehicle. Adapt your driving accordingly.
!When towing the vehicle with all wheels on
the ground, the automatic transmission must be
in positionN and the starter switch must be in
position2 (
page 39).
When towing the vehicle with all wheels on the
ground, the vehicle may be towed only for
distances up to 30 miles (50 km) and at a speed
not to exceed 30 mph (50 km / h).
Keep in mind that it is important for the
SmartKey to be in the respective starter switch
positions as described above. As soon as the
SmartKey is removed from the starter switch or
the SmartKey with KEYLESS-GO* is removed
from the vehicle, the automatic transmission will
shift to park positionP, see “Starter switch posi-
tions” (
page 39).

520 Practical hints
Fuses
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and
systems secured by that fuse will stop
operating.If a newly inserted fuse blows again, have
the cause determined and rectified by an
authorized Mercedes-Benz Center.
The following aids are available to help you
replace fuses. They are included with the
vehicle tool kit (
page 473):

Fuse chart
The fuse chart explains the fuse alloca-
tion and fuse amperages.

Spare fuses

Fuse extractor
The electrical fuses are located in different
fuse boxes:

on the passenger side of the engine
compartment (
page 521)

in the cargo compartment
(
page 521)

in the passenger compartment
(
page 522)Before replacing fuses:
Apply the parking brake (page 66).
Make sure automatic transmission is
set to position P (
page 199).
The gear position indicator in the
multifunction display should be on
P.
Turn off all electrical consumers.
Turn off the engine (page 67).
Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Open the driver’s door (this puts
the starter switch to position0,
same as with the SmartKey re-
moved from starter switch). The
driver’s door can then be closed
again.
Warning!G
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than
approved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Light Truck
Center
iA blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or the
fuse rating given on the fuse) of the amperage
recommended in the fuse chart.
Any Mercedes-Benz Light Truck Center will be
glad to advise you on this subject.

521 Practical hints
Fuses
Fuse box in engine compartment
The main fuse box is located on the pas-
senger side of the engine compartment.
Open the hood (page 364).
1Clamp
2Main fuse box cover
Release clamp1.
Lift fuse box cover2 up.
Install fuse box cover in reverse order.
Close the hood after checking or re-
placing fuses (
page 366).
Fuse box in cargo compartment
The fuse box is located under the cargo
compartment cover on the right-hand side
of the spare wheel well.
Open the tailgate (page 123).
Lift the cargo compartment cover
(
page 472).
Secure cargo compartment cover with
strap (
page 473).
1Cover
Fold cover1 to the left as indicated by
the arrow.
!The fuse box cover must be installed
properly to prevent moisture and/or dirt from
entering the fuse box and possibly impairing fuse
operation.

522 Practical hints
Fuses
Fuse box in passenger compartment
The fuse box is located behind a cover in
the dashboard on the passenger side.
Open the front passenger door.
1CoverOpening:
Pull cover1 in direction of arrow.
Closing:
Clip upper end of cover1 into open-
ing.
Push on lower end of cover1 until it
engages.
Emergency engine shut-down
If the engine cannot be turned off as de-
scribed in the “Getting started” section
(
page 67), do the following:
Take the fuse chart and the fuse
extractor from the vehicle tool kit
(
page 472).
Open the fuse box in the engine com-
partment (
page 521).
Use the fuse extractor to remove
fuse 120.
Find its location in the fuse chart.
!Do not use sharp objects such as a screw-
driver to open fuse box cover 1, as this could
damage it.
iR 500: Remove fuse 114 to shut-down the
engine. Find its location in the fuse chart.

523 Technical data
Parts service
Warranty coverage
Identification labels
Layout of poly-V-belt drive
Engine
Rims and tires
Electrical system
Main Dimensions
Weights
Fuels, coolants, lubricants, etc.

527 Technical data
Identification labels
4Second-row seat
5Carpet
6VIN
Move second-row seat 4 on pas-
senger side to the rear as far as possi-
ble (
page 138).
Fold carpet 5 in direction of arrow.
You may have to cut the perforated
carpet using a sharp object, e. g. a
knife.7Vacuum line routing diagram label
8Emission control information label,
includes both federal and California
certification exhaust emission stan-
dards
9VIN (lower edge of windshield)
aEngine number (engraved on engine)
iWhen ordering parts, please specify vehicle
identification and engine number.