2007 MERCEDES-BENZ R320CDI display

469 Practical hints
What to do if …
Display symbolDisplay messagePossible cause/consequencePossible solution
L Tele Aid
inoperativeOne or more main functions of the
Tele Aid* system are malfunctioning.Have the Tele Aid* system checked
by an authorized Mercedes-Benz Light
Truck Center.
Tele Aid
batteryThe emergency power battery for the
Tele Aid* system is malfunctioning. If the
vehicle battery is also malfunctioning or
drained, Tele Aid* will not be operational.Have the Tele Aid* system checked
by an authorized Mercedes-Benz Light
Truck Center.
tFunction
unavailableThis display appears if buttont or
son the multifunction steering wheel
is pressed and the vehicle is not equipped
with a telephone.
WTop up
washer fluidThe fluid level has dropped to
about1/3of total reservoir capacity.
Add washer fluid (page 372).

470 Practical hints
What to do if …
Display symbolDisplay messagePossible cause/consequencePossible solution
n*STOP
car too lowThe AIRMATIC* is inoperative.Avoid large steering angles.
Otherwise a fender or tire could
be damaged.
Do not drive faster than 50 mph
(80 km/h).
Have the vehicle checked at an
authorized Mercedes-Benz Light
Truck Center.
MalfunctionThe AIRMATIC* is malfunctioning.Do not drive faster than 50 mph
(80 km/h) depending on the set
vehicle level.
Have the vehicle checked at an
authorized Mercedes-Benz Light
Truck Center.
MalfunctionThe AIRMATIC* is functional only to a
limited extent.Do not drive faster than 50 mph
(80 km/h) depending on the set
vehicle level.
Have the vehicle checked at an
authorized Mercedes-Benz Light
Truck Center.

471 Practical hints
What to do if …
Display symbolDisplay messagePossible cause/consequencePossible solution
n*Vehicle rising
wait brieflyThe vehicle level is too low.Do not drive off.
The vehicle level control* has not yet
adjusted the vehicle level to the nec-
essary height required for driving.
Wait until the message disappears
from the multifunction display.
You may then drive off.
Compressor
cooling downLevel control was activated too long/too
frequently.Let the compressor cool until the
message disappears.
The selected level will be set once the
compressor has cooled down.
Level selection
not permittedYou are driving too fast for the desired
level selection.Reduce vehicle speed.
Set the next higher level
(
page 287).
!When the message Compressor cooling
down
appears in the multifunction display, driv-
ing is still possible.Keep in mind that the ride height of the vehicle is
not yet reached and you could therefore damage
the underbody of the vehicle.
The selected level will be set once the compres-
sor has cooled down.

484 Practical hints
Replacing bulbs
Bulbs
Safe vehicle operation depends on proper
exterior lighting and signaling. It is there-
fore essential that all bulbs and lamp
assemblies are in good working order at
all times.
Correct headlamp adjustment is extremely
important. Have headlamps checked and
readjusted at regular intervals and when a
bulb has been replaced. See an authorized
Mercedes-Benz Light Truck Center for
headlamp adjustment.iIf the headlamps or front fog lamps are
fogged up on the inside as a result of high humid-
ity, driving the vehicle a distance with the lights
on should clear up the fogging.iSubstitute bulbs will be brought into use
when the following lamps malfunction:

Turn signal lamps

Brake lamps

Parking lamps

Tail lamps
Read and observe messages in the multifunction
display (
page 463).

505 Practical hints
Bleeding the fuel system (diesel engine only)
Bleeding the fuel system (diesel engine only)
Driving the vehicle until the fuel tank is
empty is not recommended. Otherwise, air
may be sucked into the fuel system. If this
happens, the? malfunction indicator
lamp (USA only) or the ± malfunction
indicator lamp (Canada only) comes on
and the engine may not start immediately
after refueling the vehicle.
After refueling:
Make sure the automatic transmission
is set toP.
The gear position indicator in the multi-
function display should be on
P.
Do not depress the accelerator.
Turn the SmartKey in the starter switch
to position 2 for at least 10 seconds
(
page 40).
Return the SmartKey in the starter
switch to position 0 (
page 40).
Turn the SmartKey in the starter switch
to position 3 (
page 41) and hold it
there for a maximum of 40 seconds or
until the engine runs surge-free.
If the engine does not start:
Wait for approximately 2 minutes.
Turn the SmartKey in the starter switch
to position 3 (
page 41) and hold it
there for a maximum of 40 seconds or
until the engine runs surge-free.
If the engine still does not start, do not
make any further attempts to start the en-
gine. Contact an authorized
Mercedes-Benz Light truck Center or call
Roadside Assistance (
page 333).iVehicles with KEYLESS-GO*: If necessary,
remove the KEYLESS-GO start/stop button from
the starter switch (
page 41).iWhen the? malfunction indicator lamp
(USA only) or the ± malfunction indicator
lamp (Canada only) has been illuminated for the
above condition, it will remain illuminated until
the engine was cycled on and off four times in a
row.

520 Practical hints
Fuses
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and
systems secured by that fuse will stop
operating.If a newly inserted fuse blows again, have
the cause determined and rectified by an
authorized Mercedes-Benz Center.
The following aids are available to help you
replace fuses. They are included with the
vehicle tool kit (
page 473):

Fuse chart
The fuse chart explains the fuse alloca-
tion and fuse amperages.

Spare fuses

Fuse extractor
The electrical fuses are located in different
fuse boxes:

on the passenger side of the engine
compartment (
page 521)

in the cargo compartment
(
page 521)

in the passenger compartment
(
page 522)Before replacing fuses:
Apply the parking brake (page 66).
Make sure automatic transmission is
set to position P (
page 199).
The gear position indicator in the
multifunction display should be on
P.
Turn off all electrical consumers.
Turn off the engine (page 67).
Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Open the driver’s door (this puts
the starter switch to position0,
same as with the SmartKey re-
moved from starter switch). The
driver’s door can then be closed
again.
Warning!G
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than
approved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Light Truck
Center
iA blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or the
fuse rating given on the fuse) of the amperage
recommended in the fuse chart.
Any Mercedes-Benz Light Truck Center will be
glad to advise you on this subject.

547 Index
A
ABS 100
Indicator lamp 420
Messages in the multifunction
display 435
Accelerator position, automatic
transmission 203
Accessory weight 401
Accident 64
Active head restraint 83, 137, 482
Air bags 74
Children 75, 86
Front, Driver 77
Front, Passenger 77
Messages in the multifunction
display 445–448
Occupant Classification System
(OCS) 88
Safety guidelines 76
Side impact 78
Window curtain 78
Air conditioning, Cooling 228, 243
Air conditioning refrigerant 540Air conditioning system see
Climate control or
Automatic climate control (3-zone)*
Air distribution 223, 238
Air pressure see Tire inflation pressure
Air pressure, Tires 401
Air pump, Electric 502
Air recirculation mode 226, 240
Air vents, Front 218, 224, 232, 238
Air vents, Rear 230, 245, 249
Air volume 224, 239
AIRMATIC* 285
Messages in the multifunction
display 470
Alarm system see Anti-theft systems
Alignment bolt (vehicle tool kit) 472, 500
Anticorrosion/antifreeze 543, 546
Antiglare, Interior rear view mirror 212
Antiglare, Auto-dimming rear view
mirrors* 213
Anti-theft systems 107
Anti-theft alarm system 107
Immobilizer 107Aquaplaning see Hydroplaning
Arm rests, Second-row 141
Armrest storage compartments
Front 313
Rear* 314
Ashtrays* 319
Aspect ratio 401
ATF 370
AUDIO menu 171
CD operation 172
Radio operation 171
Satellite radio* operation 172
Audio search function 188
Auto-dimming*, Rear view mirrors 213
Automatic antiglare for rear view
mirrors* 213
Automatic central locking, Control
system 189

548 Index
Automatic climate control (3-zone)* 232
Air conditioning, Cooling 243
Air conditioning refrigerant 540
Air distribution 238
Air recirculation mode 240
Air vents, Front 232, 238
Air vents, Rear 245, 249
Air volume 239
Control panel, Front 234
Control panel, Rear 245
Deactivating system 236
Defogging 240
Defrosting 239
Maximum cooling, MAX COOL 240
Rear passenger compartment 245
Residual heat utilization (REST) 244
Automatic headlamp mode 147
Automatic lighting control, Interior
lighting 154
Automatic locking when driving 130
Automatic shift program 206Automatic transmission 197
Accelerator position 203
Automatic shift program 206
Emergency operation
(limp-home mode) 211
Gear ranges 205
Gear selector lever 54, 197
Gear shifting malfunctions 211
Hill start assist system 204
Kickdown 203
Kickdown, manual shift program
(R 63 AMG only) 211
Manual shift program
(R 63 AMG only) 209
Program mode selector switch 206
Shifting procedure 200
Starting the engine 54
Steering wheel gearshift control 207
Transmission fluid level 370
Transmission positions 201
Automatic transmission fluid see ATF
AUX-socket 311B
Backrest
Seat 44
Seat, Lumbar support 136
Seat, Multicontour* 136
Backup lamps
Messages in the multifunction
display 463–468
Replacing bulbs 484
Bar 401
BAS 102
Lamps in instrument cluster 420
Messages in the multifunction
display 435
Batteries, SmartKey
Check lamp 112, 116
Checking battery condition 115, 120
Battery, Vehicle 506
Charging 513
Disconnecting and connecting 508
Jump starting 514
Removing and installing 508
Bead 401