519 Practical hints
Towing the vehicle
Warning!
G
If circumstances require towing the vehicle
with all wheels on the ground, always tow
with a tow bar if:
the engine will not run
there is a malfunction in the power
supply or in the vehicle’s electrical sys-
tem
Prior to towing the vehicle with all wheels on
the ground, make sure the starter switch is
in position2 (
page 40).
Warning!
G
With the engine not running, there is no
power assistance for the brake and steering
systems. In this case, it is important to keep
in mind that a considerably higher degree of
effort is necessary to brake and steer the
vehicle. Adapt your driving accordingly.
i
To signal turns while being towed with
hazard warning flasher in use, set the starter
switch to position2 and activate combination
switch for left or right turn signal in usual manner
– only the selected turn signal will operate.
Upon canceling the turn signal, the hazard
warning flasher will operate again.
i
If the battery is disconnected or discharged,
the automatic transmission will remain locked in
positionP and the SmartKey will not turn in the
starter switch. For more information, see “Bat-
tery” (page 507) and “Jump starting”
(
page 515).
!
When towing the vehicle with all wheels on
the ground, note the following:
With the automatic central locking activated and
the ignition in position2 (
page 40), the vehicle
doors lock if the left front wheel is turning at a
speed of approximately 9 mph (15 km/h) or
above.
To prevent the vehicle doors from locking,
deactivate the automatic central locking
(
page 126).
Towing of the vehicle should only be done using
the towing eye bolt. Never attach tow cable, tow
rope or tow rod to vehicle chassis, frame or sus-
pension parts.
520 Practical hintsTowing the vehicleInstalling towing eye bolt
Depending on whether you are towing a
vehicle or you are being towed, the towing
eye bolt can be screwed into threaded
holes which are located behind covers on
the right-hand side of each bumper.
1Cover1Cover
Vehicles with Sport Package*1CoverRemoving cover
Press mark on cover1 as indicated by
the arrow.
Vehicles with Sport Package*:
Pry cover1 with a screwdriver or
similar tool at point indicated by the
arrow.
Lift off cover1 to reveal the threaded
hole for towing eye bolt.Warning!
G
In order to avoid possible serious burns or
injury, use extreme caution when removing
the rear cover, because the rear exhaust
pipe is extremely hot.i
The cover1 is secured to the bumper by a
plastic cord.
522 Practical hintsFusesThe electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and sys-
tems secured by that fuse will stop operat-
ing.If a newly inserted fuse blows again, have
the cause determined and rectified by an
authorized Mercedes-Benz Light Truck
Center.
The following aids are available to help you
replace fuses. They are included with the
vehicle tool kit (
page 469):
Fuse chart
The fuse chart explains the fuse alloca-
tion and fuse amperages.
Spare fuses
Fuse extractor
The electrical fuses are located in different
fuse boxes:
Fuse box in engine compartment
(page 523)
Fuse box in cargo compartment
(page 523)
Fuse box in passenger compartment
(page 524)Before replacing fuses:
Apply parking brake (
page 65).
Make sure the automatic transmission
is set toP (
page 187).
The gear position indicator in the multi-
function display should be on
P.
Turn off all electrical consumers.
Turn off the engine (
page 40).
Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Open the driver’s door (this puts
the starter switch in position0,
same as with the SmartKey re-
moved from the starter switch). The
driver’s door then can be closed
again.
Warning!
G
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than ap-
proved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an au-
thorized Mercedes-Benz Light Truck Center.i
A blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or the
fuse rating given on the fuse) of the amperage
recommended in the fuse chart. Any
Mercedes-Light Truck Center will be glad to
advise you on this subject.
543 Technical data
Fuels, coolants, lubricants
Fuels, coolants, lubricants
Capacities
Vehicle components and their respective
lubricants must match. Therefore only use
products tested and approved by
Mercerdes-Benz.
Please refer to the Factory Approved
Service Products pamphlet, or inquire at
your Mercedes-Benz Light Truck Center.
Warning!
G
Comply with all valid regulations with re-
spect to handling, storing and disposing of
service fluids. Otherwise you could
endanger persons or the environment.
Keep service fluids out of the reach of
children.
If a service fluid is swallowed, contact a
physician immediately.
Model
Capacity
Fuels, coolants, lubricants, etc.
Engine with oil filter
ML 320 CDI
9.5 US qt (9.0 l)
Approved engine oils
ML 350
8.5 US qt (8.0 l)
Approved engine oils
ML 500
9.0 US qt (8.5 l)
Approved engine oils
ML 63 AMG
10.3 US qt (9.7 l)
Approved engine oils
Automatic transmission
All models
9.5 US qt (9.0 l)
MB Automatic Transmission Fluid
Transfer case single speed
All models
0.53 US qt (0.5 l)
MB Automatic Transmission Fluid
546 Technical dataFuels, coolants, lubricantsEngine oils
Engine oils are specifically tested for their
suitability in our engines and durability for
our service intervals. Therefore, only use
approved engine oils and oil filters re-
quired for vehicles with Maintenance
System (U.S. vehicles) or FSS PLUS (Cana-
da vehicles). For a listing of approved en-
gine oils and oil filters, refer to the Factory
Approved Service Products pamphlet, or
contact an authorized Mercedes-Benz
Light Truck Center.
Engine oil additives
Do not blend oil additives with engine oil.
They may damage the engine.
Damage or malfunctions resulting from
blending oil additives are not covered by
the Mercedes-Benz Limited Warranty.Air conditioning refrigerant
R-134a (HFC) refrigerant and special PAG
lubricating oil are used in the air condition-
ing system.
Never use R-12 (CFC) or mineral-based lu-
bricating oil. Otherwise damage to the
system will occur.
Brake fluid
Only brake fluid approved by
Mercedes-Benz is recommended. Your
authorized Mercedes-Benz Light Truck
Center will provide you with additional in-
formation.
!
Using engine oils and oil filters of
specification other than those expressly
required for the Maintenance System
(U.S. vehicles) or FSS PLUS (Canada vehicles),
or changing of oil and oil filter at change intervals
longer than those called for by the Maintenance
System (U.S. vehicles) or FSS PLUS (Canada ve-
hicles) will result in engine or emission control
system damage not covered by the
Mercedes-Benz Limited Warranty.Please follow Maintenance System
(U.S. vehicles) or FSS PLUS (Canada vehicles)
recommendations for scheduled oil changes.
Failure to do so could result in engine or
emission control system damage not covered by
the Mercedes-Benz Limited Warranty.
Warning!
G
During vehicle operation, the boiling point of
the brake fluid is continuously reduced
through the absorption of moisture from the
atmosphere. Under extremely strenuous op-
erating conditions, this moisture content
can lead to the formation of bubbles in the
system, thus reducing the system’s efficien-
cy.
Therefore, the brake fluid must be replaced
regularly. Refer to your vehicle’s
Maintenance Booklet for replacement inter-
val.
547 Technical data
Fuels, coolants, lubricants
Premium unleaded gasoline (gasoline engine)
Gasoline additives (gasoline engine)
A major concern among engine manufac-
turers is carbon build-up caused by gaso-
line. Mercedes-Benz recommends only the
use of quality gasoline containing additives
that prevent the build-up of carbon depos-
its.
After an extended period of using fuels
without such additives carbon deposits
can build up, especially on the intake
valves and in the combustion area, leading
to engine performance problems such as:
Warm-up hesitation
Unstable idle
Knocking/pinging
Misfire
Power loss
Warning!
G
Gasoline is highly flammable and poisonous.
It burns violently and can cause serious
injury.
Never allow sparks, flame or smoking mate-
rials near gasoline!
Turn off the engine before refueling.
Whenever you are around gasoline, avoid in-
haling fumes and skin or clothing contact,
extinguish all smoking materials.
Direct skin contact with fuels and the inha-
lation of fuel vapors can damage your
health.
!
To maintain the engine’s durability and per-
formance, premium unleaded gasoline must be
used. If premium unleaded is not available and
low octane fuel is used, follow these precau-
tions:
Have the fuel tank only partially filled with
unleaded regular and fill up with premium
unleaded as soon as possible.
Avoid full throttle driving and abrupt acceler-
ation.
Do not exceed an engine speed of 3000 rpm
if the vehicle is loaded with a light load such
as two persons and no luggage.
Do not exceed
2/3 of maximum accelerator
pedal position if the vehicle is fully loaded or
operating in mountainous terrain.
551 Technical data
Fuels, coolants, lubricants
Windshield washer and headlamp cleaning* system
Both the windshield washer and headlamp
cleaning* system are supplied from the
windshield washer fluid reservoir.
The windshield and headlamp washer fluid
reservoir has a capacity of approximately
8.1 US qt (7.7 l).
Refill the reservoir with MB Windshield
Washer Concentrate and water (or con-
centrate and commercially available
premixed windshield washer sol-
vent/antifreeze, depending on ambient
temperatures).Windshield and headlamp washer fluid
mixing ration
For temperatures above freezing point, use
MB Windshield Washer Concentrate
“MB SummerFit” and water:
1 part “MB SummerFit” to 100 parts
water
(1.34 fl oz [40 ml] “MB SummerFit” to
1gal [4.0l] water)
For temperatures below freezing point, use
MB Windshield Washer Concentrate
“MB SummerFit ” and commercially avail-
able premixed windshield washer
solvent/antifreeze:
1 part “MB SummerFit” to 100 parts
solvent
(1.34 fl oz [40 ml]“MB SummerFit” to
1 gal [4.0 l] solvent)
Warning!
G
Washer solvent/antifreeze is highly flamma-
ble. Do not spill washer solvent/antifreeze
on hot engine parts, because it may ignite
and burn. You could be seriously burned.
555 Index
Bead 395
Belt reel 291
Beverage holder see Cup holder
Block heater (Canada only) 400
Bolts, Collapsible tire
(ML 63 AMG only) 474
Bolts, Minispare wheel
(except ML 63 AMG) 473
Brake fluid 546
Checking 354
Messages in the
multifunction display 449
Brake lamp
Cleaning lenses 408
Messages in the
multifunction display 458
Replacing bulbs 490
Brake pads 326
Messages in the
multifunction display 447
Brakes 326
Warning lamp 415
Break-in period 324
Bulbs, replacing see Replacing bulbs
Button for Voice control*
system 30, 148C
California retail buyers and lessees,
Important notice for 11
Camera see Rear view camera*
Can holder see Cup holder
Capacities and recommended
fuel/lubricants 543
Card holder 32, 35, 299
Cargo compartment cover blind 286
Cargo tie-down rings 283
Carpets, Cleaning 411
Catalytic converter
(gasoline engine) 349
CD changer* 161, 294
CD player 161
Center console
Lower part 32
Upper part 31
Central locking
Automatic 126
Locking/unlocking from
the inside 126
Switch 126
Certification label 530CHECK ENGINE malfunction
indicator lamp 417, 418
Checking tire pressure electronically with
the Advanced Tire Pressure Monitoring
System (Advanced TPMS)*,
(Canada only) 381
Checking tire pressure electronically with
the Tire Pressure Monitoring System
(TPMS), (USA only) 379
Checklist
Off-road driving 336
Returning from off-road driving 341
Children in the vehicle 82
Air bags 73, 82
Blocking rear door window
operation 93
Indicator lamp, Front passenger front
air bag 89
Infant and child restraint systems 77,
82
LATCH-type child seat anchors 91
Occupant Classification System
(OCS) 85
Cigarette lighter* 301