2007 MERCEDES-BENZ ML350 shifting

268 Controls in detailDriving systemsOff-road driving program
The off-road driving program is designed to
assist the driver when driving off-road in
terrain and crossing water. The off-road
driving program adjusts the engine power
and shifting of the automatic transmission
to be more suitable for the off-road use of
the vehicle. In addition, the ABS, ESP
®, and
4-ETS designed for off-road use are
automatically activated.
In the following situations you should
switch to the off-road driving program:


during off-road driving


when crossing water (
page 338)


when towing up or down on steep
gradientsThe switch is located on the lower part of
the center console.
1Switch for off-road driving program
2Indicator lampSwitching Off-road driving program on

Press switch1 (
page 268).
Indicator lamp2 comes on. The
symboly appears in the lower
multifunction display.
Switching Off-road driving program off

Press switch1 again.
Indicator lamp2 goes out. The
symboly disappears.
i
In the ML 63 AMG, the off-road driving
program is switched on and off via the control
system (
page 159).

324 OperationIn the “Operation” section you will find
detailed information on operating, main-
taining and caring for your vehicle.The first 1000 miles (1500 km)
The more cautiously you treat your vehicle
during the break-in period, the more satis-
fied you will be with its performance later
on.

Drive your vehicle during the first
1000 miles (1500 km) at varying but
moderate vehicle and engine speeds.


During this period, avoid heavy loads
(full throttle driving) and excessive
engine speeds (no more than
2/3 of
maximum rpm in each gear).


Shift gears in a timely manner.


Avoid accelerating by kick-down.


Do not attempt to slow the vehicle
down by shifting to a lower gear using
the gear selector lever.


Select gear ranges3, 2 or1
(page 193) only when driving at
moderate speeds (for hill driving).After 1000 miles (1500 km) you may
gradually increase vehicle and engine
speeds to the permissible maximum.
All of the above instructions, as may apply
to your vehicle type, also apply when driv-
ing the first 1000 miles (1500 km) after
the engine, the transfer case, the front dif-
ferential or the rear differential has been
replaced.
!
Additional instructions for ML 63 AMG:


During the first 1000 miles (1500 km), do
not exceed a speed of 85 mph (140 km/h).


During this period, avoid engine speeds
above 4500 rpm in each gear.


Shift gears at the correct time.


SelectC as the preferred shift program
(page 195) for the first 1000 miles
(1500 km).
i
Always obey applicable speed limits.

327 Operation
Driving instructions
To help prevent brake disk corrosion after
driving on wet road surfaces (particularly
salted roads), it is advisable to brake the
vehicle with considerable force prior to
parking. The heat generated serves to dry
the brakes.
If your brake system is normally only sub-
jected to moderate loads, you should occa-
sionally test the effectiveness of the
brakes by applying above-normal braking
pressure at higher speeds. This will also
enhance the grip of the brake pads.
Refer to the description of the Brake Assist
System (BAS) (
page 97).Brake pad wear or a leak in the system may
be the reason for low brake fluid in the
reservoir.
The brake fluid level in the reservoir may
be too low if the brake warning lamp in the
instrument cluster comes on and an
acoustic warning sounds although the
parking brake is released (
page 415).
Observe additional messages in the multi-
function display that may appear
(
page 449).
Have the brake system inspected
immediately. Contact an authorized
Mercedes-Benz Light Truck Center.
All checks and service work on the brake
system should be carried out by qualified
technicians only. Contact an authorized
Mercedes-Benz Light Truck Center.
Only install brake pads and brake fluid
recommended by Mercedes-Benz.
After hard braking, it is advisable to drive
on for some time, rather than immediately
park, so that the air stream will cool down
the brakes faster.
Warning!
G
Make sure not to endanger any other road
users when carrying out these braking
maneuvers.
Warning!
G
If other than recommended brake pads are
installed, or other than recommended brake
fluid is used, the braking properties of the
vehicle can be degraded to an extent that
safe braking is substantially impaired. This
could result in an accident.!
When driving down long and steep grades,
relieve the load on the brakes by shifting into a
lower gear to use the engine’s braking power.
This helps prevent overheating of the brakes and
reduces brake pad wear.
When using the engine’s braking power, a drive
wheel may not spin for an extended period of
time, e.g. on slippery road surfaces. This may
cause serious damage to the drivetrain which is
not covered by the Mercedes-Benz Limited
Warranty.

337 Operation
Driving instructions


Comply with the warnings
(page 333) and rules for off-road
driving (
page 335).


Driving on embankments, slopes and
other steep inclines should only be
done straight up or downhill, i.e. in the
line of gravity. Maximum vehicle climb-
ing ability is a 100% grade which is
equivalent to a slope angle of
45 degrees. Keep in mind that the
climbing ability of the vehicle depends
on terrain conditions.


Shift automatic transmission to
position1 (
page 193).


Drive slowly.


Avoid excessive engine speeds – drive
with moderate engine speeds
(max. 3 000 rpm).


Utilize the engine’s braking power
when descending a slope, observe the
engine speed (do not overrev the en-
gine). Apply the service brake as need-
ed.


Check the brakes after a lengthy down-
grade drive.Traction in steep terrain
The maximum vehicle climbing ability is a
100% grade which is equivalent to a slope
angle of 45 degrees. Keep in mind that the
climbing ability of the vehicle depends on
terrain conditions.
Be easy on the accelerator and watch for
continuous wheel traction when driving in
steep terrain.
Vehicles with air
suspension
package*
1
1
1
1Vehicles with AMG Sport-Package*
2
Raised level
34°
29°
31°
Highway
29°
22°
27°
ML 63 AMG
1
2
Raised level
28°
29°
Highway
23°
24°
i
For maximum engine speed, see “Instru-
ment cluster” (
page 26) and see “Engine”
(
page 534).Warning!
G
To help avoid the vehicle rolling over, never
turn it around on steep inclines. If the vehi-
cle cannot complete the attempted climb,
back it down in reverse gear.
i
The hill start assist system supports you
when driving uphill.
For more information, see “Hill start assist sys-
tem” (page 192).
i
The 4-ETS helps greatly when starting out on
a steep incline when the front wheels have then
the tendency to slip due to the weight shifting
towards the rear axle.
The 4-ETS recognizes the situation and limits the
torque for the front wheels by braking them.
Simultaneously the torque for the rear wheels is
increased.

362 OperationEngine compartmentTransmission fluid level
The transmission fluid level does not need
to be checked. If you notice transmission
fluid loss or gear shifting malfunctions,
have an authorized Mercedes-Benz Light
Truck Center check the automatic trans-
mission.Coolant level
The engine coolant is a mixture of water
and anticorrosion/antifreeze. To check
the coolant level, the vehicle must be
parked on level ground.
The coolant expansion tank is located on
the driver’s side of the engine compart-
ment.1Cap
2Coolant expansion tank
3Indicator wall
4Coolant level

Using a rag, turn cap1 slowly approx-
imately one half turn counterclockwise
to release any excess pressure.
Warning!
G
In order to avoid potentially serious burns:

Use extreme caution when opening the
hood if there are any signs of steam or
coolant leaking from the cooling system,
or if the coolant temperature gauge indi-
cates that the coolant is overheated.


Do not remove pressure cap on coolant
reservoir if coolant temperature is
above 158°F (70°C). Allow engine to
cool down before removing cap. The
coolant reservoir contains hot fluid and
is under pressure.


Using a rag, slowly open the cap approx-
imately
1/2 turn to relieve excess pres-
sure. If opened immediately, scalding
hot fluid and steam will be blown out un-
der pressure.


Do not spill antifreeze on hot engine
parts. Antifreeze contains ethylene gly-
col which may burn if it comes into con-
tact with hot engine parts.

435 Practical hints
What to do if …
Display message
Possible cause/consequence
Possible solution
Depress brake
to shift out of
Park
You have tried to shift the automatic
transmission into positionD,R orN
using the gear selector lever without
depressing the brake pedal.

Depress the brake pedal.
Door Open
Vehicle not in Park
You have opened the driver’s door
and the transmission is still in
positionD,R orN.

Before you leave the vehicle, make sure
that the automatic transmission is set to
positionP and that the parking brake is
engaged.
Drive to workshop
without
shifting gears
The automatic transmission cannot
be shifted out of the set position be-
cause of a malfunction.
If the automatic transmission is set to
positionD:
Without changing the automatic transmis-
sion from positionD, drive to an authorized
Mercedes-Benz Light Truck Center.
If the automatic transmission is set to
positionN,R orP:

Do not drive.

Contact an authorized Mercedes-Benz Light
Truck Center.

554 IndexAutomatic climate control (3-zone)* 220
Air conditioning, Cooling 230, 231
Air distribution, Front 226
Air distribution, Rear 234
Air recirculation mode 228
Air vents, Front 226
Air volume 227
Control panel, Front 222
Control panel, Rear 232
Deactivating system 224
Defogging 227
Defrosting 227
Maximum cooling, MAX COOL 228
Rear passenger compartment 232
Rear window defroster 205
Residual engine heat (REST) 232
Using driver-side settings for
all temperature zones 231
Automatic headlamp mode 137
Automatic lighting control, Interior
lighting 143
Automatic locking when driving 126
Automatic shift program
(ML 63 AMG only) 196Automatic transmission 54
Accelerator position 191
Automatic shift program
(ML 63 AMG only) 196
Emergency operation
(Limp-Home Mode) 198
Gear ranges 193
Gear selector lever 54, 185
Gear shifting malfunctions 198
Hill start assist system 192
Kickdown 191
Kickdown, manual shift program
(ML 63 AMG only) 198
Manual shift progam
(ML 63 AMG only) 196
Program mode selector switch
(ML 63 AMG only) 195
Shift program (ML 63 AMG only) 195
Shifting procedure 188
Starting the engine 54
Steering wheel gearshift control 194
Towing a trailer 192
Transmission fluid level 362
Transmission positions 189
Automatic Transmission Fluid see ATFB
Backrest
Seat 44
Seat, Lumbar support 130
Seat, Multicontour* 130
Backup lamps
Messages in the
multifunction display 458
Replacing bulbs 490
Bar 395
BAS 97
Lamps in instrument cluster 414
Messages in the
multifunction display 430
Basic carrier bars* 281
Batteries, SmartKey
Check lamp 108, 112
Checking battery condition 111
Messages in the
multifunction display 446
Replacing 480
Battery, Vehicle 507
Charging 514
Disconnecting and connecting 509
Jump starting 515
Removing and installing 509

561 Index
Fuel cap
Messages in the multifunction
display 455
Fuel consumption statistics
After start 180
Since last reset 181
Fuel filler flap 352
Locking/unlocking 352
Opening 352
Opening in an emergency 477
Fuel tank
Capacity 545
Filler flap 352
Fuel, Premium unleaded gasoline 545
Fuels, coolants, lubricants etc. 543
Fuses 522
Fuse box in cargo compartment 523
Fuse box in engine compartment 523
Fuse box in passenger
compartment 524
Fuse chart 469, 522
Fuse extractor 469, 522
Replacing 522
Spare fuses 469, 522G
Garage door opener* 316
Gasoline see Fuel
GAWR 395
Gear range
Automatic transmission 193
Limiting 193
Shifting into optimal 195
Gear selector lever 25, 54, 185
Cleaning 411
Gearshift pattern 185
Messages in the
multifunction display 438
Position 188
Shifting procedure 188
Transmission position 189
Global locking/unlocking see Key,
SmartKey
Glove box 294
Good visibility 200
Gross Axle Weight Rating see GAWR
Gross Trailer Weight see GTW
Gross Vehicle Weight Rating see GVWRGross Vehicle Weight see GVW
GTW 395
GVW 395
GVWR 395
H
Halogen headlamp see Headlamps
Hands-free microphone 33
Hard plastic trim items, cleaning 411
Hazard warning flasher 142
Head restraints 44, 128
Active head restraint 80, 128
Front seats, Adjusting 44
Rear seats 81
Rear seats, Adjusting 129
Rear seats, Removing and
installing 129
Headlamp aim
Adjusting 492
Headlamp cleaning system* 200, 363
Headlamp shut-off delay see Delayed
shut-off, Exterior lamps