538 Practical hints
Jump starting
If the battery is discharged, the engine can
be started with jumper cables and the bat-
tery of another vehicle. Observe the follow-
ing:
Jump starting should only be performed
using the jump-start contacts located
in the engine compartment
(
page 539).
Jump starting should only be performed
when the engine and catalytic
converter
1 are cold.
Do not start the engine if the battery is
frozen. Let the battery thaw out first.
Only jump start from batteries with the
same voltage rating (12 V). Jump start-
ing with a higher voltage battery could
damage the vehicle’s electrical system,
which will not be covered by the
Mercedes-Benz Limited Warranty.
Only use jumper cables with sufficient
cross-section and insulated terminal
clamps.
Always make sure the jumper cables
are not on or near pulleys, fans or other
parts that move when the engine is
started or running.
Warning!G
Failure to follow these directions will cause
damage to the electronic components, and
can lead to a battery explosion and severe
injury or death.
Never lean over batteries while connecting
or jump starting, you might get injured.
Battery fluid contains sulfuric acid. Do not
allow this fluid to come in contact with eyes,
skin or clothing. In case it does, immediately
flush affected area with water, and seek
medical help if necessary.
A battery will also produce hydrogen gas,
which is flammable and very explosive. Keep
flames or sparks away from battery, avoid
improper connection of jumper cables,
smoking, etc.
Attempting to jump start a frozen battery
can result in it exploding, causing personal
injury.
Read all instructions before proceeding.
1Vehicles with gasoline engine only.
!Do not tow-start the vehicle.
!Avoid repeated and lengthy starting
attempts.
Do not attempt to start the engine using a
battery quick charge unit.
If the engine does not run after several unsuc-
cessful starting attempts, have it checked at the
nearest authorized Mercedes-Benz Light Truck
Center.
Excessive unburned fuel generated by repeated
failed starting attempts may damage the catalyt-
ic converter
1.
Make sure the jumper cables do not have loose
or missing insulation.
Make sure the cable clamps do not touch any
other metal part while the other end is still at-
tached to a battery.
571 Index
Battery, Vehicle 530
Charging 537
Disconnecting and connecting 532
Jump starting 538
Removing and installing 532
Bead 416
Beverage holder see Cup holder
Bi-Xenon headlamps* see headlamps
Bolts, Spare wheel 499
Brake fluid 562
Checking 377
Messages in the
multifunction display 472
Brake lamp
Cleaning lenses 429
Messages in the
multifunction display 481
Replacing bulbs 515
Brake pads 350
Messages in the
multifunction display 470
Brakes 350
Warning lamp 437
Break-in period 348
Bulbs, replacing see Replacing bulbsButton for Voice control* system 30,
158
C
California retail buyers and lessees,
Important notice for 11
Camera see Rear view camera*
Can holder see Cup holder
Capacities and recommended
fuel/lubricants 560
Card holder 33, 37, 321
Cargo compartment cover blind 312
Cargo net* 313
Cargo tie-down rings 304
Carpets, Cleaning 433
Carriers* 297
Catalytic converter
(gasoline engine) 373
CD changer 167, 316
CD player 167
Center console
Lower part 33
Upper part (Vehicles with
enhanced off-road package*) 32
Upper part (Vehicles without
enhanced off-road package*) 31Central locking
Automatic 130
Locking/unlocking from the
inside 130
Switch 130
Certification label 550
CHECK ENGINE malfunction indicator
lamp 439, 440
Checking tire pressure electronically with
the Advanced Tire Pressure Monitoring
System (Advanced TPMS)*,
(Canada only) 402
Checking tire pressure electronically with
the Tire Pressure Monitoring System
(TPMS), (USA only) 399
Checklist
Off-road driving 359
Returning from off-road driving 365
