Page 309 of 457

308 Operation
Tires and wheels
If applicable to your vehicle’s tire confi-
guration, tires can be rotated according to
the tire manufacturer’s recommended
intervals in the tire manufacturer’s
warranty pamphlet located in your vehicle
literature portfolio. If none is available,
tires should be rotated every 3 000 to
6 000 miles (5 000 to 10 000 km), or
sooner if necessary, according to the
degree of tire wear. The same rotation
(spinning) direction must be maintained
(
page 280).
Rotate tires before the characteristic tire
wear pattern becomes visible (shoulder
wear on front tires and tread center wear
on rear tires).
Thoroughly clean the mounting face of
wheels and brake disks, i.e. the inner side
of the wheels/tires, during each rotation.
Check for and ensure proper tire inflation
pressure.For information on wheel change, see the
“Practical hints” section (page 366) and
(
page 390).
Warning!G
Have the tightening torque checked after
changing a wheel. Wheels could become
loose if not tightened with a torque of
97 lb-ft (130 Nm).
Only use genuine Mercedes-Benz wheel
bolts specified for your vehicle’s rims.
Page 396 of 457

395 Practical hints
Flat tire
1-5 Wheel bolts
Tighten the five wheel bolts evenly,
following the diagonal sequence illus-
trated (1 to 5), until all wheel bolts
are tight. Observe a tightening torque
of 96 lb-ft (130 Nm).
Disassemble the pump handle
(
page 392).
Put the pump handle and the wheel
wrench back into the vehicle tool kit.
Store the vehicle tool kit in the
designated storage compartment
(
page 366).
Press the jack piston in again and close
the lowering screw (
page 392).
Store the jack in the designated
storage compartment (
page 367).
After changing the wheel, secure the
damaged wheel on the spare wheel
carrier (
page 369). Make sure the
wheel cannot come loose.
Check the tire inflation pressure and
correct it if necessary.
Follow recommended cold tire inflation
pressures listed on the Tire and
Loading Information placard on the
driver’s door B-pillar (
page 280).
Warning!G
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque of
96 lb-ft (130 Nm).
Page 452 of 457

451 Index
Telephone* 226
Changing mobile phone cradle 228
Inserting in cradle 227
Installing a different mobile phone
cradle 228
Message in display 364
Removing from cradle 228
Telephone* tray
Armrest 216
Below armrest 216
Temperature
Setting interior temperature 185
Tires 287
Text messages
Multifunction display 340–343
Tie-down rings (cargo compartment) 209
Tightening torque (wheel bolts) 395
Tilt/sliding sunroof 195
Automatic opening 196
Closing 196, 374
Opening 196, 374
Opening fully 196
Stopping 196
TIN 306
Tire
Vehicle maximum load on 307Tire and Loading Information 281
Tire and loading terminology 304
Tire care and maintenance 278
Tire Identification Number see TIN
Tire inflation pressure
Checking 286, 288
Tire inspection 278
Tire load rating 306
Tire ply composition and material
used 306
Tire speed rating 250, 297, 306
Tire terminology 304
Tire traction 249
Tires 277, 416
Advanced Tire Pressure Monitoring
System (Advanced TPMS) 289
Advanced TPMS malfunction
telltale 335
Combination low tire pressure/TPMS
malfunction telltale, USA only 27
Direction of rotation 280
Driving instructions 248
Low tire pressure telltale 335
Messages in display 342–343,
361–362
Retreads 277Rims and tires 416
Rotating 307
Service life 278
Temperature 287, 303
Tread depth 279, 309
Wear pattern 308
Winter 309
Tongue Weight Rating see TWR
Tools 366
Total load limit 306
Tow-away alarm 30, 98
Arming 98
Disarming 98
Disarming for transport 98
Tow-away alarm system
Canceling alarm 98
Towing eye, front 404
Towing eye, rear 404
Towing the vehicle 401
Stranded vehicle 404
Towing the vehicle - various problem
scenarios 403
Traction 307