27 At a glance
Instrument cluster
ItemPage
1Speedometer with:
vElectronic Stability
Program (ESP®)
warning lamp
92,
330
;Brake warning lamp,
USA only55,
326
3Brake warning lamp,
Canada only55,
326
BLow beam headlamp
indicator lamp56,
118
HCombination low tire
pressure/Advanced
TPMS malfunction tell-
tale335
2LLeft turn signal
indicator lamp57
3Multifunction display with:133
Trip odometer131,
140
Main odometer140
Transfer case indicator170
ItemPage
Gear selector lever
position indicator164
Gear range indicator167
Status indicator:
Outside temperature132,
133
Digital speedometer133
Clock133
4KRight turn signal
indicator lamp 57
5Tachometer with:
-Antilock Brake System
(ABS) indicator lamp88,
324
332
1Supplemental
Restraint System
(SRS) indicator lamp68,
334
úEngine malfunction
indicator lamp,
USA only328
ItemPage
±Engine malfunction
indicator lamp,
Canada only328
AHigh beam headlamp
indicator lamp57,
122
6Fuel gauge with:
Fuel tank reserve warning
lamp331
4Fuel filler flap indica-
tor: The fuel filler flap
is located on the rear
right-hand side264
7Coolant temperature gauge131
8Reset button for:
Resetting trip odometer131
Resetting all settings146
Resetting individual
settings 158,
312
Adjusting instrument
cluster illumination130
293 Operation
Tires and wheels
If you want to set new reference values
manually:
Using the Tire and Loading Information
placard on the driver’s door B-pillar
(
page 280) or, if available, the
supplemental tire inflation pressure
information on the inside of the fuel
filler flap (
page 264), make sure the
tire inflation pressure of all four tires is
correct.
Press buttonè orÿ on the mul-
tifunction steering wheel repeatedly
until the standard display menu
appears in the multifunction display.
Press buttonj ork repeatedly
until you see the current inflation
pressures for each tire appear in the
multifunction display or the following
message appears in the multifunction
display:
Tire pressure
displayed
only after
driving for
a few minutes
Press the reset button (page 130).
The following message will appear in
the multifunction display:
Restart
tire pressure
monitor?
Press theæ button.
The following message will appear in
the multifunction display:
Tire pressure
monitor
restarted
After driving a few minutes the system
verifies that the current tire inflation
pressures are within the system’s
specified range. Afterwards the current
tire inflation pressures are accepted as
reference pressures and then moni-
tored.
If you wish to cancel activation:
Press theç button.
iRestart the TPMS after adjusting the tire in-
flation pressure to the inflation pressure recom-
mended for the vehicle operating condition. Tire
pressure should only be adjusted on cold tires.
Observe the recommended tire inflation pres-
sure on the Tire and Loading Information placard
on the driver’s door B-pillar (
page 280). Some
vehicles may have supplemental tire inflation
pressure information for driving at high speeds
(
page 287) or for vehicle loads less than the
maximum loaded vehicle condition
(
page 287). If such information is provided, it
can be found on the inside of the fuel filler flap
(
page 264).
