2007 MERCEDES-BENZ G500 turn signal

Contents
Introduction.......................................... 9
Product information ................................ 9
Operator’s Manual ............................... 10
Service and warranty information .. 10
Important notice for California
retail buyers and lessees of
Mercedes-Benz automobiles .......... 11
Maintenance .................................. 12
Roadside Assistance ...................... 12
Change of address or ownership.... 13
Operating your vehicle outside
the USA or Canada......................... 13
Where to find it .................................... 15
Symbols ............................................... 16
Operating safety .................................. 17
Proper use of the vehicle ............... 17
Problems with your vehicle .................. 18
Reporting safety defects...................... 19
Reporting safety defects ................ 19
Vehicle data recording......................... 20
Information regarding electronic
recording devices........................... 20At a glance.......................................... 21
Exterior view ......................................... 22
Cockpit ................................................. 24
Instrument cluster ................................ 26
Multifunction steering wheel ................ 28
Center console ..................................... 30
Upper part ...................................... 30
Lower part ...................................... 31
Overhead control panel ........................ 32
Door control panel................................ 33
Storage compartments ......................... 34Getting started................................... 37
Unlocking ............................................. 38
Unlocking with the SmartKey ......... 38
Starter switch positions .................. 39
Adjusting .............................................. 41
Seats .............................................. 41
Steering wheel ................................ 44
Mirrors ............................................ 46
Driving .................................................. 48
Fastening the seat belts ................. 48
Starting the engine ......................... 54
Parking brake ................................. 55
Driving off ....................................... 55
Switching on headlamps ................. 56
Turn signals .................................... 57
Windshield wipers ........................... 58
Rear window wiper/washer ............ 60
Problems while driving.................... 61
Parking and locking .............................. 62
Parking brake ................................. 62
Switching off headlamps................. 64
Turning off engine ........................... 64
Releasing seat belts........................ 64
Locking ........................................... 65

25 At a glance
Cockpit
ItemPage
1Combination switch

High beam57

Turn signals57

Windshield wipers58
2Headlamp cleaning button177
3Cruise control lever197
4Horn
5Instrument cluster26
6Lever for Voice Control
System*, see separate
operating instructions
7Starter switch39
8Glove box release215
Glove box lock216
ItemPage
9Glove box215
aCenter console30
bMultifunction steering wheel28
cHood lock release267
dSteering wheel adjustment
stalk44
Heated steering wheel225
eExterior lamp switch56,
117
fExterior rear view mirror
adjustment46

27 At a glance
Instrument cluster
ItemPage
1Speedometer with:
vElectronic Stability
Program (ESP®)
warning lamp
92,
330
;Brake warning lamp,
USA only55,
326
3Brake warning lamp,
Canada only55,
326
BLow beam headlamp
indicator lamp56,
118
HCombination low tire
pressure/Advanced
TPMS malfunction tell-
tale335
2LLeft turn signal
indicator lamp57
3Multifunction display with:133

Trip odometer131,
140

Main odometer140

Transfer case indicator170
ItemPage

Gear selector lever
position indicator164

Gear range indicator167

Status indicator:

Outside temperature132,
133

Digital speedometer133

Clock133
4KRight turn signal
indicator lamp 57
5Tachometer with:
-Antilock Brake System
(ABS) indicator lamp88,
324
332
1Supplemental
Restraint System
(SRS) indicator lamp68,
334
úEngine malfunction
indicator lamp,
USA only328
ItemPage
±Engine malfunction
indicator lamp,
Canada only328
AHigh beam headlamp
indicator lamp57,
122
6Fuel gauge with:
Fuel tank reserve warning
lamp331
4Fuel filler flap indica-
tor: The fuel filler flap
is located on the rear
right-hand side264
7Coolant temperature gauge131
8Reset button for:

Resetting trip odometer131

Resetting all settings146

Resetting individual
settings 158,
312

Adjusting instrument
cluster illumination130

39 Getting started
Unlocking
Press unlock button Πon the
SmartKey.

All turn signal lamps flash once.

The locking knobs in the doors
move up.

The anti-theft alarm system is
disarmed.

The locator lighting comes on if the
feature is enabled in the control
system (
page 152).
Enter the vehicle and insert the
SmartKey in the starter switch.
For more information, see “Locking and
unlocking” (
page 100).
Starter switch positions
SmartKey
Starter switch
0For removing SmartKey
The steering is locked when the
SmartKey is removed from the starter
switch.
1Power supply for some electrical
consumers, such as seat adjustment
2Ignition (power supply for all electrical
consumers) and driving position
All lamps (except high beam headlamp
indicator lamp and turn signal indicator
lamps unless activated) in the instru-
ment cluster come on. If a lamp in the
instrument cluster fails to come on
when the ignition is switched on, have
it checked and replaced if necessary. If
a lamp in the instrument cluster
remains on after starting the engine or
comes on while driving, refer to “Lamps
in instrument cluster” (
page 324).
3Starting position
Warning!G
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. A child’s
unsupervised access to a vehicle could
result in an accident and/or serious
personal injury.

40 Getting started
Unlocking
For information on starting the engine, see
(
page 54).
iWhen you switch on the ignition, the indica-
tor and warning lamps (except high beam head-
lamp indicator lamp and turn signal indicator
lamps unless activated) in the instrument cluster
come on. The indicator and warning lamps
(except high beam headlamp indicator lamp and
turn signal indicator lamps if activated) will go
out when the engine is running. This indicates
that the respective systems are operational.
iThe SmartKey can only be removed from the
starter switch with the gear selector lever in park
positionP.
iIf the SmartKey is left in starter switch
position0 for an extended period of time, it can
no longer be turned in the switch. In this case,
the steering is locked. To unlock, remove
SmartKey from the starter switch and reinsert.
!If the SmartKey cannot be turned in the
starter switch, the battery may not be
sufficiently charged.

Check the battery and charge it if necessary
(
page 398).

Get a jump start (page 399).
To prevent accelerated vehicle battery discharge
or a completely discharged vehicle battery,
always remove the SmartKey from the starter
switch when the engine is not in operation.

57 Getting started
Driving
High beam
The combination switch is located on the
left of the steering column.
Combination switch
1High beam
2High beam flasher
Push the combination switch in
direction of arrow1.
The high beam headlamp indicator
lampA in the instrument cluster
comes on (
page 26).
For more information on headlamps, see
“Lighting” (
page 117).
Turn signals
The combination switch is located on the
left of the steering column.
Combination switch
1Turn signals, right
2Turn signals, left
Press the combination switch in
direction of arrow1 or2.
The corresponding turn signal indicator
lampK orL in the instrument
cluster flashes (
page 26).
The combination switch resets automati-
cally after major steering wheel move-
ments.
iTo signal minor directional changes such as
changing lanes, press combination switch only
to point of resistance and release. The corre-
sponding turn signals will flash three times.

65 Getting started
Parking and locking
Locking
Exit the vehicle and close all doors and
the tailgate.
Press lock button‹ on the
SmartKey (
page 38).
With the hood, tailgate and all doors
closed:

All turn signal lamps flash three
times.

The locking knobs in the doors
move down.

The anti-theft alarm system is
armed.
For more information, see “Locking and
unlocking” (
page 100).
Warning!G
To prevent possible personal injury, always
keep hands and fingers away from the door
openings when closing the doors. Be
especially careful when small children are
around.
Before closing doors, make sure there is no
possibility of someone getting caught in a
door during closing.
Warning!G
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. A child’s
unsupervised access to a vehicle could
result in an accident and/or serious
personal injury.
iIf you hear a warning signal you have forgot-
ten to switch off the headlamps before opening
the driver’s door.
In addition the message
Switch off lights
appears in the multifunction display.
Switch off the headlamps.
!Failure to switch off the headlamps when
leaving the vehicle may result in a discharged
battery.

87 Safety and Security
Panic alarm
Panic alarm
1Âbutton
Activating
Press and hold button for at
least 1 second.
An audible alarm and blinking turn
signal lamps will operate briefly.
Deactivating
Press Âbutton once more.
or
Insert the SmartKey in the starter
switch.
iUSA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful inter-
ference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.
iCanada only:
This device complies with RSS-210 of Industry
Canada. Operation is subject to the following
two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.