Page 431 of 514
430 Practical hintsWhere will I find ...?First aid kit
The first aid kit is in the storage compart-
ment at the front edge of the front passen-
ger seat.
1Tab
Pull tab1 upward.
Fold the covering forward.
Remove the first aid kit.
Vehicle tool kit, jack and spare wheel
The vehicle tool kit, jack and spare wheel
are stored in the compartment underneath
the third row seat cushions and footwell
(page 431) or underneath the cargo
compartment floor (E 63 AMG only).
The vehicle tool kit includes:
One pair of universal pliers
One towing eye bolt
One wheel wrench
One alignment bolt
One fuse extractor
Spare fuses
Collapsible wheel chock
A pair of glovesVehicles without foldable third row
seat (E 63 AMG only) - Vehicle tool kit,
jack and collapsible tire
The vehicle tool kit is located in the cargo
compartment underneath the front cargo
compartment floor.
1Front cargo compartment floor
2Rear cargo compartment floor
Pull release handle 1 or 2 and fold
the respective cargo compartment
floor upward.
i
Check expiration dates and contents for
completeness at least once a year and replace
missing/expired items.
Page 459 of 514
458 Practical hintsFlat tire
Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while
vehicle is raised.Removing the wheel
1Alignment bolt
Unscrew upper-most wheel bolt and re-
move.
Replace this wheel bolt with alignment
bolt1 supplied in the tool kit.
Remove the remaining bolts.
Remove the wheel.
Mounting the spare wheel
Clean contact surfaces of wheel and
wheel hub.
Warning!
G
Position the jack only on the jack take-up
brackets designed for this purpose.
If the jack is not properly positioned, the ve-
hicle may slip off of the jack.
Warning!
G
The jack is intended only for lifting the
vehicle briefly for wheel changes. It is not
suited for performing maintenance work
under the vehicle.
Never start the engine when the vehicle
is raised.
Never lie down under the raised vehicle.
!
Do not place wheel bolts in sand or dirt. This
could result in damage to the bolt and wheel hub
threads.
!
To avoid paint damage, place wheel flat
against hub and hold it there while installing first
wheel bolt.
Page 460 of 514
459 Practical hints
Flat tire
Guide the spare wheel onto the align-
ment bolt and push it on.
Insert wheel bolts and tighten them
slightly.
Unscrew the alignment bolt, install last
wheel bolt and tighten slightly.Vehicles with collapsible tire (E 63 AMG
without folding third row seat only):
Continue the procedure by following
the instructions under “Inflating the
collapsible tire” (
page 459) and then
“Lowering the vehicle” (
page 461).
Vehicles with Minispare wheel
(except E 63 AMG):
Continue the procedure by following
the instructions under “Lowering the
vehicle” (
page 461).
Inflating the collapsible tire
(E 63 AMG without foldable third row
seat only)
Warning!
G
Always replace wheel bolts that are dam-
aged or rusted.
Never apply oil or grease to wheel bolts.
Damaged wheel hub threads should be re-
paired immediately. Do not continue to drive
under these circumstances! Contact an au-
thorized Mercedes-Benz Center or call
Roadside Assistance.
Incorrect wheel bolts or improperly tight-
ened wheel bolts can cause the wheel to
come off. This could cause an accident. Be
sure to use the correct wheel bolts.
Warning!
G
Only use Genuine equipment
Mercedes-Benz wheel bolts. Other wheel
bolts may come loose.
Do not tighten the wheel bolts when the
vehicle is raised. Otherwise the vehicle
could fall off the jack.
Warning!
G
Inflate collapsible tire only after the wheel is
properly mounted.
Inflate the collapsible tire using the electric
air pump before
lowering the vehicle.