2007 MERCEDES-BENZ E350 4MATIC key

459 Practical hints
Bleeding the fuel system (diesel engine only)
Bleeding the fuel system (diesel engine only)
Driving the vehicle until the fuel tank is
empty is not recommended. Otherwise, air
may be sucked into the fuel system. If this
happens, theú malfunction indicator
lamp (USA only) or the ±malfunction
indicator lamp (Canada only) comes on
and the engine may not start immediately
after refueling the vehicle.
After refueling:
Make sure the gear selector lever is set
to P.

Do not depress the accelerator.

Turn the SmartKey in the starter switch
to position2 (
page 38) for at least
10 seconds.

Return the SmartKey in the starter
switch to position0 (
page 38).

Turn the SmartKey in the starter switch
to position3 (
page 38) and hold it
there for a maximum of 40 seconds or
until the engine runs surge-free.If the engine does not start:

Wait for approximately 2 minutes.

Turn the SmartKey in the starter switch
to position3 (
page 38) and hold it
there for a maximum of 40 seconds or
until the engine runs surge-free.
If the engine still does not start, do not
make any further attempts to start the en-
gine. Contact an authorized
Mercedes-Benz Center or call Roadside
Assistance (
page 297).
i
Where theú malfunction indicator lamp
(USA only) or the± malfunction indicator
lamp (Canada only) in the instrument cluster has
been illuminated for the above condition, it will
remain illuminated until the engine was cycled
on and off four times in a row.

461 Practical hints
Battery
Disconnecting the battery
Apply the parking brake (
page 62).

Make sure the gear selector lever is set
to positionP.

Turn off all electrical consumers.
!
As with any other battery, disconnect the
battery if you do not intend to operate your vehi-
cle for an extended period of time to prevent bat-
tery discharge or connect an accessory battery
charge unit expressly approved by
Mercedes-Benz for your vehicle model to main-
tain the battery charge. Contact an authorized
Mercedes-Benz Center for further information.
The battery, the battery ventilation hose and the
lateral plug must always be securely installed
when the vehicle is in operation.
!
Never loosen or detach battery terminal
clamps while the engine is running or the
SmartKey is in the starter switch. Otherwise the
alternator and other electronic components
could be severely damaged.
Have the battery checked regularly by an autho-
rized Mercedes-Benz Center.
Refer to Maintenance Booklet for maintenance
intervals or contact an authorized
Mercedes-Benz Center for further information.
Warning!
G
Do not place metal objects on the battery as
this could result in a short circuit.
Use leak-proof batteries only to avoid the
risk of acid burns in the event of an acci-
dent.
Warning!
G
With a disconnected battery

you will no longer be able to turn the
SmartKey in the starter switch and
pressing the KEYLESS-GO* start/stop
button on the gear selector lever will
have no effect


the gear selector lever will remain
locked in positionP
!
Always disconnect the battery in the order
described below. Otherwise the vehicle’s
electronics can be damaged.


462 Practical hintsBattery
Remove SmartKey from starter switch.
Vehicles with KEYLESS-GO*:
Press the start/stop button until
the engine shuts off.

Open the driver’s door.

Open the trunk.

Read and observe safety instructions
and precautions (
page 331) and
(
page 460).

Remove the luggage box (
page 433).

Disconnect the negative lead from neg-
ative terminal2 (
page 460).

Remove cover1 (
page 460) from
the positive terminal.

Disconnect the positive lead.
Removing the battery
Remove the screw-nuts securing the
battery.

Remove the battery bracket3
(page 460).

Pull out the battery ventilation hose4
(page 460) from the battery (de-
pending on battery arrangement in
your vehicle model, the ventilation
hose is located either on the left or
right side of the battery).

Take out the battery.
Charging and reinstalling the batteryWarning!
G
Never charge a battery while still installed in
the vehicle unless the accessory battery
charge unit* approved by Mercedes-Benz is
being used. Gases may escape during charg-
ing and cause explosions that may result in
paint damage, corrosion or personal injury.
An accessory battery charge unit* specially
adapted for Mercedes-Benz vehicles and
tested and approved by Mercedes-Benz is
available, permitting the charging of the bat-
tery in its installed position. Contact an au-
thorized Mercedes-Benz Center for
information and availability. Charge battery
in accordance with the separate instruc-
tions for the accessory battery charger.


466 Practical hintsTowing the vehicleMercedes-Benz recommends that the vehi-
cle be transported with all wheels off the
ground using flatbed or appropriate wheel
lift/dolly equipment. This method is pref-
erable to other types of towing.When circumstances do not permit the
recommended towing methods, the vehi-
cle may be towed with all wheels on the
ground or front wheels raised (except vehi-
cles with 4MATIC) only so far as necessary
to have the vehicle moved to a safe loca-
tion where the recommended towing
methods can be employed.!
Do not tow-start the vehicle.
!
Use flatbed or wheel lift/dolly equipment
with SmartKey in starter switch turned to
position0.
Do not tow with sling-type equipment. Towing
with sling-type equipment over bumpy roads will
damage radiator and supports.
To prevent damage during transport, do not tie
down vehicle by its chassis or suspension parts.
Switch off the tow-away alarm and the automatic
central locking.
!
Vehicles with 4MATIC:
Do not tow with one axle raised. Doing so could
damage the transfer case, which is not covered
by the Mercedes-Benz Limited Warranty.
All wheels must be on or off the ground. Observe
instructions for towing the vehicle with all
wheels on the ground.
Warning!
G
If circumstances require towing the vehicle
with all wheels on the ground, always tow
with a tow bar if:

the engine will not run


there is a malfunction in the brake
system


there is a malfunction in the power sup-
ply or in the vehicle’s electrical system
as that will be necessary to adequately con-
trol the towed vehicle.
Prior to towing the vehicle with all wheels on
the ground, make certain the SmartKey is in
starter switch position2.
If the SmartKey is left in the starter switch
position0 for an extended period of time, it
can no longer be turned in the switch. In this
case, the steering is locked. To unlock, re-
move SmartKey from starter switch and re-
insert.

467 Practical hints
Towing the vehicle
Warning!
G
With the engine not running, there is no
power assistance for the brake and steering
systems. In this case, it is important to keep
in mind that a considerably higher degree of
effort is necessary to brake and steer the ve-
hicle. Adapt your driving accordingly.!
If the vehicle is towed with the front axle
raised (not permissible for vehicles with
4MATIC), the gear selector lever must be in
positionN and the engine must be shut off
(SmartKey in starter switch position0 or1).
Active braking action through the ESP
® may
otherwise seriously damage the brake system.
When towing the vehicle with all wheels on the
ground, the gear selector lever must be in
positionN and the SmartKey must be in starter
switch position2.
When towing the vehicle with all wheels on the
ground or the front axle raised, the vehicle may
be towed only for distances up to 30 miles
(50 km) and at a speed not to exceed 30 mph
(50 km/h).
!
Towing of the vehicle should only be done
using the properly installed towing eye bolt.
Never attach tow cable, tow rope or tow rod to
the vehicle chassis, frame or suspension parts.
i
When towing the vehicle with all wheels on
the ground, please note the following:
With the automatic central locking activated and
the SmartKey in starter switch position2, or
KEYLESS-GO
* start/stop button in position2,
the vehicle doors lock if the left front wheel as
well as the right rear wheel are turning at vehicle
speeds of approximately 9 mph (15 km/h) or
more.
To prevent the vehicle door locks from locking,
deactivate the automatic central locking
(
page 127).
i
To signal turns while being towed with the
hazard warning flasher in use, turn SmartKey in
starter switch to position2 and activate the
combination switch for the left or right turn sig-
nal in the usual manner – only the selected turn
signal will operate.
Upon canceling the turn signal, the hazard warn-
ing flasher will operate again.
i
The gear selector lever will remain locked in
positionP and the SmartKey will not turn in the
starter switch if the battery is disconnected or
discharged. For more information see “Batter-
ies” (page 460) or “Jump starting”
(
page 464).
For information on manual unlocking of the gear
selector lever, see (
page 438).

469 Practical hintsFuses
Fuses
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and sys-
tems secured by that fuse will stop operat-
ing.If a newly inserted fuse blows again, have
the cause determined and rectified by an
authorized Mercedes-Benz Center.
The following aids are available to help you
replace fuses.


Fuse chart
The fuse chart is located in the fuse box
in the passenger compartment
(page 470). The fuse chart explains
the fuse allocation and fuse amperag-
es.


Spare fuses
Spare fuses are located in the vehicle
tool kit in the trunk (
page 434).


Fuse extractor
The fuse extractor is located in the ve-
hicle tool kit in the trunk (
page 434).The electrical fuses are located in different
fuse boxes:


in the passenger compartment on the
driver’s side (
page 470)


in the trunk (
page 470)
Before replacing fuses:

Apply the parking brake (
page 62).

Make sure the gear selector lever is set
to position P (
page 184).

Turn off all electrical consumers.

Turn off the engine (
page 63).

Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Open the driver’s door.
Warning!
G
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than ap-
proved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Center.i
A blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or the
fuse rating given on the fuse) of the amperage
recommended in the fuse chart.
Any Mercedes-Benz Center will be glad to advise
you on this subject.

502 IndexAutomatic transmission
Accelerator position 188
Automatic shift program 190
Emergency operation (Limp-Home
Mode) 197
Gear ranges 189
Gear selector lever 184
Gear selector lever control one-touch
gearshifting 191
Gear selector lever positions 186
Gear shifting malfunctions 197
Kickdown 188
Kickdown, manual shift program
E63AMG 196
Manual shift program E 63 AMG 194
Program mode selector switch 190
Shifting procedure 185
Starting engine 52
Steering wheel gearshift control
one-touch gearshifting* 192
B
BabySmart
TM
Air bag deactivation system 81
Self-test 81Backrest 277
Seat 43
Seat, multicontour* 131
Backup lamps
Messages in display 422
Replacing bulbs 443
Bar 360
BAS 99
Batteries, SmartKey
Checking battery condition 119
Replacing 441
Batteries, SmartKey with KEYLESS-GO*
Checking battery condition 119
Replacing 441
Batteries, Vehicle
Charging 462
Disconnecting 461
Jump starting 464
Messages in display 412
Reconnecting 463
Reinstalling 462
Removing 462
Bead 360
Beverage holder see Cup holders
Bi-Xenon headlamps* see Headlamps
Bleeding the fuel system 459Block heater* (Canada only) 365
Brake fluid
Checking 324
Messages in display 413
Brake lamp
Cleaning lenses 372
Replacing bulbs 443
Brake pads
Message in display 412
Brakes 310
High-performance brake system
(E 63 AMG only) 312
Warning lamp 383
Break-in period 308
Bulbs see Replacing bulbs
C
California retail buyers and lessees, impor-
tant notice for 11
Can holder see Cup holders
Capacities and recommended
fuel/lubricants 491
Cargo area see Trunk
Cargo tie-down rings 280
Carpets, cleaning 376
Catalytic converter (gasoline
engine) 318

504 IndexConvenience submenu
Activating easy-entry/exit
feature 178
Setting parking position for exterior
rear view mirror 179
Coolant
Anticorrosion/antifreeze mixing ratio
and quantity 499
Capacities 493
Checking coolant level 330
Messages in display 414, 415, 416
Temperature 320
Temperature indicator 149
Warning lamp 386
Corner-illuminating front fog lamps* 142
Cruise control 249
Cup holders 284
Curb weight 360
Customer Assistance Center (CAC) 17
D
Date display, setting 172, 173
Daytime running lamp mode 139
Setting 173, 174
Deep water see Standing water
Defogging windshield 213, 230
Defrosting, Front 212, 229Defrosting, Rear 203
Delayed shut-off
Exterior lamps 175
Interior lighting 176
Department of Transportation see DOT
Diesel fuel 322
Difficulties
While driving 60
With starting 54
Digital clock see Clock
Digital speedometer 157
Dimensions, vehicle 489
Direction of rotation (tires) 336
Displays
Digital speedometer 157
Distronic* 255
Maintenance service indicator 366
Messages in display 411
Multifunction display 151
Outside temperature 151, 170
Symbol messages 411
Text messages 398
Vehicle status message memory 165
Vehicle system settings, Control
system 151Distance to empty (Range), Trip
computer 181
Distronic* 252
Activating/deactivating 258
Cleaning system sensor 373
Control system 163
Distance warning function 261
Driving hints 262
Menu 257
Messages in display 399
Sensor cover 373
Warning and indicator lamps 255
Door
Entry lamps 147
Locking/unlocking, SmartKey 36
Locking/unlocking, SmartKey with
KEYLESS-GO* 37, 116
Message in display 430
Opening from inside/outside 119
Remote door unlock (Tele Aid) 300
Unlocking, Mechanical key 436
Door control panel 34
Door handle 34
Doors
Locking/unlocking from outside 112
DOT 360