2007 MERCEDES-BENZ CLS63AMG garage door opener

ContentsPower tilt/sliding sunroof .................. 212
Opening and closing
the power tilt/sliding sunroof ...... 212
Synchronizing
the power tilt/sliding sunroof ...... 214
Driving systems ................................. 215
Cruise control............................... 215
Distronic*..................................... 218
Airmatic DC (Dual Control) ........... 231
Parktronic system
(Parking assist)* ........................... 235
Loading .............................................. 239
Roof rack* .................................... 239
Loading instructions ..................... 239
Ski bag* (Canada only)................. 240
Cargo tie-down rings .................... 243
Retaining hooks............................ 243Useful features .................................. 244
Storage compartments ................ 244
Cup holders.................................. 247
Ashtrays ....................................... 249
Cigarette lighter ........................... 250
Power outlets ............................... 251
Heated steering wheel
(Canada only) ............................... 252
Floormats ..................................... 253
Telephone* .................................. 254
Tele Aid ........................................ 257
Garage door opener ..................... 263
Operation......................................... 269
The first 1 000 miles (1 500 km) ........ 270
Driving instructions ........................... 271
Drive sensibly – save fuel............. 271
Drinking and driving ..................... 271
Pedals .......................................... 271
Power assistance ......................... 272
Brakes.......................................... 272
Driving off .................................... 274
Parking......................................... 275
Tires ............................................. 275
Hydroplaning................................ 276
Tire traction ................................. 276
Tire speed rating .......................... 277
Winter driving instructions ........... 278
Standing water............................. 279
Passenger compartment .............. 280
Driving abroad ............................. 280
Control and operation of
radio transmitter .......................... 280
Catalytic converter....................... 281
Emission control .......................... 281
Coolant temperature.................... 282

31 At a glance
Overhead control panel
Overhead control panel
Item
Page
1
Rear interior lighting on/off
135
2
Automatic interior lighting
135
3
Front interior lighting on/off
135
4
Right front reading lamp
on/off
135
5
Tilt/sliding sunroof
212
6
Tele Aid (emergency call
system) button
257
7
Rear view mirror
185
8
Front reading lamps
135
Item
Page
9
Garage door opener
263
a
Hands-free microphones for
Tele Aid (emergency call
system), telephone*, and
Voice Control System* (see
separate operating instruc-
tions)
b
Ambient lighting
163
c
Interior lighting
135
d
Left front reading lamp
on/off
135

263 Controls in detail
Useful features
Stolen Vehicle Recovery services
In the event your vehicle was stolen:
Report the incident to the police.
The police will issue a numbered
incident report.

Pass this number on to the
Mercedes-Benz Response Center along
with your password issued to you when
you subscribed to the service.
The Response Center will then attempt
to covertly contact the vehicle’s
Tele Aid system. Once the vehicle is
located, the Response Center will
contact the local law enforcement and
you. The vehicle’s location will only be
provided to law enforcement.
Garage door opener
The integrated remote control is capable of
operating up to three separately controlled
devices. It provides a convenient way to re-
place up to three hand-held remote con-
trols used to operate devices such as
garage door openers, gate openers, or oth-
er devices compatible with HomeLink
® or
some other systems.
Before the integrated remote control can
be used, it must be programmed to the ga-
rage door opener, gate operator or other
device you wish to operate. See the follow-
ing instructions for programming informa-
tion.
i
The remote door unlock feature is available
if the relevant cellular phone network is avail-
able.
The SOS button will flash and the message

Connecting call
will appear in the multifunc-
tion display to indicate receipt of the door unlock
command.
Once the vehicle is unlocked, a Response Center
specialist may attempt to establish voice contact
with the vehicle occupants.
If the tailgate recessed handle was pulled for
more than 20 seconds before door unlock autho-
rization was received by the Response Center,
you must wait 15 minutes before pulling the tail-
gate recessed handle again.
i
When the anti-theft alarm or the tow-away
alarm stays on for more than 30 seconds, a call
is initiated automatically to the Response Cen-
ter. See anti-theft alarm system (
page 99).

264 Controls in detailUseful featuresInterior rear view mirror with integrated re-
mote control1Indicator lamp
2 3 4Signal transmitter button
Needed for programming (not part of vehi-
cle equipment):
5Hand-held remote control of ga-
rage door opener, gate operator
or other device
6Hand-held remote control but-
tonProgramming integrated remote
control
Step 1:

Switch on the ignition (
page 38).
Warning!
G
Before programming the integrated remote
control to a garage door opener or gate
operator, make sure people and objects are
out of the way of the device to prevent po-
tential harm or damage. When programming
a garage door opener, the door moves up or
down. When programming a gate operator,
the gate opens or closes.
Do not use the integrated remote control
with any garage door opener that lacks
safety stop and reverse features as required
by U.S. federal safety standards (this
includes any garage door opener model
manufactured before April 1, 1982).
A garage door that cannot detect an object
– signaling the door to stop and reverse –
does not meet current U.S. federal safety
standards.
When programming a garage door opener,
park the vehicle outside the garage.
Do not run the engine while programming
the integrated remote control. Inhalation of
exhaust gas is hazardous to your health.
All exhaust gas contains carbon
monoxide (CO), and inhaling it can cause
unconsciousness and possible death.

265 Controls in detail
Useful features
Step 2:
If you have previously programmed a
signal transmitter button and wish to
retain its programming, proceed to
step 3.
If you are programming the integrated
remote control for the first time, press
and hold the two outer signal transmit-
ter buttons2 and4 and release
them only when indicator lamp1 be-
gins to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory.
If you later wish to program a second
and/or third hand-held transmitter to
the remaining two signal transmitter
buttons, do not repeat this step and be-
gin directly with step 3.Step 3:

Hold the end of hand-held remote
control5 of the device you wish to
train approximately 2 to 5 in
(5 to12 cm) away from the signal trans-
mitter button (2, 3 or4) to be pro-
grammed, while keeping indicator
lamp1 in view.
Step 4:

Using both hands, simultaneously
press hand-held remote control
button6 and the desired signal trans-
mitter button (2, 3 or4). Do not
release the buttons until step 5 is com-
pleted.
Indicator lamp1 will flash, first slowly
and then rapidly.Step 5:

After indicator lamp1 changes from a
slow to a rapidly flashing light, release
the hand-held remote control button
and the signal transmitter button.
Step 6:

Press and hold the just-trained signal
transmitter button (2, 3 or4) and
observe indicator lamp1.
If indicator lamp1 stays on
constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (2, 3 or4) is pressed and re-
leased.
Step 7:

To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
i
Indicator lamp1 flashes immediately the
first time the signal transmitter button is pro-
grammed. If this button has already been pro-
grammed, the indicator lamp will only start
flashing after 20 seconds.
i
If indicator lamp1 flashes rapidly for about
2 seconds and then turns to a constant light,
continue with programming steps 8 through 12
as your garage door opener may be equipped
with the “rolling code” feature.

266 Controls in detailUseful featuresRolling code programming
To train a garage door opener (or other
rolling code devices) with the rolling code
feature, follow these instructions after
completing the “Programming” portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
Step 8:
Locate “training” button on the garage
door opener motor head unit.
Exact location and color of the button
may vary by garage door opener brand.
Depending on manufacturer, the
“training” button may also be referred
to as “learn”or “smart” button. If there
is difficulty locating the transmitting
button, refer to the garage door opener
operator’s manual.
Step 9:

Press the “training” button on the ga-
rage door opener motor head unit.
The “training light” is activated.You have 30 seconds to initiate the follow-
ing two steps.
Step 10:

Return to the vehicle and firmly press,
hold for 2 seconds and release the pro-
grammed signal transmitter button
(2, 3 or4).
Step 11:

Press, hold for 2 seconds and release
same signal transmitter button a sec-
ond time to complete the training pro-
cess.
Step 12:

Confirm the garage door operation by
pressing the programmed signal trans-
mitter button (2, 3 or4).Step 13:

To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
i
Some garage door openers (or other rolling
code equipped devices) may require you to
press, hold for 2 seconds and release the same
signal transmitter button a third time to com-
plete the training process.

268 Controls in detailUseful featuresProgramming tips
If you are having difficulty programming
the integrated remote control, here are
some helpful tips:

Check the frequency of hand-held re-
mote control5 (typically located on
the reverse side of the remote). The in-
tegrated remote control is compatible
with radio-frequency devices operating
between 280-390 MHz.


Put a new battery in hand-held remote
control5. This will increase the likeli-
hood of the hand-held remote control
sending a faster and more accurate sig-
nal to the integrated remote control.


While performing step 3, hold
hand-held remote control5 at differ-
ent lengths and angles from the signal
transmitter button (2, 3 or4) you
are programming. Attempt varying an-
gles at the distance of 2 to 5 in (5 to
12 cm) away or the same angle at vary-
ing distances.


If another hand-held remote control is
available for the same device, try the
programming steps again using that
other hand-held remote control. Make
sure new batteries are in the hand-held
remote control before beginning the
procedure.


Straighten the antenna wire from the
garage door opener assembly. This
may help improve transmitting and/or
receiving signals.
i
Certain types of garage door openers are in-
compatible with the integrated remote control. If
you should experience further difficulties with
programming the integrated remote control,
contact an authorized Mercedes-Benz Center, or
call Mercedes-Benz Customer Assistance Cen-
ter (in the USA only) at 1-800-FOR-MERCedes, or
Customer Service (in Canada) at
1-800-387-0100.
i
USA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interfer-
ence, and
(2) this device must accept any interference re-
ceived, including interference that may
cause undesired operation.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.
i
Canada only:
This device complies with RSS-210 of Industry
Canada. Operation is subject to the following
two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference re-
ceived, including interference that may
cause undesired operation of the device.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.

463 Index
Flexible Service System see FSS PLUS
Floormats 253
Fluids
Automatic transmission fluid 449
Brake fluid 450
Capacities 449
Engine coolant 450
Engine oil 449
Power steering fluid 450
Windshield washer and headlamp
cleaning system 450
Fog lamp, rear 131
Fog lamps 131
Messages in display 380, 381, 382,
383, 384
Fog lamps, front
Corner-illuminating* 132
Switching on 131
Front air bags 69
Front lamps see Headlamps
Front passenger front air bag
Messages in display 353
Front passenger front air bag off indicator
lamp 70, 75Front seat head restraints see Head re-
straints
FSS PLUS (Canada vehicles) 330
Fuel
Additives 453
Capacities, Fuel tank 450
Filler flap and cap 283
Filling the tank 283
Fuel reserve warning lamp 348
Premium unleaded gasoline 284
Requirements
Gasoline additives 453
Premium unleaded gasoline 452
Fuel consumption statistics
Since last reset 167
Since start 167
Fuel filler flap 283
Locking/unlocking 283
Opening 283
Fuel tank
Capacity 283
Filler flap 283
Fuels, coolants, lubricants etc. 449
Fuse box in trunk 429Fuses 428
Aids for replacing fuses 428
Fuse box (main) in passenger
compartment 429
Fuse box in trunk 429
Fuse chart 428
Fuse extractor 428
Replacing 428
Spare fuses 428
G
Garage door opener 263
Gasoline see Fuel
GAWR 323
Gear range
Automatic transmission 176
Limiting 176
Shifting into optimal 179, 181
Gear selector lever 171
Cleaning 339
Gearshift pattern 171
Lock 51
Position 172, 173
Shifting procedure 172
Unlocking in an emergency 398