2007 MERCEDES-BENZ CLK63AMG remote start

water pump drain bolt sat nav wiring air suspension check oil

Page 298 of 505

MERCEDES-BENZ CLK63AMG 2007 A209 Owners Manual 297 Controls in detail
Useful features
Step 4:
Press and hold the signal transmitter
button (2, 3 or4). Do not release
this button until it has been successful-
ly trained.
While still holding dow

297 Controls in detail
Useful features
Step 4:
Press and hold the signal transmitter
button (2, 3 or4). Do not release
this button until it has been successful-
ly trained.
While still holding down the signal
transmitter button (2, 3 or4),
“cycle” your hand-held remote control
button6 as follows: Press and hold
button6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this se-
quence on the hand-held remote con-
trol until the frequency signal has been
learned. Upon successful training, indi-
cator lamp1 will flash slowly and then
rapidly after several seconds.
Proceed with programming step 5 and
step 6 to complete.Reprogramming a single signal trans-
mitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
Switch on the ignition (page 38).
Press and hold the desired signal
transmitter button (2, 3 or4).
Do not release the button.
Indicator lamp1 will begin to flash af-
ter 20 seconds. Without releasing the
signal transmitter button, proceed with
programming starting with step 3.Operation of integrated remote control
Switch on the ignition (page 38).
Select and press the appropriate
integrated signal transmitter button
(2, 3 or4) to activate the remote
controlled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
Switch on the ignition (page 38).
Simultaneously press and hold outer
signal transmitter buttons2 and 4,
for approximately 20 seconds, until
indicator lamp1 flashes rapidly. Do
not hold for longer than 30 seconds.
The codes of all three channels are
erased.
iUpon completion of programming the inte-
grated remote control, make sure you retain the
hand-held remote control that came with the ga-
rage door opener, gate operator or other device.
You may need it for use in other vehicles, for fu-
ture programming of an integrated remote con-
trol, or simply for continued use as a hand-held
remote control to operate the respective device
in other situations.
iIf you sell your vehicle, erase the codes of all
three channels.

Page 490 of 505

MERCEDES-BENZ CLK63AMG 2007 A209 Owners Manual 489 Index
I
Identification labels 462
Identification number,
Vehicle (VIN) 462, 463
Ignition
with KEYLESS-GO* 38
with SmartKey 36
Immobilizer 95
Indicator lamps see
Lamps, indicator and warning
Infa

Page 491 of 505

MERCEDES-BENZ CLK63AMG 2007 A209 Owners Manual 490 Index
KEYLESS-GO* 101
Batteries in SmartKey 107
Battery check lamp, SmartKey 105
Factory setting 104, 106
Ignition 38
Important notes 103
Lock button 62
Locking/unlocking 35, 62, 101
Locking/unloc

Page 495 of 505

MERCEDES-BENZ CLK63AMG 2007 A209 Owners Manual 494 Index
Power windows 249
Cleaning 362
Convenience closing feature 253
Express opening/closing 250, 251
Opening with soft top switch 254
Operating 249
Rear side windows,
Blocking operation 86
Summe

Page: < prev 1-8 9-16

power steering timing belt sunroof brake pads replacement dead battery open trunk drain bolt