424 Practical hints
Battery
Reconnecting the battery
Turn off all electrical consumers.
Remove SmartKey from starter switch.
Vehicles with KEYLESS-GO*:
Open the driver’s door.
Connect the battery positive lead and
fasten its cover3 (
page 422).
Connect the battery negative lead 2
(
page 422).
Reinstall the filter box (page 421).Batteries contain materials that can harm
the environment if disposed of improperly.
Large 12-volt storage batteries contain
lead. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.
!Always connect the battery in the order de-
scribed below. Otherwise the vehicle’s electron-
ics can be damaged.
!Never invert the terminal connections!
iThe following procedures must be carried
out following any interruption of battery power
(e.g. due to reconnecting):
Set the clock (page 156). Vehicles with
COMAND*: see COMAND operator’s manu-
al.
Synchronize the side windows
(
page 247).
Synchronize the tilt/sliding sunroof*
(
page 252).
427 Practical hints
Towing the vehicle
Towing the vehicle
Towing the vehicle
Mercedes-Benz recommends that the vehi-
cle be transported with all wheels off the
ground using flatbed or appropriate wheel
lift/dolly equipment.When circumstances do not permit the
recommended towing methods, the vehi-
cle may be towed with all wheels on the
ground or front wheels raised only so far as
necessary to have the vehicle moved to a
safe location where the recommended
towing methods can be employed.
!Do not tow-start the vehicle.
!Use flatbed or wheel lift/dolly equipment
with SmartKey in starter switch turned to
position0.
Do not tow with sling-type equipment. Towing
with sling-type equipment over bumpy roads will
damage radiator and supports.
To prevent damage during transport, do not tie
down vehicle by its chassis or suspension parts.
Switch off the automatic central locking
(
page 162).
!If the vehicle is towed with the front axle
raised, the gear selector lever must be in posi-
tion N and the engine must be shut off
(SmartKey in starter switch position0 or1). Oth-
erwise, the ESP
® will immediately be engaged
and will apply the rear wheel brakes.
When towing the vehicle with all wheels on the
ground, the gear selector lever must be in
positionN and the SmartKey must be in starter
switch position2.
When towing the vehicle with all wheels on the
ground or the front axle raised, the vehicle may
be towed only for distances up to 30 miles
(50 km) and at a speed not to exceed 30 mph
(50 km/h).
Warning!G
If circumstances require towing the vehicle
with all wheels on the ground, always tow
with a tow bar if:
the engine will not run
there is a malfunction in the power sup-
ply or in the vehicle’s electrical system
as that will be necessary to adequately con-
trol the towed vehicle.
Prior to towing the vehicle with all wheels on
the ground, make certain that the SmartKey
is in starter switch position2.
If the SmartKey is left in starter switch
position 0 for an extended period of time, it
can no longer be turned in the switch. In this
case, the steering is locked. To unlock,
remove SmartKey from starter switch and
reinsert.
428 Practical hints
Towing the vehicle
Warning!G
With the engine not running, there is no
power assistance for the brake and steering
systems. In this case, it is important to keep
in mind that a considerably higher degree of
effort is necessary to brake and steer the ve-
hicle. Adapt your driving accordingly.
iTo signal turns while being towed with the
hazard warning flasher in use, switch on the igni-
tion and activate the combination switch for the
left or right turn signal in the usual manner – only
the selected turn signal will operate.
Upon canceling the turn signal, the hazard warn-
ing flasher will operate again.
!When towing the vehicle with all wheels on
the ground, please note the following:
With the automatic central locking activated and
the SmartKey in starter switch position2, or
KEYLESS-GO* start/stop button in position2,
the vehicle doors lock if the left front wheel as
well as the right rear wheel are turning at vehicle
speeds of approx. 9 mph (15 km / h) or more.
To prevent the vehicle door locks from locking,
deactivate the automatic central locking
(
page 162).
Towing of the vehicle should only be done using
the properly installed towing eye bolt. Never at-
tach tow cable, tow rope or tow rod to the vehi-
cle chassis, frame or suspension parts.
iIf the battery is disconnected or discharged
the SmartKey will not turn in the starter
switch. For more information, see “Battery”
(
page 421) and “Jump starting”
(
page 425).
the gear selector lever will remain locked in
positionP. For information on manually un-
locking the transmission gear selector lever,
see (
page 401).
431 Practical hints
Fuses
Fuses
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and sys-
tems secured by that fuse will stop operat-
ing.If a newly inserted fuse blows again, have
the cause determined and rectified by an
authorized Mercedes-Benz Center.
The following aids are available to help you
replace fuses.
Fuse chart
The fuse chart is located in the main
fuse box in the passenger compart-
ment (
page 432). The fuse chart ex-
plains the fuse allocation and fuse
amperages.
Spare fuses
Spare fuses are located in the vehicle
tool kit in the spare wheel well
(
page 395).
Fuse extractor
The fuse extractor is located in the cov-
er of the auxiliary fuse box in the trunk
(
page 434).The electrical fuses are located in different
fuse boxes:
in the passenger compartment on the
driver’s side (
page 432)
on the driver’s side of the engine com-
partment (
page 433)
in the trunk (page 434)
Before replacing fuses:
Apply the parking brake (page 59).
Make sure the gear selector lever is set
to position P (
page 170).
Turn off all electrical consumers.
Turn off the engine (page 60).
Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Open the driver’s door.
Warning!G
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than ap-
proved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Center
iA blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or the
fuse rating given on the fuse) of the amperage
recommended in the fuse chart.
Any Mercedes-Benz Center will be glad to advise
you on this subject.
446 Technical data
Electrical system
ModelCLK 350CLK 550
Generator (alternator)14 V/150 A14 V/180 A
Starter motor14 V/1.4 KW14 V/1.7 KW
Battery12 V/100 Ah12 V/100 Ah
Spark plugsBosch Platin Y 7 MPP 33
NGK PLKR 6ABosch F8 DPP 332
NGK PFR 5R-11
Electrode gap0.031 in (0.8 mm)0.039 in (1.00 mm)
Tightening torque15 - 22 lb-ft (20 - 30 Nm)18.5 - 22 lb-ft (25 - 30 Nm)
465 Index
I
Identification labels 438
Identification number,
Vehicle (VIN) 438, 439
Ignition
with KEYLESS-GO* 38
with SmartKey 36
Immobilizer 94
Indicator lamps
see Lamps, indicator and warning
Infant and child restraint systems
see Children in the vehicle
Inflation pressure
see Tires,Inflation pressure
Inside door handle 32, 108
Instrument cluster 26, 138
Illumination brightness 138
Lamps in 356–365
Messages in display
see Multifunction display messages
Multifunction display 141
Instrument lighting see Instrument cluster,
Illumination brightness
Instrument panel see Instrument cluster
Instruments and controls see CockpitInterior lighting 136
Delayed shut-off 161
Interior rear view mirror 45, 180
Antiglare position 179
Auto-dimming 180
Interior storage spaces
see Storage compartments
J
Jack 394
Jacking up the vehicle 416
Jump starting 425K
Key, Mechanical 399
Key, SmartKey 98
Batteries 107
Battery check lamp 100, 105
Changing batteries 404
Factory setting 100, 101
Ignition 36
Locking/unlocking 34, 62, 98
Locking/unlocking,
Global setting 100
Locking/unlocking,
Selective setting 100
Loss of 107
Message in display 385
Opening and closing the
power tilt/sliding sunroof* 251
Opening and closing the
power windows 248
Positions in starter switch 36
Remote control 98
SmartKey with KEYLESS-GO* 101
Starting the engine 51
Steering wheel lock 36
Turning off the engine 61
Unlocking/opening trunk lid 101
473 Index
Side marker lamps
Cleaning lenses 350
Messages in display 389
Replacing bulbs 407
Side windows see Power windows
Sidewall 338
Ski sack* (Canada only) 262
Removing 264
Unfolding and loading 262
Unloading and folding 263
SmartKey see Key, SmartKey
SmartKey with KEYLESS-GO*
see KEYLESS-GO*
Snow chains 342
Snow tires 341
Sound system* 211
Spare fuses 394, 431
Spare parts service see Parts service
Spare wheel 397
Bolts 394, 398
Mounting 416
Sizes 445
Speedometer 27, 154
SRS 64, 76
Indicator lamp 27, 65, 365
Message in display 391Standard display, Selecting display 155
Standing lamps 128, 410, 411
Replacing bulbs 407
Standing water, Driving through 300
Starter switch 25, 36
Positions 36
Starting difficulties, Engine 52
Starting, Engine 50
Status line, Selecting display 155
Steering column 43
Steering gear oil
Message in display 392
Steering wheel 43
Buttons 28
Cleaning 353
Lock 52
Steering wheel gearshift control
one-touch gearshifting*
Automatic transmission 177
Stolen Vehicle Recovery services 285
Storage box 268Storage compartments 268
Armrest, Front 270
Armrest, Rear 271
Cup holder 271
Glove box 268
Parcel net 269
Storage bags 269
Storage box 268
Storing
Tires 315
Submenus see Control system submenus
Sun visors 181
Sunroof* see Power tilt/sliding sunroof*
Sunshade* (Canada only) 182
Supplemental Restraint System see SRS
Symbols used
in this operator’s manual 15