2007 MERCEDES-BENZ CLK350 garage door opener

Contents
Power windows .................................. 249
Opening and closing
the windows ................................. 249
Synchronizing power windows ..... 251
Summer opening feature .............. 252
Convenience closing feature ........ 253
Opening and closing
all side windows with
the soft top switch ....................... 254
Soft top .............................................. 255
Opening and closing
the soft top................................... 255
Opening and closing
the soft top with the SmartKey .... 259
Luggage cover .............................. 260
Wind screen ................................. 261
Driving systems ................................. 263
Cruise control............................... 263
Parktronic system
(Parking assist)*,
CLK 63 AMG (USA),
Canada all vehicles....................... 267
Loading .............................................. 271
Ski sack* (Canada only) ............... 271
Loading instructions ..................... 275Useful features .................................. 276
Storage compartments ................ 276
Center armrest ............................. 278
Armrest in the
rear passenger compartment ....... 279
Cup holders.................................. 279
Ashtrays ....................................... 280
Cigarette lighter ........................... 282
Power outlet in the
rear passenger compartment ....... 283
Floormats* ................................... 283
Telephone* .................................. 284
Tele Aid ........................................ 287
Garage door opener* ................... 293
Operation......................................... 299
The first 1 000 miles (1 500 km) ........ 300
Driving instructions ........................... 301
Drive sensibly – save fuel............. 301
Drinking and driving ..................... 301
Pedals .......................................... 301
Power assistance ......................... 302
Brakes.......................................... 302
Driving off .................................... 304
Parking......................................... 304
Tires ............................................. 305
Hydroplaning................................ 306
Tire traction ................................. 306
Tire speed rating .......................... 307
Winter driving instructions ........... 308
Standing water............................. 309
Passenger compartment .............. 309
Driving abroad ............................. 309
Control and operation
of radio transmitters .................... 309
Catalytic converter....................... 310
Emission control .......................... 310
Coolant temperature.................... 311

31 At a glance
Overhead control panel
Overhead control panel
ItemPage
1Tele Aid (emergency call
system) button287
2Right reading lamp on/off135
3Interior lighting control134
4Interior rear view mirror45,
184
5Garage door opener*293
6Hands-free microphone for
Tele Aid (emergency call
system) and telephone*284
7Left reading lamp on/off135

293 Controls in detail
Useful features
Stolen Vehicle Recovery services
In the event your vehicle was stolen:
Report the incident to the police.
The police will issue a numbered
incident report.
Pass this number on to the
Mercedes-Benz Response Center along
with your password issued to you when
you subscribed to the service.
The Response Center will then attempt
to covertly contact the vehicle’s
Tele Aid system. Once the vehicle is
located, the Response Center will
contact the local law enforcement and
you. The vehicle’s location will only be
provided to law enforcement.
Garage door opener*
The integrated remote control is capable of
operating up to three separately controlled
devices. It provides a convenient way to re-
place up to three hand-held remote con-
trols used to operate devices such as
garage door openers, gate openers, or oth-
er devices compatible with HomeLink
® or
some other systems.
Before the integrated remote control can
be used, it must be programmed to the ga-
rage door opener, gate operator or other
device you wish to operate. See the follow-
ing instructions for programming informa-
tion.
iThe remote door unlock feature is available
if the relevant cellular phone network is avail-
able.
The SOS button will flash and the message
Con-
necting call
will appear in the multifunction
display to indicate receipt of the door unlock
command.
Once the vehicle is unlocked, a Response Center
specialist will attempt to establish voice contact
with the vehicle occupants.
If the trunk recessed handle was pulled for more
than 20 seconds before door unlock authoriza-
tion was received by the Response Center, you
must wait 15 minutes before pulling the trunk
recessed handle again.
iWhen the anti-theft alarm stays on for more
than 30 seconds, a call is initiated automatically
to the Response Center, see “Anti-theft alarm
system” (
page 95).

294 Controls in detail
Useful features
Interior rear view mirror with integrated re-
mote control
1Indicator lamp
2 3 4Signal transmitter button
Needed for programming (not part of vehi-
cle equipment):
5Hand-held remote control of ga-
rage door opener, gate operator
or other device
6Hand-held remote control but-
tonProgramming the integrated remote
control
Step 1:
Switch on the ignition (page 38).
Step 2:
If you have previously programmed a
signal transmitter button and wish to
retain its programming, proceed to
step 3.
If you are programming the integrated
remote control for the first time, press
and hold the two outer signal transmit-
ter buttons2 and4 and release
them only when indicator lamp1 be-
Warning!G
Before programming the integrated remote
control to a garage door opener or gate
operator, make sure people and objects are
out of the way of the device to prevent po-
tential harm or damage. When programming
a garage door opener, the door moves up or
down. When programming a gate operator,
the gate opens or closes.
Do not use the integrated remote control
with any garage door opener that lacks
safety stop and reverse features as required
by U.S. federal safety standards (this
includes any garage door opener model
manufactured before April 1, 1982).
A garage door that cannot detect an object
– signaling the door to stop and reverse –
does not meet current U.S. federal safety
standards.
When programming a garage door opener,
park outside the garage.
Do not run the engine while programming
the integrated remote control. Inhalation of
exhaust gas is hazardous to your health. All
exhaust gas contains carbon monoxide
(CO), and inhaling it can cause unconscious-
ness and possible death.

295 Controls in detail
Useful features
gins to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory.
If you later wish to program a second
and/or third hand-held transmitter to
the remaining two signal transmitter
buttons, do not repeat this step and be-
gin directly with step 3.
Step 3:
Hold the end of hand-held remote
control5 of the device you wish to
train approximately 2 to 5 in
(5 to12 cm) away from the signal trans-
mitter button (2, 3 or4) to be pro-
grammed, while keeping indicator
lamp1 in view.
Step 4:
Using both hands, simultaneously
press hand-held remote control
button6 and the desired signal trans-mitter button (2, 3 or4). Do not
release the buttons until step 5 is com-
pleted.
Indicator lamp1 will flash, first slowly
and then rapidly.
Step 5:
After indicator lamp1 changes from a
slow to a rapidly flashing light, release
the hand-held remote control button
and the signal transmitter button.
Step 6:
Press and hold the just-trained signal
transmitter button (2, 3 or4) and
observe indicator lamp1.If indicator lamp1 stays on
constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (2, 3 or4) is pressed and re-
leased.
Step 7:
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
iIndicator lamp1 flashes immediately the
first time the signal transmitter button is pro-
grammed. If this button has already been pro-
grammed, the indicator lamp will only start
flashing after 20 seconds.iIf indicator lamp1 flashes rapidly for about
2 seconds and then turns to a constant light,
continue with programming steps 8 through 12
as your garage door opener may be equipped
with the “rolling code” feature.

296 Controls in detail
Useful features
Rolling code programming
To train a garage door opener (or other
rolling code devices) with the rolling code
feature, follow these instructions after
completing the “Programming” portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
Step 8:
Locate “training” button on the garage
door opener motor head unit.
Exact location and color of the button
may vary by garage door opener brand.
Depending on manufacturer, the
“training” button may also be referred
to as “learn”or “smart” button. If there
is difficulty locating the transmitting
button, refer to the garage door opener
Operator’s Manual.
Step 9:
Press the “training” button on the ga-
rage door opener motor head unit.
The “training light” is activated.You have 30 seconds to initiate the
following step.
Step 10:
Return to the vehicle and firmly press,
hold for 2 seconds and release the pro-
grammed signal transmitter button
(2, 3 or4).
Step 11:
Press, hold for 2 seconds and release
same signal transmitter button a sec-
ond time to complete the training
process.Step 12:
Confirm the garage door operation by
pressing the programmed signal trans-
mitter button (2, 3 or4).
Step 13:
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
iSome garage door openers (or other rolling
code equipped devices) may require you to
press, hold for 2 seconds and release the same
signal transmitter button a third time to com-
plete the training process.

298 Controls in detail
Useful features
Programming tips
If you are having difficulty programming
the integrated remote control, here are
some helpful tips:

Check the frequency of hand-held re-
mote control5 (typically located on
the reverse side of the remote). The in-
tegrated remote control is compatible
with radio-frequency devices operating
between 280-390 MHz.

Put a new battery in hand-held remote
control5. This will increase the likeli-
hood of the hand-held remote control
sending a faster and more accurate sig-
nal to the integrated remote control.

While performing step 3, hold
hand-held remote control5 at differ-
ent lengths and angles from the signal
transmitter button (2, 3 or4) you
are programming. Attempt varying an-
gles at the distance of 2 to 5 inches
(5 to 12 cm) away or the same angle at
varying distances.

If another hand-held remote control is
available for the same device, try the
programming steps again using that
other hand-held remote control. Make
sure new batteries are in the hand-held
remote control before beginning the
procedure.

Straighten the antenna wire from the
garage door opener assembly. This
may help improve transmitting and/or
receiving signals.
iCertain types of garage door openers are in-
compatible with the integrated remote control. If
you should experience further difficulties with
programming the integrated remote control,
contact an authorized Mercedes-Benz Center, or
call Mercedes-Benz Customer Assistance
Center (in the USA only) at
1-800-FOR-MERCedes, or Customer Service (in
Canada) at 1-800-387-0100.
iUSA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interfer-
ence, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.
iCanada only:
This device complies with RSS-210 of Industry
Canada. Operation is subject to the following
two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.

487 Index
Front lamps see Headlamps
Front passenger front air bag 65, 69
Messages in display 382–385
Front passenger front
air bag off indicator lamp 29, 74, 376
FSS (Canada vehicles) 353
Fuel 313, 472
Additives 476
Automatic transmission fluid 472
Brake fluid 473
Capacities 472
Capacities, Fuel tank 473
Engine coolant 473
Engine oil 472
Filling the tank 312
Fuel display 27
Fuel filler flap and cap 312
Fuel filler flap and cap, Multifunction
display messages 393
Fuel reserve warning lamp 373
Power steering fluid 473
Premium unleaded
gasoline 313, 473, 475
Requirements, Octane rating 476
Technical data 472Fuel cap
Message in display 370
Fuel consumption statistics
From start 165
Resetting 166
Since last reset 166
Fuel filler flap 312
Locking/unlocking 312
Opening 312
Fuel reserve warning lamp 27
Fuel tank
Capacity 473
Filler flap 312
Message in display 395
Fuel, Premium unleaded
gasoline 313, 475, 476
Fuels, coolants, lubricants etc.
Capacities 472
Fuses 456
Fuse box (main)
in passenger compartment 457
Fuse box
in engine compartment 457
Fuse box
in trunk 458
Replacing 456G
Garage door opener 31, 293
Gasoline see Fuel
GAWR 347
Gear range
Automatic transmission 175
Limiting 175
Shifting into optimal 178, 180
Gear selector lever 30, 50, 170
Cleaning 363
Gearshift pattern 170
Lock 51
Message in display 386
Position 171, 172
Position indicator 27, 139
Shifting procedure 171
Unlocking in an emergency 412
Gear selector lever one-touch gearshifting
Automatic transmission 177
Global locking/unlocking see
Key, SmartKey or KEYLESS-GO*
Glove box 25, 276
Gloves 404
Good visibility 184
Gross Axle Weight Rating see GAWR
Gross Vehicle Weight Rating see GVWR