2007 MERCEDES-BENZ CLK350 trunk

256 Controls in detail
Soft top
Opening the soft top
1Soft top, opening
Before pulling on the soft top switch, you
must make sure:

the parking brake is engaged
(
page 52)

the luggage cover is latched, see
“Latch luggage cover” (
page 260)

the trunk lid is closed

the ignition is switched on (page 38)
Pull up on the soft top switch as indi-
cated by the arrow1 until the soft top
is completely lowered into its trunk
storage compartment.
During the opening procedure the mul-
tifunction display shows the message
Top in operation.
If you continuously pull on the soft top
switch, the windows will close.However, the windows can also be
closed/opened later on, for more informa-
tion see “Opening and closing all side win-
dows with the soft top switch”
(
page 254), or see “Opening and closing
the windows” (
page 249).
iThe soft top cannot be opened using the soft
top switch when the roll bars have been re-
leased. The roll bars need to be lowered before
the soft top can be operated again using the soft
top switch. If the roll bars have released and the
soft top is closed, contact an authorized
Mercedes-Benz Center to have the roll bars low-
ered. Do not attempt to lower the roll bars man-
ually with the soft top closed. Lowering the roll
bars manually with the soft top closed may im-
pair the function of the roll bars (
page 413).
If the roll bars have released and the soft top is
open, you can lower the roll bars manually
(
page 414) or contact an authorized Mer-
cedes-Benz Center to have the roll bars lowered.
iFor safety reasons, the soft top cannot be
opened while driving.
Make sure the soft top is dry before you open it.
Otherwise water may enter the trunk interior.
!To prevent mildew, the soft top must be dry
before lowering it into the storage compartment.
Do not lower a frozen soft top until thawed and
dry. Lowering a frozen soft top may result in
damage not covered by the Mercedes-Benz Lim-
ited Warranty.
Warning!G
Do not place anything on the soft top com-
partment cover.
The soft top compartment cover must never
be used by any persons as a seat bench.
Raising of the roll bars could result in seri-
ous personal injury.

257 Controls in detail
Soft top
Closing the soft top
1Soft top, closing
Before pressing the soft top switch, you
must make sure:

the parking brake is engaged
(
page 52)

the trunk lid is closed

the ignition is switched on (page 38)
Press the soft top switch as indicated
by the arrow1 until the soft top is
completely closed and locked.
During the closing procedure the multi-
function display shows the message
Top in operation.
If you continuously press on the soft
top switch the windows will close.
However, the windows can also be
closed/opened later on, for more informa-
tion see “Opening and closing all side win-
dows with the soft top switch”
(
page 254) or see “Opening and closing
the windows” (
page 249).
iFor safety reasons, the soft top cannot be
closed while driving.
iThe soft top cannot be closed using the soft
top switch when the roll bars have been re-
leased. The roll bars need to be lowered before
the soft top can be operated again using the soft
top switch. If the roll bars have released and the
soft top is open, you can lower the roll bars man-
ually (
page 414) or contact an authorized
Mercedes-Benz Center to have the roll bars low-
ered.
Warning!G
To prevent possible accidents, drive the ve-
hicle only with the soft top either completely
closed and locked, or fully lowered into its
storage compartment.
If the soft top does not completely open or
close, a warning sounds. In the multifunc-
tion display you will see K, and the mes-
sage
Top being opened appears. After
about 15 seconds the roof hydraulics lose
pressure.
Properly lock the soft top (
page 258) be-
fore continuing to drive.

260 Controls in detail
Soft top
Make sure all side windows and the
soft top are properly closed before leaving
the vehicle.Luggage cover
The luggage cover is located in the trunk.
1Luggage cover
Open the trunk
Latch luggage cover
Pull luggage cover1 out in direction
of arrow until it engages in place.Folding back luggage cover
Press luggage cover1 in direction of
rear seat.
Warning!G
If the soft top does not completely open or
close, a warning sounds and the soft top
switch flashes. In the multifunction display
you will see K, and the message
Top
being opened
appears. After about
15 seconds the roof hydraulics lose pres-
sure.
Properly lock the soft top (
page 258) be-
fore continuing to drive.
!To prevent damage to the soft top or lug-
gage/cargo when lowering the roof:

load trunk only to the height of the luggage
cover

do not permit luggage/cargo to push up the
closed luggage cover

do not place anything on the shelf behind the
roll bars

do not place anything on the soft top com-
partment cover
!Never place anything behind the side nets
when the luggage cover has been folded back.
You could forget about objects placed there,
which could result in damage when operating the
soft top.

261 Controls in detail
Soft top
Wind screen
The wind screen deflects drafts away from
the driver and passenger when the soft top
is lowered. It is stored in a separate stor-
age bag in the trunk.Installing
Remove the wind screen from its stor-
age bag.
1Upper section
2Lower section
Fold sections1 and2 together.3Catch
4Retainer claw
5Snap fastener
Press retainer claw4 on upper sec-
tion into snap fastener5 of lower sec-
tion.
Warning!G
The wind screen can restrict the driver’s vi-
sion to the rear of the vehicle. To prevent a
possible accident when visibility is limited
(e.g. in darkness), the upper part of the wind
screen should be folded back.


271 Controls in detail
Loading
Loading
Ski sack* (Canada only)
Unfolding and loading
Close soft top completely
(
page 257).
Open the trunk.
Fold luggage cover back in direction of
the arrow.1Left hinge
2Right hinge
3Pull strap
Pull ski sack roller blind upward using
pull strap3.
Manually fold left1 and right
hinges2 of ski sack roller blind all the
way up.4Handle
5Cover
6Armrest
Fold armrest6 down (arrow).
Pull handle4 and swing cover5
down.


272 Controls in detail
Loading
7Hook and loop fastener
Unfasten hook and loop fastener7.
Pull ski sack into passenger compart-
ment and unfold.8Flap
9CatchPull down catch9.
Open the flap8 downwards in the di-
rection of the arrow.
From trunk, slide skis into ski sack.
Warning!G
The ski sack is designed for up to two pairs
of skis. Do not load the ski sack with other
objects.
Always fasten the ski sack securely. In an
accident, an unfastened ski sack can cause
injury to vehicle occupants.


273 Controls in detail
Loading
aStrap
Tighten strapa by pulling at the loose
end (arrow) until the skis in the ski sack
are tightly secured.bHook
cEye
Connect hookb to eyec located on
center tunnel in front of rear seat
bench.
Tighten strap by pulling at the loose
end (arrow).Unloading and folding
Loosen both straps.
Disconnect hookb from eyec.
Unload skis.
Close flap8 in trunk.
Fold and flatten ski sack lengthwise.
Place folded ski sack inside recess of
backrest.
Fasten hook and loop fastener.
Close ski sack compartment cover.

274 Controls in detail
Loading
Closing ski sack roller blind
1Left hinge
2Right hinge
3Pull strap
Pull ski sack roller blind downward us-
ing pull strap3.
Manually fold left1 and right
hinges2 of ski sack roller blind all the
way down.
To snap ski sack roller blind into place,
press left and right hinges where the
word PRESS can be seen.
Fold luggage cover back and close it
securely (
page 260).Removing the ski sack
For ski sack removal, we recommend that
you contact an authorized Mercedes-Benz
Center.
Warning!G
Never drive vehicle with trunk open while
the ski sack is removed. Deadly carbon
monoxide (CO) gases may enter vehicle in-
terior, resulting in unconsciousness and
death.
iTo prevent unauthorized persons from ac-
cess to the trunk, always close the flap.