2007 MERCEDES-BENZ CL600 bulb

621 Practical hints
What to do if …?
Display Possible cause/consequencePossible solution
Tail lamp/
brake lamp, LeftThe left tail lamp/brake lamp is malfunc-
tioning.
This message will only appear if all light
emitting diodes have stopped working. A
substitute bulb is being used.Contact an authorized Mercedes-Benz
Center as soon as possible.
Tail lamp/
brake lamp, RightThe right tail lamp/brake lamp is malfunc-
tioning.
This message will only appear if all light
emitting diodes have stopped working. A
substitute bulb is being used.Contact an authorized Mercedes-Benz
Center as soon as possible.

641 Practical hints
Replacing bulbs
Replacing bulbs
Safe vehicle operation depends on proper
exterior lighting and signaling. It is there-
fore essential that all bulbs and lamp as-
semblies are in good working order at all
times.
Correct headlamp adjustment is extremely
important. Have headlamps checked and
readjusted at regular intervals and when a
bulb has been replaced. See an authorized
Mercedes-Benz Center for headlamp ad-
justment.iIf the headlamps or front fog lamps are
fogged up on the inside as a result of high humid-
ity, driving the vehicle a distance with the lights
on should clear up the fogging.iSubstitute bulbs will be brought into use
when the following lamps malfunction:

Brake lamps

Rear fog lamps

Front parking lamps

Tail lamps

Turn signal lamps
Read and observe messages in the multifunction
display (
page 580).

642 Practical hints
Replacing bulbs
Bulbs Front lamps Rear lamps
LampType
1Low and high beam
lamp1
1Bi-Xenon headlamps: Low beam and high beam
use the same D1S-35W lamp. Do not replace the
Bi-Xenon bulbs yourself. Contact an authorized
Mercedes-Benz Center.
D1S-35 W
2Additional turn signal
lampLED
3Parking and standing
lampW5W
4Side marker lampW5W
5High beam flasher lampH7-55 W
IR emitter* (for Night
View Assist*)H11-55 W
6Corner-illuminating
lampH7-55 W
7Fog lampH11-55 W
8Turn signal lampPY 24 W
LampType
9High mounted brake
lampLED
aTurn signal lampHiP 16 W
bBrake lamp/tail lamp
and standing lampLED
cLicense plate lampW5W
dBackup lampHiP 16 W
eSide marker lampLED
fRear fog lamp (driver’s
side only)HiP 19 W

643 Practical hints
Replacing bulbs
Notes on bulb replacement
Only use 12-volt-bulbs of the same
type and with the specified watt rating.

Switch lights off before changing a bulb
to prevent short circuits.

Always use a clean lint-free cloth when
handling bulbs.

Your hands should be dry and free of oil
and grease.

If the newly installed bulb does not
come on, contact an authorized
Mercedes-Benz Center.
Have the LEDs and bulbs for the following
lamps replaced by an authorized
Mercedes-Benz Center:

the Bi-Xenon lamps

the front turn signal lamps

the front fog lamps

the additional turn signal lamps in the
exterior rear view mirrors

the parking and standing lamps

the front side marker lamps

the high mounted brake lamps

the brake, tail and rear standing lamps

the rear side marker lamps

the rear fog lamp

the rear turn signal lamps

the rear side marker lamps

the license plate lamps
Warning!G
Bulbs and bulb sockets can be very hot. Al-
low the lamp to cool down before changing
a bulb.
Keep bulbs out of reach of children.
Halogen lamps contain pressurized gas. A
bulb can explode if you:

touch or move it when hot

drop the bulb

scratch the bulb
Wear eye and hand protection.
Because of high voltage in Xenon lamps, it is
dangerous to replace the bulb or repair the
lamp and its components. We recommend
that you have such work done by a qualified
technician.
!Do not replace the LEDs yourself. You could
otherwise damage the LEDs or parts of the vehi-
cle. Only have the LEDs replaced by an autho-
rized Mercedes-Benz Center.
iHave the headlamp adjustment checked
regularly.

644 Practical hints
Replacing bulbs
Replacing bulbs for front lamps
You can only change the halogen bulbs for,
high-beam flasher lamp, corner-illuminat-
ing lamp, and IR emitter* lamp.
Before you start to replace a bulb for a
front lamp, do the following first:
Turn the exterior lamp switch to M
(
page 363).
Open the hood (page 512) (except
for side marker lamps).
Headlamp, left
1Cover
2Tab
Removing cover: Pull cover1 on
tab2 in direction of arrow and re-
move cover1.
Bi-Xenon headlampsHigh beam flasher lamp
Headlamp, left
1Installation device
Pull installation device1 up (left
headlamp) or down (right headlamp)
and remove the bulb together with
installation device1 from the head-
lamp.
Warning!G
Do not remove the cover for the Bi-Xenon
headlamp. Because of high voltage in Xenon
lamps, it is dangerous to replace the bulb or
repair the lamp and its components. We rec-
o mme nd th at y ou ha ve s uc h w o rk do n e b y a
qualified technician.

645 Practical hints
Replacing bulbs
1Installation device
2Bulb
Pull bulb2 out of the socket.
Insert new bulb2 into the socket.
Insert installation device1 into the
headlamp so that the handle of the in-
stallation device points up (left head-
lamp) or down (right headlamp).
Pull installation device1 down (left
headlamp) or up (right headlamp) until
it engages.
Attach cover (page 644) and let it au-
dibly engage to close.
Corner-illuminating lamp
1Bulb holder
2Wire position
Turn bulb holder1 counterclockwise
until it disengages.
Take out bulb holder1.
Take bulb out of holder.
Insert new bulb into holder and press it
all the way down.
Insert bulb holder1 into guide in
headlamp.
The tab of the bulb holder must be po-
sitioned on the upper left-hand side
and wire2 must point downward and
to the left for the left headlamp, up-
ward and to the right for the right head-
lamp.
Turn bulb holder1 clockwise until it
engages.
iMake sure to insert the bulb in the right di-
rection. The bulb must fit plane on the socket.

646 Practical hints
Replacing bulbs
IR emitter*
1Bulb holder
2Wire position
Turn bulb holder1 counterclockwise
until it disengages.
Take out bulb holder1.
Press both catches on left and right
sides of bulb holder1 and take bulb
out of holder.
Insert new bulb into holder until it en-
gages.
Insert bulb holder1 into guide in
headlamp. Wire2 must point down-
ward and to the right.
Turn bulb holder1 clockwise until it
engages and wire2 points downward
and to the left.
Additional turn signal lamp bulbs
The additional turn signal lamps in the ex-
terior rear view mirrors have LEDs.
If a malfunction occurs or LEDs fail to func-
tion, the entire turn signal unit must be re-
placed. Have the turn signal unit replaced
by an authorized Mercedes-Benz Center.
Front side marker lamp bulbs
Since replacing the side marker lamp bulbs
is a technically highly demanding process,
we recommend you have the side marker
lamp bulbs replaced by an authorized
Mercedes-Benz Center.Replacing bulbs for the rear lamps
Tail lamp unit
The tail lamp unit is equipped with HiP
bulbs and LED’s.
Warning!G
The bulbs in the tail lamp unit cannot be re-
placed individually. The tail lamp bulbs are
under pressure and could explode during an
attempt to replace them.
If the tail lamps (HiP bulbs and/or LED’S)
are malfunctioning, have them replaced at
an authorized Mercedes-Benz Center.

695 Index
B
Backup lamps
Replacing bulbs 642
Bar 545
BAS 66
Batteries, SmartKey
Checking battery condition 332
Replacing 639
Batteries, SmartKey with KEYLESS-GO*
Checking battery condition 332
Replacing 639
Batteries, vehicle 655
Charging 658
Discharged, Jump starting 660
Disconnecting 657
For electrical consumers 655
For starter 655
Message in display 608
Reconnecting 659
Removing 658
Bead 545
Beverage holder see Cup holder
Bluetooth
®
Settings (COMAND) 232
Brake assist system (BAS Plus) 67
Brake assist system (BAS) 66Brake fluid 511, 685, 687
Brake lamp bulbs 642
Brake lamp, high mounted 642
Brake pads
Message in display 598
Brake warning lamp 31
Brakes 500
Warning lamp 31, 567
Break-in period 498
Bulbs, replacing 641
Additional turn signals 642
Brake lamps 642
Fog lamps 642
Front lamps 642
High beam 642
High mounted brake lamp 642
License plate lamps 642
Low beam 642
Parking and standing lamps 642
Rear fog lamp 642
Turn signal lamps 642C
California retail buyers and lessees,
important notice for 15
Can holder see Cup holder
Capacities and
recommended fuel/lubricants 684
Carpets, Cleaning and care of 564
Catalytic converter 507
CD
Ejecting (COMAND) 113
Loading (COMAND) 111
Menu overview (COMAND) 114
Playback options (COMAND) 119
Selecting a medium (COMAND) 117
Selecting a track (COMAND) 117
CD (COMAND) 107
Central locking
Automatic 334
Locking/unlocking from inside 335
Central locking/unlocking switches 335
Certification label 674
Change of address or ownership 16