Page 593 of 723

590 Practical hints
What to do if …?
Display Possible cause/consequencePossible solution
Radar sensor
deactivated
See Oper. ManualYou attempt to activate DISTRONIC Plus*,
Park Assist* or PRE-SAFE® Brake* even
though you have switched off the radar sen-
sors* on the vehicle.
Check if the radar sensors* may be switched on (page 272).
Switch on the radar sensors* using the instrument cluster
control system.
Service X
dueYour vehicle is due for maintenance service
(
page 551).
Have the maintenance service carried out by an authorized
Mercedes-Benz Center.
Service X exceeded
by X days
by XXX mls (km)Service X must be carried within the next ...
or before you have driven ... miles (kilome-
ters) .Have the maintenance service carried out by an authorized
Mercedes-Benz Center as soon as possible.
!Failure to have the vehicle maintained in ac-
cordance with the Maintenance Booklet and
maintenance service indicator at the designated
times/mileage will result in vehicle damage not
covered by the Mercedes-Benz Limited
Warranty. For more information, see “Mainte-
nance” (
page 551).
Page 608 of 723
605 Practical hints
What to do if …?
Display Possible cause/consequencePossible solution
Turn on the ignition
to release the
parking brakeThe yellow indicator lamp for the electronic
parking brake comes on.
You have tried to release the electronic
parking brake, but the ignition was not
switched on.Switch on the ignition (page 336).
(USA only)
(Canada only)
Inoperative
See Oper. ManualESP® as well as PRE-SAFE® are switched off
due to a malfunction. In addition, the v
warning lamp in the instrument cluster
comes on.
The ABS may not be operational.Continue driving with added caution.
Have the system checked at an authorized
Mercedes-Benz Center as soon as possible.
Failure to follow these instructions increases the
risk of an accident.
Page 609 of 723
606 Practical hints
What to do if …?
Display Possible cause/consequencePossible solution
Inoperative
See Oper. ManualCL 600 only:
ESP
® a s w e l l a s P R E - S A F E® are switched off
due to a malfunction. In addition, the v
and ; (USA only) or 3(Canada only)
warning lamps come on in the instrument
cluster.
Brake force assistance is impaired and is
sustained through an electric substitute
function as long as the engine is running.
The brake system continues to function
normally. You will feel a pulsating effect at
the brake pedal while braking.
BAS Plus* and PRE-SAFE
® Brake* are also
not available.
Continue driving with added caution.
Have the system checked at an authorized
Mercedes-Benz Center as soon as possible.
Failure to follow these instructions increases the
risk of an accident.
Page 613 of 723

610 Practical hints
What to do if …?
During severe operating conditions,
e.g. stop-and-go traffic, the coolant tem-
perature may rise close to 248°F (120°C).
Display Possible cause/consequencePossible solution
Coolant level
Stop vehicle!
Switch engine offThe coolant is too hot. Stop the vehicle in a safe location or as soon
as it is safe to do so and immediately turn off
the engine.
Only start the engine again after the message
disappears. You could otherwise damage the
engine.
Observe the coolant temperature gauge in
the instrument cluster (
page 30).
Warning!G
Driving when your engine is overheated
can cause some fluids which may have
leaked into the engine compartment to
catch fire. You could be seriously
burned.
Steam from an overheated engine can
cause serious burns which can occur
just by opening the engine hood. Stay
away from the engine if you see or hear
steam coming from it.
Stop the vehicle in a safe location away from
other traffic. Turn off the engine, get out of
the vehicle and do not stand near the vehicle
until the engine has cooled down.!The engine should not be operated with the
coolant temperature above 248°F (120°C). Do-
ing so may cause serious engine damage which
is not covered by the Mercedes-Benz Limited
Warranty.
Page 614 of 723
611 Practical hints
What to do if …?
Display Possible cause/consequencePossible solution
Coolant level
Stop vehicle!
Switch engine offThe poly-V-belt could be broken.Stop the vehicle in a safe location or as soon
as it is safe to do so and immediately turn off
the engine.
Check the poly-V-belt.
If it is broken:
Do not continue to drive. Otherwise the en-
gine will overheat due to an inoperative water
pump which may result in damage to the en-
gine.
Notify an authorized Mercedes-Benz Center.
If it is intact:
Do not continue to drive the vehicle with this
message displayed. Doing so could result in
serious engine damage that is not covered by
the Mercedes-Benz Limited Warranty.
Observe the coolant temperature gauge in
the instrument cluster (
page 30).
(Continued on next page)
Page 615 of 723
612 Practical hints
What to do if …?
Display Possible cause/consequencePossible solution
Coolant level
Stop vehicle!
Switch engine offRestart the engine.
If this message disappears from the multi-
function display:
Drive immediately to the nearest autho-
rized Mercedes-Benz Center.
If this message does not disappear from the
multifunction display:
Call Roadside Assistance.
The cooling fan for the coolant is malfunc-
tioning.Observe the coolant temperature gauge in
the instrument cluster (
page 30).
Have the fan replaced as soon as possible.
You are driving with one or both doors
open.
The display symbol shows you which doors
are open.Close the doors.
Page 620 of 723

617 Practical hints
What to do if …?
Display Possible cause/consequencePossible solution
Third brake lampThe high mounted brake lamp is malfunc-
tioning. This message will only appear if all
light emitting diodes have stopped working.Contact an authorized Mercedes-Benz
Center as soon as possible.
Corner. lamp,
LeftThe left-hand corner-illuminating lamp is
malfunctioning.Replace the bulb as soon as possible
(
page 641).
Corner. lamp,
RightThe right-hand corner-illuminating lamp is
malfunctioning.Replace the bulb as soon as possible
(
page 641).
Low beam,
LeftThe left low beam lamp is malfunctioning.Contact an authorized Mercedes-Benz
Center as soon as possible.
Low beam,
RightThe right low beam lamp is malfunctioning.Contact an authorized Mercedes-Benz
Center as soon as possible.
Active headlamps
inoperativeThe active headlamps are malfunctioning.Contact an authorized Mercedes-Benz
Center as soon as possible.
AUTO lamps
inoperativeThe light sensor is malfunctioning. Daytime
driving lamps are switched on.Contact an authorized Mercedes-Benz
Center as soon as possible.
To switch off the headlamps (U.S. vehicles only):
In the instrument cluster control system, set
lamp operation to manual mode
(
page 271).
Switch off the headlamps using the exterior
lamp switch (
page 363).
Page 697 of 723

694 Index
Audio (COMAND) 107
CD mode 115
DVD mode 115
MP3 mode 115
Audio (Control system
instrument cluster) 263
CD changer 264
DVD changer 264
Audio DVD
Fast forward/rewind (COMAND) 117
Menu overview (COMAND) 114
Pause function (COMAND) 116
Stop function (COMAND) 116
Auto-dimming, Rear view mirrors 355Automatic climate control 453
Adjusting air distribution
(COMAND) 246
Adjusting air flow from air vents
(COMAND) 249
Adjusting air volume
(COMAND) 246
Adjusting the footwell temperature
(COMAND) 249
Air recirculation mode 458
Central climate control menu
(COMAND) 247
Defrosting 456
Operating via COMAND 244
Rear window defroster 457
Selecting Mono mode
(COMAND) 248
Setting temperature
(COMAND) 245
Setting the temperature 456
Switching cooling on or off
(COMAND) 247Automatic headlamp mode 271, 364
Automatic lighting control,
Interior lighting 370
Automatic locking when driving 334
Automatic shift program 399
Automatic transmission
Accelerator position 396
Automatic shift program 399
Emergency operation
(limp-home mode) 401
Fluid 684
Fluid level 517
Gear ranges 398
Gear selector lever 389
Gear shifting malfunctions 401
Hill start assist system 397
Kickdown 396
Program mode selector switch 399
Shifting procedure 392
Starting the engine 378
Steering wheel gearshift control 400
Transmission fluid 517
Transmission positions 393