Page 329 of 441

328 Practical hints
What to do if …
ProblemPossible cause/consequenceSuggested solution
The yellow fuel tank reserve
warning lamp in the fuel gauge
(
page 24) comes on while
driving.
The fuel level has gone below the reserve
mark.Refuel at the next gas station
(
page 271).
on for a maximum of 6 seconds
after starting the engine.The seat belt telltale reminds you and your
passengers to fasten your seat belts before
driving off.Fasten your seat belts.
Regardless of whether the seat belts
are fastened or not, the seat belt tell-
tale always comes on and remains lit
for 6 seconds after starting the
engine.
maximum of 6 seconds after
starting the engine.You have forgotten to fasten your seat belt.Fasten your seat belt.
The warning chime stops sounding.
on while the vehicle is standing
still and the engine is running or
during driving.You and/or your front passenger have for-
gotten to fasten your seat belts.Fasten your seat belts.
The seat belt telltale goes out.
There are items placed on the front passen-
ger seat and therefore the system senses the
front passenger seat as being occupied.Remove the items from the front pas-
senger seat and put them in a safe
place.
The seat belt telltale goes out.
Page 330 of 441

329 Practical hints
What to do if …
ProblemPossible cause/consequenceSuggested solution
telltale flashes and you addition-
ally hear an intermittent warning
chime with increasing intensity.The vehicle’s speed once exceeded 15 mph
(25 km/h) and you and/or your front pas-
senger have forgotten to fasten your seat
belts.Fasten your seat belts.
The seat belt telltale goes out and the
warning chime stops sounding.
There are items placed on the front passen-
ger seat and therefore the system senses the
front passenger seat as being occupied.Remove the items from the front pas-
senger seat and put them in a safe
place.
The seat belt telltale goes out and the
warning chime stops sounding.
iAfter 60 seconds with an unfastened seat
belt the warning chime stops sounding and the
seat belt telltale illuminates continuously. The
seat belt telltale will only go out if both, the driv-
er’s and the front passenger’s seat belt are fas-
tened, or the vehicle is standing still and a front
door is opened.
Page 344 of 441
343 Practical hints
What to do if …
Symbol messages
Display symbolDisplay messagePossible cause/consequencePossible solution
#The battery is no longer charging.
Possible causes:
broken poly-V-belt
alternator malfunctioning
Stop immediately and check the
poly-V-belt in a safe location or as
soon as it is safe to do so.
If it is broken:
Do not continue to drive. Otherwise
the engine will overheat due to an
inoperative water pump which may
result in damage to the engine. Notify
an authorized Mercedes-Benz Center.
If it is intact:
Drive immediately to the nearest
authorized Mercedes-Benz Center.
Low voltage
Charge batteryThe battery has insufficient voltage.Start the engine (page 46).
Low voltage
Switch off ConsumersThe battery has insufficient voltage.Turn off unnecessary electrical
consumers.
Page 347 of 441
346 Practical hints
What to do if …
Display symbolDisplay messagePossible cause/consequencePossible solution
•Coolant
Stop, turn
engine offThe coolant is too hot.
Among other possible causes, the
poly-V-belt could be broken.Stop the vehicle in a safe location or
as soon as it is safe to do so.
Apply the parking brake (page 54).
Turn off the engine.
Check the poly-V-belt.
If it is broken:
Do not continue to drive. Otherwise
the engine will overheat due to an in-
operative water pump which may re-
sult in damage to the engine. Contact
an authorized Mercedes-Benz Center.
If it is intact:
Wait for the message to disappear be-
fore restarting the engine.
Doing otherwise could result in seri-
ous engine damage that is not covered
by the Mercedes-Benz Limited War-
ranty.
(Continued on next page)
Page 396 of 441
395 Technical data
Parts service
Warranty coverage
Identification labels
Layout of poly-V-belt drive
Engine
Rims and Tires
Electrical system
Main dimensions and weights
Weights
Fuels, coolants, lubricants, etc.
Page 401 of 441
400 Technical data
Layout of poly-V-belt drive
All models
1Idler pulley
2Idler pulley
3Automatic belt tensioner
4Power steering pump
5Air conditioning compressor
6Crankshaft
7Coolant pump
8Generator (alternator)
Page 402 of 441

401 Technical data
Engine
Engine
ModelC 230 (203.052)1
C 230 Sport (203.052)1
1The quoted data apply only to the standard vehicle. See an authorized Mercedes-Benz Center for the corresponding data of all special bodies and special equipment.
C 280 (203.054)1
C 280 4MATIC (203.092)1
Engine272272
Mode of operation4-stroke engine, gasoline injection4-stroke engine, gasoline injection
No. of cylinders66
Bore3.46 in (88.00 mm)3.46 in (88.00 mm)
Stroke2.69 in (68.40 mm)3.23 in (82.10 mm)
Total piston displacement152.3 cu in (2 496 cm3)182.8 cu in (2 996 cm3)
Compression ratio11.2:111.3:1
Output acc.
to SAE J 1349201 hp/6 200 rpm2
(150 kW/6 200 rpm)
2Premium fuel required. Performance may vary with fuel octane rating.
228 hp/6 000 rpm2
(170 kW/6 000 rpm)
Maximum torque acc.
to SAE J 1349181 lb-ft/2 700 – 5 500 rpm
(245 Nm/2 700 – 5 500 rpm)221 lb-ft/2 700 – 5 000 rpm
(300 Nm/2 700 – 5 000 rpm)
Maximum engine speed6500 rpm6500 rpm
Firing order1-4-3-6-2-51-4-3-6-2-5
Poly-V-belt2404 mm2404 mm
Page 403 of 441
402 Technical data
Engine
ModelC 350 (203.056)1
C 350 Sport (203.056)1
C 350 4MATIC (203.087)1
Engine272
Mode of operation4-stroke engine, gasoline injection
No. of cylinders6
Bore3.65 in (92.90 mm)
Stroke3.38 in (86.00 mm)
Total piston displacement213.5 cu in (3 498 cm3)
Compression ratio10.7:1
Output acc.
to SAE J 1349268 hp/6 000 rpm2
(200 kW/6 000 rpm)
Maximum torque acc.
to SAE J 1349258 lb-ft/2 400 – 5 000 rpm
(350 Nm/2 400 – 5 000 rpm)
Maximum engine speed6 500 rpm
Firing order1-4-3-6-2-5
Poly-V-belt2 404 mm
1The quoted data apply only to the standard vehicle. See an authorized Mercedes-Benz Center for the
corresponding data of all special bodies and special equipment.
2Premium fuel required. Performance may vary with fuel octane rating.