2007 MERCEDES-BENZ C280 wiper fluid

51 Getting started
Driving
Windshield wipers
The combination switch is located on the
left of the steering column.
Combination switch
1Single wipe
Wiping with windshield washer fluid
2Switching on windshield wipers
Switch on the ignition (page 32).Switching on windshield wipers
Turn the combination switch to the
desired position depending on the
intensity of the rain.
0Windshield wipers off
IIntermittent wiping
IINormal wiper speed
IIIFast wiper speedIntermittent wiping
Vehicles with rain sensor*:
Intermittent wiping interval is dependent
on wetness of windshield.
Turn the combination switch to
positionI.
Vehicles with rain sensor*:
After the initial wipe, pauses between
wipes are automatically controlled by
the rain sensor.
iIf the combination switch is pressed to the
point of resistance and released, the
corresponding turn signals will flash three times.!Do not operate the windshield wipers when
the windshield is dry. Dust that accumulates on
a windshield might scratch the glass and/or
damage the wiper blades when wiping occurs on
a dry windshield. If it is necessary to operate the
windshield wipers in dry weather conditions, al-
ways operate the windshield wipers with wind-
shield washer fluid (
page 52).
!Vehicles with rain sensor*:
Do not leave windshield wipers in intermittent
setting when the vehicle is taken to an automatic
car wash or during windshield cleaning. Wind-
shield wipers will operate in the presence of wa-
ter sprayed on the windshield, and windshield
wipers may be damaged as a result.
!Vehicles with rain sensor*:
If you have set intermittent wiping, dirt on the
surface of the rain sensor or optical effects may
cause the windshield wipers to wipe in an undes-
ired fashion. This could then damage the wind-
shield wiper blades or scratch the windows. You
should therefore switch off the windshield wip-
ers when weather conditions are dry.

52 Getting started
Driving
Single wipe
Press the combination switch briefly in
direction of arrow1 to the resistance
point.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
Press the combination switch in direc-
tion of arrow1 past the resistance
point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system*”
(
page 280).
iIntermittent wiping is interrupted when the
vehicle is at a standstill and a front door is
opened. This protects persons getting into or out
of the vehicle from being sprayed.
Intermittent wiping will be continued when

all doors are closed
and

the clutch pedal is depressed (vehicles with
manual transmission)
or

the gear selector lever is in positionD or R
(vehicles with automatic transmission*)
or

the wiper setting is changed using the com-
bination switch
iTo prevent smears on the windshield, or
noisy/chattering wiper blades, wipe with wind-
shield washer fluid every now and then even
when it is raining.
!If anything blocks the windshield wipers
(leaves, snow, etc.), switch them off immediate-
ly.

For safety reasons, stop the vehicle in a safe
location and remove SmartKey from starter
switch before attempting to remove any
blockage.

Remove blockage.

Turn the windshield wipers on again.
If the windshield wipers fail to function at all with
combination switch in positionI,

set the combination switch to the next high-
er wiper speed

have the windshield wipers checked at the
nearest authorized Mercedes-Benz Center

160 Controls in detail
Good visibility
For information on the windshield wipers,
see “Windshield wipers” (
page 51).
Headlamp cleaning system*
The button is located on the left side of the
dashboard.
1Headlamp washer button
Switch on the ignition (page 32).
Press button1.
The headlamps are cleaned with a
high-pressure water jet.For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system*”
(
page 280).
Rear view mirrors
For more information on setting the rear
view mirrors, see “Mirrors” (
page 41).
Interior rear view mirror,
antiglare position
1Lever
Tilt the mirror to the antiglare position
by moving lever1 towards the wind-
shield.
The interior rear view mirror is dimmed.
iThe headlamps will automatically be
cleaned when you have

switched on the headlamps
and

operated the windshield wipers with wind-
shield washer fluid fifteen times
When you switch off the ignition, the counter
resets.

436 Index
Individual settings 131, 132
Locking/unlocking 100
Locking/unlocking
in an emergency 361, 362
Lowering 381
Modifications and alterations,
Operating safety 16
Towing 388
Washing 314, 315
Weights 408
With flexible fuel 414
Vehicle jack 357
Vehicle lighting 273
Vehicle loading
Cargo tie-down rings* 236
Instructions 235, 284
Load limit 408
Roof rack* 230
Split rear bench seat* 233
Terminology 304
Vehicle maximum load on the tire 307
Vehicle recovery services,
Stolen (Tele Aid*) 247
Vehicle status message memory 130
Vehicle tool kit 356
VIN 398Voice control system*,
Hands-free microphone 29
W
Warning lamps see
Lamps, indicator and warning
Warning sounds
Driver’s or passenger’s seat belt 71
Parking brake 48
Seat belt telltale 328, 329
Warranty coverage 10, 397
Washer fluid see Windshield washer fluid
Washer reservoir level 273
Washing the vehicle 313
Wear pattern (tires) 307
Weights, Vehicle 408
Wheel
Bolts 360
Change 381
Removing 379
Spare 357, 359, 406
Tightening torque 381
Wheels, Tires 281
Window curtain air bags 64
Windows see Power windowsWindshield
Cleaning 317
Defogging 170, 180
Replacing wiper blades 375
Washer fluid 280, 418
Washer system 418
Windshield washer fluid 418
Message in display 355
Mixing ratio 418
Refilling 280
Wiping with 52
Windshield washer system 418
Windshield wipers 51
Cleaning 317
Replacing wiper blades 375
Winter driving 308
Block heater (Canada only) 309
Snow chains 309
Tires 308
Winter driving instructions 267
Winter tires 308
Wiper blades
Cleaning 317
Replacing 375
Wood trims, Cleaning 320