2007 MERCEDES-BENZ C280 mirror

254 Controls in detail
Useful features
Interior rear view mirror with integrated re-
mote control
1Indicator lamp
2 3 4Signal transmitter button
Needed for programming (not part of vehi-
cle equipment):
5Hand-held remote control of ga-
rage door opener, gate operator
or other device
6Hand-held remote control but-
tonProgramming the integrated remote
control
Step 1:
Switch on the ignition (page 32).
Step 2:
If you have previously programmed a
signal transmitter button and wish to
retain its programming, proceed to
step 3.
If you are programming the integrated
remote control for the first time, press
and hold the two outer signal transmit-
ter buttons2 and4 and release
them only when indicator lamp1 be-
Warning!G
Before programming the integrated remote
control to a garage door opener or gate
operator, make sure people and objects are
out of the way of the device to prevent po-
tential harm or damage. When programming
a garage door opener, the door moves up or
down. When programming a gate operator,
the gate opens or closes.
Do not use the integrated remote control
with any garage door opener that lacks
safety stop and reverse features as required
by U.S. federal safety standards (this
includes any garage door opener model
manufactured before April 1, 1982).
A garage door that cannot detect an object
- signaling the door to stop and reverse -
does not meet current U.S. federal safety
standards.
When programming a garage door opener,
park outside the garage.
Do not run the engine while programming
the integrated remote control. Inhalation of
exhaust gas is hazardous to your health. All
exhaust gas contains carbon monoxide
(CO), and inhaling it can cause unconscious-
ness and possible death.

316 Operation
Vehicle care
Ornamental moldings
For regular cleaning and care of
ornamental moldings, use a damp cloth.Headlamps, tail lamps, side markers,
turn signal lenses
Use a mild car wash detergent, such as
Mercedes-Benz approved Car
Shampoo, with plenty of water.
!Make sure that the windshield wiper switch
is set to0 (
page 51). Otherwise, e.g. the rain
sensor could activate and cause the wipers to
move unintentionally. This may lead to vehicle
damage.
Due to the width of the vehicle, fold in exterior
rear view mirrors prior to running the vehicle
through an automatic car wash to prevent
damage to the mirrors.
iAfter running the vehicle through an
automatic car wash, wipe any wax off of the
windshield (
page 317). This will prevent
smears and reduce wiping noise which can be
caused by residual wax on the windshield.
When leaving the car wash, make sure that the
mirrors are folded out. Otherwise they may
vibrate.
!Do not use chrome cleaner on ornamental
moldings. Although ornamental moldings may
have chrome appearance, they could be made of
anodized aluminum that will be damaged when
cleaned with chrome cleaner. Instead, use a
damp cloth to clean those ornamental moldings.
For very dirty ornamental moldings of which you
are sure are chrome-plated, use a chrome
cleaner. If in doubt whether an ornamental
molding is chrome-plated, contact an authorized
Mercedes-Benz Center.
!Only use window cleaning solutions that are
suitable for plastic lamp lenses. Window
cleaning solutions which are not suitable may
damage the plastic lamp lenses of the
headlamps. Therefore, do not use abrasives,
solvents or cleaners that contain solvents.
Never apply strong force and only use a soft,
non-scratching cloth when cleaning the lenses.
Do not attempt to wipe dirty lenses with a dry
cloth or sponge.
Otherwise you may scratch or damage the lens
surface.

353 Practical hints
What to do if …
Display symbolDisplay messagePossible cause/consequencePossible solution
.Turn signal
front leftThe left front turn signal lamp is
malfunctioning.Replace the bulb as soon as possible
(
page 371).
Turn signal
front rightThe right front turn signal lamp is
malfunctioning.Replace the bulb as soon as possible
(
page 371).
Turn signal
left side
mirrorThe turn signal in the left exterior rear
view mirror is malfunctioning. This mes-
sage will only appear if a critical number
of LEDs have stopped working.Contact an authorized Mercedes-Benz
Center as soon as possible.
Turn signal
right side
mirrorThe turn signal in the right exterior rear
view mirror is malfunctioning. This mes-
sage will only appear if a critical number
of LEDs have stopped working.Contact an authorized Mercedes-Benz
Center as soon as possible.
Turn signal
rear left
Auxiliary bulb
onThe left rear turn signal lamp is malfunc-
tioning. A substitute bulb is being usedReplace the bulb as soon as possible
(
page 373).
Turn signal
rear right
Auxiliary bulb
onThe right rear turn signal lamp is malfunc-
tioning. A substitute bulb is being used.Replace the bulb as soon as possible
(
page 373).

369 Practical hints
Replacing bulbs
Notes on bulb replacement

Only use 12 volt bulbs of the same type
and with the specified watt rating.

Switch lights off before changing a bulb
to prevent short circuits.

Always use a clean lint-free cloth when
handling bulbs.

Your hands should be dry and free of oil
and grease.

If the newly installed bulb does not
come on, visit an authorized
Mercedes-Benz Center.
Have the LEDs and bulbs for the following
lamps replaced by an authorized
Mercedes-Benz Center:

Additional turn signals in the exterior
rear view mirrors

High mounted brake lamp

Xenon* lamps

Front fog lamps

Front side marker lamps
Warning!G
Bulbs and bulb sockets can be very hot.
Allow the lamp to cool down before
changing a bulb.
Keep bulbs out of reach of children.
Halogen lamps contain pressurized gas.
A bulb can explode if you

touch or move it when hot

drop the bulb

scratch the bulb
Wear eye and hand protection.
Because of high voltage in Xenon lamps, it is
dangerous to replace the bulb or repair the
lamp and its components. We recommend
that you have such work done by a qualified
technician.
!Do not replace the LEDs yourself. You could
otherwise damage the LEDs or parts of the
vehicle. Only have the LEDs replaced by an
authorized Mercedes-Benz Center.

373 Practical hints
Replacing bulbs
Front turn signal lamp bulb
Turn bulb socket3 with the bulb
counterclockwise and remove it.
Press gently onto the bulb and turn it
counterclockwise out of bulb
socket3.
Press new bulb gently into bulb
socket3 and turn clockwise until it
engages.
Place bulb socket3 back into the
lamp and turn it clockwise.
Parking and standing lamp bulb
Press the clamp on housing cover2
and remove it.
Pull out bulb socket5 with the bulb.
Pull the bulb out of bulb socket5.
Press the new bulb into bulb socket5.
Press bulb socket5 back into the
lamp.
Align housing cover2 and press until
it engages.Additional turn signal lamp bulbs
The additional turn signal lamps in the
exterior rear view mirrors have LEDs.
If a malfunction occurs or LEDs fail to
function, the entire turn signal unit must be
replaced. Have the turn signal unit
replaced by an authorized Mercedes-Benz
Center.
Front side marker lamp bulbs
Since replacing the side marker lamp bulbs
is a technically highly demanding process,
we recommend you have the side marker
lamp bulbs replaced by an authorized
Mercedes-Benz Center.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following first:
Turn the exterior lamp switch to
positionM (
page 109).
Open the trunk (page 96).
Tail lamp unit
1Latch


408 Technical data
Main dimensions and weights
Main dimensions
Weights
ModelC 230
C 230 SportC 280
C 350C 280 4MATIC
C 350 4MATICC 350 Sport
Overall vehicle length178.4 in (4 532 mm)178.4 in (4 532 mm)178.4 in (4 532 mm)178.4 in (4 532 mm)
Overall vehicle width (exte-
rior rear view mirrors fold-
ed out)77.8 in (1977 mm)77.8in (1977mm)77.8 in (1977 mm)77.8 in (1977 mm)
Overall vehicle height55.6in (1413mm)56.1 in (1 426 mm)56.3 in (1 429 mm)55.5 in (1 410 mm)
Wheelbase106.9 in (2 715 mm)106.9 in (2 715 mm)106.9 in (2 715 mm)106.9 in (2 715 mm)
Track, front59.3in (1505mm)59.3 in (1 505 mm)59.3 in (1 505 mm)59.3 in (1 505 mm)
Track, rear58.1in (1476mm)58.1 in (1 476 mm)58.1 in (1 476 mm)58.1 in (1 476 mm)
Roof load max.220 lb (100 kg)
Trunk load max.220 lb (100 kg)

419 Index
A
ABS 25, 82
Malfunction indicator lamp 322, 323
Messages in display 335
Accelerator position,
automatic transmission 155
Accessory weight 304
Accident
In case of 53
Active head restraints
see Head restraints
Additional turn signals 368
Air bags 59
Children 75
Front passenger front air bag off
indicator lamp 27, 68, 331
Front, Driver 63
Front, Passenger 63
Passenger 63
Safety guidelines 62
Side impact (front and rear*) 64
Window curtain 64Air conditioning refrigerant 412
Air conditioning system
Automatic climate control* 174
Climate control 164
Air conditioning, Cooling
Automatic climate control* 184
Climate control 172
Air distribution
Automatic climate control* 178
Climate control 168
Air pressure see Tire inflation pressure
Air recirculation mode
Automatic climate control* 181
Climate control 170
Air vents, Front
Automatic climate control* 175
Climate control 165Air vents, Rear
Automatic climate control* 186
Climate control 173
Air volume
Automatic climate control* 179
Climate control 168
Alignment bolt (vehicle tool kit) 379
Anticorrosion/antifreeze 417
Antiglare, Rear view mirror 160
Anti-theft systems 89
Anti-theft alarm system* 89
Immobilizer 89
Aquaplaning see Hydroplaning
Armrest 238
Ashtrays 241
Aspect ratio 304
ATF (Automatic transmission fluid) 277
AUDIO menu
Search function 142
AUDIO menu (Control system) 127

420 Index
Audio system 187
Audio and telephone, operation 187
Button and soft key operation 190
CD changer* with MP3 202
CD operation 201
Operating and display elements 188
Operating audio system 190
Operating safety 187
Radio operation 194
Telephone* operation 208
Auto-dimming mirror* 161
Automatic central locking
Activating/deactivating
(Control system) 143
Automatic climate control* 174
Control panel 175
Defrosting, front 179
Rear window defroster 163
Automatic headlamp mode 110
Automatic locking when driving 99
Automatic shift program 157
Automatic time change (Standard time,
Daylight Saving time) 137Automatic transmission 151
Accelerator position 155
Automatic shift program 157
Emergency operation
(limp-home mode) 159
Gear ranges 156
Gear selector lever 151
Gear selector lever positions 153
Gear shifting malfunctions 159
Kickdown 155
One-touch gearshifting 158
Program mode selector switch 157
Shifting procedure 152
Automatic transmission*
Fluid level (ATF) 277
Starting engine 47B
Backrest
Driver’s multicontour seat*
(Canada only) 105
Rear seat, folding 234
Seat, manual 35
Seat, power* 37
Backup lamps
Messages in display 352
Replacing bulbs 368
Bar 304
BAS 84
Batteries, SmartKey
Changing 366
Checking battery condition 95
Battery, Vehicle 279, 383
Charging 385
Disconnecting and connecting 384
Jump starting 386
Removing and installing 384
Bead 304
Block heater (Canada only) 309
Bolts, Spare wheel 360