2007 MERCEDES-BENZ C230 Transmission fluid change

52 Getting started
Driving
Single wipe
Press the combination switch briefly in
direction of arrow1 to the resistance
point.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
Press the combination switch in direc-
tion of arrow1 past the resistance
point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system*”
(
page 280).
iIntermittent wiping is interrupted when the
vehicle is at a standstill and a front door is
opened. This protects persons getting into or out
of the vehicle from being sprayed.
Intermittent wiping will be continued when

all doors are closed
and

the clutch pedal is depressed (vehicles with
manual transmission)
or

the gear selector lever is in positionD or R
(vehicles with automatic transmission*)
or

the wiper setting is changed using the com-
bination switch
iTo prevent smears on the windshield, or
noisy/chattering wiper blades, wipe with wind-
shield washer fluid every now and then even
when it is raining.
!If anything blocks the windshield wipers
(leaves, snow, etc.), switch them off immediate-
ly.

For safety reasons, stop the vehicle in a safe
location and remove SmartKey from starter
switch before attempting to remove any
blockage.

Remove blockage.

Turn the windshield wipers on again.
If the windshield wipers fail to function at all with
combination switch in positionI,

set the combination switch to the next high-
er wiper speed

have the windshield wipers checked at the
nearest authorized Mercedes-Benz Center

277 Operation
Engine compartment
For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(
page 348).
Adding engine oil
1Filler cap
Unscrew filler cap1 from filler neck.
Add engine oil as required. Be careful
not to overfill with oil.
Be careful not to spill any oil when adding.
Avoid environmental damage caused by oil
entering the ground or water.
Screw filler cap1 back on filler neck.
For more information on engine oil, see the
“Technical data” section (
page 409) and
(
page 412).
Transmission fluid level
The transmission fluid level does not need
to be checked. If you notice transmission
fluid loss or gear shifting malfunctions,
have an authorized Mercedes-Benz Center
check the transmission.
!Only use approved engine oils and oil filters
required for vehicles with Maintenance System
(U.S. vehicles) or FSS (Canada vehicles). For a
listing of approved engine oils and oil filters,
refer to the Factory Approved Service Products
pamphlet in your vehicle literature portfolio, or
contact an authorized Mercedes-Benz Center.
Using engine oils and oil filters of specification
other than those expressly required for the
Maintenance System (U.S. vehicles) or FSS
(Canada vehicles), or changing of oil and oil filter
at change intervals longer than those called for
by the Maintenance System (U.S. vehicles) or
FSS (Canada Vehicles) will result in engine or
emission control system damage not covered by
the Mercedes-Benz Limited Warranty.
!Excess oil must be siphoned or drained off.
It could cause damage to the engine and emis-
sion control system not covered by the
Mercedes-Benz Limited Warranty.

420 Index
Audio system 187
Audio and telephone, operation 187
Button and soft key operation 190
CD changer* with MP3 202
CD operation 201
Operating and display elements 188
Operating audio system 190
Operating safety 187
Radio operation 194
Telephone* operation 208
Auto-dimming mirror* 161
Automatic central locking
Activating/deactivating
(Control system) 143
Automatic climate control* 174
Control panel 175
Defrosting, front 179
Rear window defroster 163
Automatic headlamp mode 110
Automatic locking when driving 99
Automatic shift program 157
Automatic time change (Standard time,
Daylight Saving time) 137Automatic transmission 151
Accelerator position 155
Automatic shift program 157
Emergency operation
(limp-home mode) 159
Gear ranges 156
Gear selector lever 151
Gear selector lever positions 153
Gear shifting malfunctions 159
Kickdown 155
One-touch gearshifting 158
Program mode selector switch 157
Shifting procedure 152
Automatic transmission*
Fluid level (ATF) 277
Starting engine 47B
Backrest
Driver’s multicontour seat*
(Canada only) 105
Rear seat, folding 234
Seat, manual 35
Seat, power* 37
Backup lamps
Messages in display 352
Replacing bulbs 368
Bar 304
BAS 84
Batteries, SmartKey
Changing 366
Checking battery condition 95
Battery, Vehicle 279, 383
Charging 385
Disconnecting and connecting 384
Jump starting 386
Removing and installing 384
Bead 304
Block heater (Canada only) 309
Bolts, Spare wheel 360