2007 MAZDA MODEL B3000 TRUCK key

[x] Cancel search: key

Page 152 of 280

MAZDA MODEL B3000 TRUCK 2007  Owners Manual 1. Turn the key to 4 (ON) withoutturning the key to 5 (START). If
there is difficulty in turning the
key, rotate the steering wheel
until the key turns freely. This
condition may occur when:
• the f

Page 157 of 280

MAZDA MODEL B3000 TRUCK 2007  Owners Manual WARNING: Vehicles with a higher center of gravity such as
utility and four-wheel drive vehicles handle differently than
vehicles with a lower center of gravity. Utility and four-wheel
drive vehicles a

Page 158 of 280

MAZDA MODEL B3000 TRUCK 2007  Owners Manual 3. Start the vehicle.
If it is necessary to use the above procedure to move the gearshift lever,
it is possible that a fuse has blown or the vehicle’s brakelamps are not
operating properly. Refer to

Page 159 of 280

MAZDA MODEL B3000 TRUCK 2007  Owners Manual Driving with a 5–speed automatic transmission (if equipped)
This vehicle is equipped with an adaptive Transmission Shift Strategy.
Adaptive Shift Strategy offers the optimal transmission operation a

Page 160 of 280

MAZDA MODEL B3000 TRUCK 2007  Owners Manual R (Reverse)
With the gearshift lever in R (Reverse), the vehicle will move backward.
Always come to a complete stop before shifting into and out of R
(Reverse).
N (Neutral)
With the gearshift lever in

Page 163 of 280

MAZDA MODEL B3000 TRUCK 2007  Owners Manual Removing the key
Turn the ignition off, push the
release lever (located above the
ignition), then turn the key toward
you and remove the key.
If your vehicle gets stuck in mud or snow
If your vehicle

Page 170 of 280

MAZDA MODEL B3000 TRUCK 2007  Owners Manual HAZARD FLASHER
The hazard flasher is located on the
steering column, just behind the
steering wheel. The hazard flashers
will operate when the ignition is in
any position or if the key is not in
the i

Page 171 of 280

MAZDA MODEL B3000 TRUCK 2007  Owners Manual The fuel pump shut-off switch is
located under the right-hand side of
the glove box, just above the carpet.
To reset the switch:1. Turn the ignition OFF.
2. Check the fuel system for leaks.
3. If no l
Page:   < prev 1-8 9-16 17-24 25-32 next >