2007 MAZDA MODEL B3000 TRUCK fuel cap

government emission standards. The OBD-II system also assists your
authorized dealer in properly servicing your vehicle. When the
indicator illuminates, the OBD-II system has detected a malfunction.
Temporary malfunctions may cause the
indicator to illuminate.
Examples are:
1. The vehicle has run out of fuel—the engine may misfire or run poorly.
2. Poor fuel quality or water in the fuel.
3. The fuel cap may not have been securely tightened. See Fuel filler
cap in this chapter.
These temporary malfunctions can be corrected by filling the fuel tank
with good quality fuel and/or properly tightening the fuel cap. After three
driving cycles without these or any other temporary malfunctions
present, the
indicator should turn off—A driving cycle consists of a
cold engine startup followed by mixed city/highway driving. No additional
vehicle service is required.
If the
indicator remains on, have your vehicle serviced at the first
available opportunity.
Readiness for Inspection/Maintenance (I/M) testing
In some localities, it may be a legal requirement to pass an I/M test of
the on-board diagnostics system. If the
indicator is on, refer to the
description in the Warning lights and chimes section of the
Instrument Cluster chapter. Your vehicle may not pass the I/M test with
the
indicator on.
If the vehicle’s powertrain system or its battery has just been serviced,
the on-board diagnostics system is reset to a “not ready for I/M test”
condition. To ready the on-board diagnostics system for I/M testing, a
minimum of 30 minutes of city and highway driving is necessary as
described below:
• First, at least 10 minutes of driving on an expressway or highway.
• Next, at least 20 minutes driving in stop-and-go, city-type traffic with
at least four idle periods.
Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature. Once started,
do not turn off the engine until the above driving cycle is complete.
2007 B-Series (mbs)
Owners Guide (post-2002-fmt)
USA (fus)
Maintenance and Specifications
252

MAINTENANCE PRODUCT SPECIFICATIONS AND CAPACITIES
ItemApplicationMazda part name or
equivalent Capacity
Brake fluid and clutch fluid (if equipped) AllHigh Performance DOT 3
Motor Vehicle Brake Fluid Fill to line on reservoir
1
Door weather strips
AllSilicone Lubricant —
Hinges, door checks,
latches, striker plates, fuel filler door hinge and seat tracks All
Multi-Purpose Grease —
Transmission
/steering/parking brake linkages and pivots,
brake and clutch pedal shaft, clutch pilot
bearing and input shaft spline (manualtransmission) All
Premium Long-Life
Grease —
2007 B-Series
(mbs)
Owners Guide (post-2002-fmt)
USA (fus)
Maintenance and Specifications
260

ItemApplicationMazda part name or
equivalent Capacity
Fuel tank Regular cab
(Short wheel base) —17 gallons (64.4L)
Cab Plus 4 19.5 gallons (73.8L)
1Brake fluid will drop slowly as the brakes wear and will rise when brake components are replaced.
Fluid levels below the MAX line that do not trigger the brake warning light are within the normal
operating range, there is no need to add fluid. If the levels are outside the normal operating range,
the performance of your brake system could be compromised, seek service from your authorized
dealer immediately.2Add the coolant type originally equipped in your vehicle. Do not mix different colors or types of
coolant. Do not use Mazda Extended Life Engine Coolant (orange in color). Refer to Adding
engine coolant, in this chapter.3Service refill capacity is determined by filling the transmission to the bottom of the filler hole with
the vehicle on a level surface.4Ensure the correct automatic transmission fluid is used. Transmission fluid requirements are
indicated on the dipstick or on the dipstick handle. MERCON
and MERCON
V are not
interchangeable. DO NOT mix MERCON
and MERCON
V. Refer toscheduled maintenance to
determine the correct service interval.5Indicates only approximate dry-fill capacity. Some applications may vary based on cooler size and
if equipped with an in-tank cooler. The amount of transmission fluid and fluid level should be set
by the indication on the dipstick’s normal operating range.6Traction-Lok axles use 4.75–5.0 pints (2.2–2.4L) of rear axle lubricant. Add 4 oz. (118 ml) of
Additive Friction Modifier meeting Mazda specifications for complete refill of Traction-Lok axles.
Service refill capacities are determined by filling the rear axle 1/4 inch to 9/16 inch (6 mm to 14
mm) below the bottom of the filler hole.
If submerged in water, the rear axle lubricant should be changed.
2007 B-Series (mbs)
Owners Guide (post-2002-fmt)
USA (fus)
Maintenance and Specifications
263

Clock adjustAM/FM Stereo ...........................19
AM/FM stereo CD ...............21, 24
Premium AM/FM stereo
CD6/MP3 .............................29, 33
Single CD ..................................21
Clutch fluid ..........................................255
operation while driving ..........161
recommended shift speeds ....162
Console ........................................57
Coolant checking and adding ..............237
refill capacities ........................241
specifications ..........................260
Cruise control
(see Speed control) ....................59
Customer Assistance .......198–199, 202
D
Daytime running lamps
(see Lamps) ................................46
Dipstick engine oil .................................229
Driveline universal joint and
slip yoke ....................................258
Driving under special
conditions ..................163, 166, 168 mud ..........................................167
sand .........................................167
snow and ice ...........................169
through water .................167, 169
E
Emergencies, roadside jump-starting ..........................191
Emergency Flashers .................170 Emission control system ..........250
Engine ........................................264
cleaning ...................................210
coolant .....................................237
idle speed control ...................235
lubrication specifications .......260
service points ..................225–227
starting after a collision .........170
Engine block heater .................152
Engine oil ..................................229 checking and adding ..............229
dipstick ....................................229
filter, specifications ................233
recommendations ...................233
specifications ..........................260
Exhaust fumes ..........................152
F
Foglamps .....................................45
Four-Wheel Drive vehicles .......163 driving off road .......................165
electronic shift ........................164
indicator light .........................163
preparing to drive your
vehicle .....................................156
Fuel ............................................243 calculating fuel economy .......247
cap ...........................................245
choosing the right fuel ...........245
comparisons with EPA fuel
economy estimates .................250
detergent in fuel .....................246
filling your vehicle with
fuel ...........................243, 245, 247
filter, specifications ................242
fuel pump shut-off switch .....170
improving fuel economy ........247
octane rating ...................246, 264
quality ......................................246
2007 B-Series (mbs)
Owners Guide (post-2002-fmt)
USA (fus)
Index
270

running out of fuel .................247
safety information relating to
automotive fuels .....................243
Fuel pump shut-off switch .......170
Fuses ..................................171–172
G
Gas cap (see Fuel cap) ............245
Gas mileage
(see Fuel economy) .................247
Gauges .........................................17
H
Hazard flashers .........................170
Headlamps ...................................45 aiming ........................................47
bulb specifications ....................49
daytime running lights .............46
flash to pass ..............................46
high beam .................................45
replacing bulbs .........................50
turning on and off ....................45
Heating heating and air conditioning
system .................................42–43
Hood ..........................................224
I
Ignition ...............................149, 264
Infant seats
(see Safety seats) .....................103
Inspection/maintenance (I/M)
testing ........................................252
Instrument panel cleaning ...................................213 cluster ........................................12
lighting up panel and
interior .......................................46
location of components ............12
J
Jack ............................................181 positioning ...............................181
storage .....................181, 184–185
Jump-starting your vehicle ......191
K
Keys .......................................65, 70 positions of the ignition .........149
L
Lamps bulb replacement
specifications chart ..................49
daytime running light ...............46
fog lamps ...................................45
headlamps .................................45
headlamps, flash to pass ..........46
instrument panel, dimming .....46
interior lamps .....................49–50
replacing bulbs .........................50
Lane change indicator
(see Turn signal) ........................48
Lights, warning and indicator ....12 anti-lock brakes (ABS) ..........154
Load limits .................................132
Loading instructions .................138
Locks doors ..........................................65
Lubricant specifications ...........260
Lug nuts ....................................190
2007 B-Series (mbs)
Owners Guide (post-2002-fmt)
USA (fus)
Index
271