2007 MAZDA MODEL 3 HATCHBACK warning light

[x] Cancel search: warning light

Page 71 of 402

MAZDA MODEL 3 HATCHBACK 2007  Owners Manual (in English) Black plate (71,1)
lVehicle roll-over may not provide
enough side force to deploy the side
and curtain air bags.
lSide impacts with two-wheeled
vehicles may not provide enough force
to deploy the side

Page 72 of 402

MAZDA MODEL 3 HATCHBACK 2007  Owners Manual (in English) Black plate (72,1)
A system malfunction is indicated if the
warning light constantly illuminates or
does not illuminate at all when the
ignition switch is turned to the ON
position. If either of these

Page 78 of 402

MAZDA MODEL 3 HATCHBACK 2007  Owners Manual (in English) Black plate (78,1)
NOTE
lThe keyless entry system is designed
to operate up to about 2.5 m (8 ft)
from the center of the vehicle, but
this may vary due to local
conditions.
lThe system doesnt operate

Page 79 of 402

MAZDA MODEL 3 HATCHBACK 2007  Owners Manual (in English) Black plate (79,1)
NOTE
l(U.S.A.)
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
this device may not cause harmful
interference, and (2)

Page 80 of 402

MAZDA MODEL 3 HATCHBACK 2007  Owners Manual (in English) Black plate (80,1)
NOTE
(Without theft-deterrent system)
The hazard warning lights will flash
twice to indicate that all doors and the
liftgate are unlocked.
(With theft-deterrent system)
lThe hazard

Page 87 of 402

MAZDA MODEL 3 HATCHBACK 2007  Owners Manual (in English) Black plate (87,1)
NOTE
If the vehicle battery is dead or there is
a malfunction in the electrical system
and the liftgate cannot be unlocked,
perform the following procedure as an
emergency measure t

Page 92 of 402

MAZDA MODEL 3 HATCHBACK 2007  Owners Manual (in English) Black plate (92,1)
WARNING
Close the trunk lid, lock the rear
seatbacks and do not allow children to
play inside the vehicle:
Leaving the trunk lid open or leaving
children in the vehicle with the key

Page 93 of 402

MAZDA MODEL 3 HATCHBACK 2007  Owners Manual (in English) Black plate (93,1)
Power Windowsí
The ignition switch must be in the ON
position for the power windows to
operate.
WARNING
Make sure the opening is clear before
closing a window:
Closing power window
Page:   < prev 1-8 9-16 17-24 25-32 33-40 41-48 49-56 ... 88 next >