2007 LINCOLN MARK LT radio controls

When programming your HomeLinkWireless Control System to
a garage door or gate, be sure that people and objects are out of
the way to prevent potential harm or damage.
Do not use the HomeLinkWireless Control System with any garage
door opener that lacks safety stop and reverse features as required by
U.S. federal safety standards (this includes any garage door opener
model manufactured before April 1, 1982). A garage door which cannot
detect an object, signaling the door to stop and reverse, does not meet
current U.S. federal safety standards. For more information, contact
HomeLinkat:www.homelink.comor1–800–355–3515.
Retain the original transmitter for use in other vehicles as well as for
future programming procedures (i.e. new HomeLinkequipped vehicle
purchase). It is also suggested that upon the sale of the vehicle, the
programmed Homelinkbuttons be erased for security purposes, refer to
Programmingin this section.
Programming
Do not program HomeLinkwith the vehicle parked in the garage.
Note:Your vehicle may require the ignition switch to be turned to the
ACC position for programming and/or operation of the HomeLink.Itis
also recommended that a new battery be placed in the hand-held
transmitter of the device being programmed to HomeLinkfor quicker
training and accurate transmission of the radio-frequency signal.
1. Press and hold the two outside
buttons releasing only when the
indicator light begins to flash after
20 seconds.Do notrepeat Step 1
to program additional hand-held
transmitters to the remaining two
HomeLinkbuttons. This will erase
previously programmed hand-held
transmitter signals into HomeLink.
2. Position the end of your
hand-held transmitter 1–3 inches (2–8 cm) away from the HomeLink
button you wish to program (located on your visor) while keeping the
indicator light in view.
2007 Mark LT(mlt)
Owners Guide (post-2002-fmt)
USA(fus)
Driver Controls
93

Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLinkto accept the signal
from the hand-held transmitter.
After completing Steps 1 and 2
outlined in the“Programming”
section, replace Step 3 with the following:
Note:If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
•Continue to press and hold the HomeLinkbutton (note Step 3 in the
“Programming” section) while you press and release —every two
seconds(“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink. The indicator light will
flash slowly and then rapidly after HomeLinkaccepts the radio
frequency signal.
•Proceed with Step 4 in the “Programming” section.
Operating the HomeLinkWireless Control System
To operate, simply press and release
the appropriate HomeLinkbutton.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the event that there are still
programming difficulties, contact HomeLinkatwww.homelink.comor
1–800–355–3515.
2007 Mark LT(mlt)
Owners Guide (post-2002-fmt)
USA(fus)
Driver Controls
95

Power mirrors .............................85
Power point .................................81
Power steering ..........................202
fluid, checking and adding ....284
fluid, refill capacity ................291
fluid, specifications .................291
Power Windows ...........................83
Preparing to drive your
vehicle ........................................203
R
Radio ......................................19, 23
Rear seat entertainment
system ..........................................37
Relays ........................................223
Remote entry system ...............111
illuminated entry ....................116
locking/unlocking
doors ................................111–112
panic alarm .............................113
replacement/additional
transmitters .............................115
replacing the batteries ...........114
Reverse sensing system ...........208
Roadside assistance ..................220
S
Safety Belt Maintenance ..........142
Safety belts (see Safety
restraints) ..........128, 131–134, 136
Safety defects, reporting ..250–251
Safety restraints ........128, 131–136
Belt-Minder...........................137
Belt-Minder,
deactivating/activating ...........140
extension assembly ................141for adults .........................132–134
for children .............................151
Occupant Classification
Sensor ......................................129
safety belt maintenance .........142
warning light and
chime ...............................136–137
Safety seats for children ..........155
Safety Compliance
Certification Label ....................295
Satellite Radio Information ........34
Seat belts
(see Safety restraints) .............128
Seats ..........................................122
child safety seats ....................155
heated ................................63, 126
memory seat ...................113, 125
SecuriLock passive anti-theft
system ................................119–120
Servicing your vehicle ..............259
Setting the clock
AM/FM/In-dash 6 CD ................24
Snowplowing .........................9, 219
Spare tire
(see Changing the Tire) ...........233
Spark plugs,
specifications .....................290, 294
Special notice
ambulance conversions ..............9
utility-type vehicles ....................8
Specification chart,
lubricants ...................................291
Speed control ..............................88
Starting your vehicle ........196–198
jump starting ..........................238
Steering wheel
controls ......................................90
2007 Mark LT(mlt)
Owners Guide (post-2002-fmt)
USA(fus)
Index
303