2007 LEXUS LX470 reset

xv
B
Roll sensing of curtain shield
airbags off switch
P. 65
Power quarter window switches P. 40
Tire pressure warning reset switch
P. 294
Power rear view mirror control
switches
P. 32
Lexus night view system on-off knob
P. 126
: If equipped
*: Refer to “Navigation System Owner's Manual”.

21
1
1-3. Adjustable components
Before driving
Driving position memory system
Your preferred driving position (the position of the driver's seat, steering
wheel and outside rear view mirrors) can be entered into the computer's
memory and recalled with the touch of a button.
Two different driving positions can be entered into memory.
■Entering a position to memory
Check that the shift lever is set in “P”.
Turn the ignition key to the “ON” position.
Adjust the driver’s seat, steeri ng wheel, and outside rear view
mirrors to the desired positions.
While pushing the “SET” button,
push button “1” or “2” until the
signal beeps.
If the selected button has
already been preset, the previ-
ously recorded position will be
overwritten.
■Recalling the memorized position
Check that the shift lever is set in “P”.
Turn the ignition key to the “ON” position. Push button “1” or “2” to recall
the desired position.
STEP1
STEP2
STEP3STEP3
STEP1
STEP2

22
1-3. Adjustable components
■Retained accessory power
Each memorized position (except for the steering wheel position) can be activated
within 30 seconds after the corresponding driver’s door is opened, even if the key is
removed from ignition switch.
■If any position memory button is pushed while the adjustments are being made
The operation will stop. To reactivate the sy stem, push the desired button (“1” or “2”)
again.
■If the battery is disconnected
The memorized positions must be reset be cause the computer's memory is erased
when the battery is disconnected.
CAUTION
■Seat adjustment caution
Take care during seat adjustment that the seat does not strike the rear passenger or
squeeze your body against the steering wheel.
If this happens, you can stop the movement by pressing another seat position mem-
ory button.

105
2-2. Instrument cluster
2
When driving
Instrument panel light controlThe brightness of the instrument panel lights can be adjusted. Darker
Brighter
Odometer
Displays the total distance the vehicle has been driven.
Trip meter
Displays the distance the vehicle has been driven since the meter was last
reset. Trip meters A and B can be used to record and display different dis-
tances independently.
Odometer / trip meter and trip meter reset knob
Switches between odometer and trip meter displays. Pushing and holding
the button will reset the trip meter when the trip meter is being displayed.
Fuel gauge
Displays the quantity of fuel remaining in the tank.

110
2-2. Instrument cluster
Trip information display
Trip information■ Average vehicle speed
■ Driving distance
Displays the average vehicle speed since the engine
was started or the function was reset.
The function can be reset by pushing the “RESET”
switch for longer than on e second when the average
vehicle speed is displayed.
Displays the driving dist ance since engine was
started or the function was reset.
The function can be rest pushing the “RESET” switch for
longer than one second wh en the driving distance is
displayed.
The trip information display presents the driver with a variety of driving-
related data.
Display items can be switched
by pushing the “MODE” switch.

111
2-2. Instrument cluster
2
When driving
■Driving range
■ Average fuel consumption
■ Current fuel consumption
Displays the estimated maximum distance that can
be driven with the quantity of fuel remaining.
This distance is computed based on your average fuel
consumption. As a result, the actual distance that can be
driven may differ from that displayed.
Displays the average fuel consumption since the
vehicle was last refueled.
Displays the current rate of fuel consumption.
■Changing the unit shown on the display
Push and hold the “MODE” sw itch until the unit flashes.
Push the “MODE” switch.
STEP1
Push the “RESET” switch to change the unit. The unit on the outside temperature display
is also changed.STEP2
STEP3

121
2-4. Using other driving systems
2
When driving
■Cruise control can be set when
●The shift lever is in the “D” or “4”.
●Vehicle speed is between approximately 25 mph (40 km/h) and 125 mph
(200 km/h).
■Accelerating
The vehicle can be accelerated normally. After acceleration, the set speed
resumes.
■Automatic cruise control cancelation
The set speed is automatically canceled in any of the following situations.
●Actual vehicle speed falls more than 10 mph (16 km/h) below the preset vehicle
speed
●Actual vehicle speed is below 25 mph (40 km/h)
●VSC is activated
■If the cruise control indicator light flashes
Turn the “ON-OFF” button off once, and then reactivate the system.
If the cruise control speed cannot be set or if the cruise control cancels immediately
after being activated, there may be a malfun ction in the cruise control system. Have
the vehicle inspected by your Lexus dealer.
■ Canceling and resuming regular acceleration
Cancel
Push the lever towards you to
cancel cruise control.
The setting is also canceled
when the brake pedal is
depressed.
Resume
To resume cruise control and
return to the set speed, push the
lever up.

186
3-2. Using the audio system
Setting station presets (excluding XM® satellite radio)
Search for desired stations by turning or pressing  or 
on .
Press and hold one of the preset st ations (1 - 6) until you hear a
beep.
Scanning radio stations (excluding XM® satellite radio)
■ Scanning the preset radio stations
Press and hold until you hear a beep.
Preset stations will be played for a few seconds each.
When the desired station is reached, press once again.
■ Scanning all radio stations within range
Press .
“SCAN” appears on the display an d all stations with reception
will be played for a few seconds each.
When the desired station is reached, press once again.
RDS (Radio Data System)
This feature allows your radio to receive station identification information
and program information (classical, ja zz, etc.) from radio stations which
broadcast this information.
■ Receiving RDS broadcasts
Press  or  on the during FM reception.
STEP1
STEP2
STEP1
STEP2
STEP1
STEP2
STEP1